Jeep · Model Report
Showing safety data for the 2000 model year only.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.
CERTAIN AFTERMARKET AIRTEX ELECTRIC FUEL PUMPS INSTALLED FOR USE AS REPLACEMENT EQUIPMENT FOR CERTAIN 1997-2004 JEEP WRANGLER; 1997-2001 JEEP CHEROKEE; 1997-2004 JEEP GRAND CHEROKEE; AND 2000-2003 DODGE DAKOTA VEHICLES. THE PLASTIC ELECTRICAL GROMMET CONNECTORS AT THE TOP OF THE FUEL PUMP MODULE ARE NOT COMPATIBLE WITH AUTOMOTIVE FUELS AND MAY DEGRADE CAUSING A POTENTIAL LEAK PATH FOR FUEL.
BESTOP AFTERMARKET REAR SHELL ROOF RACKS,MANUFACTURED BETWEEN APRIL 27 AND MAY 20, 2004, DESIGNED FOR USE WITH THE BESTOP HARDTOP MADE FOR THE 1986-1995 AND 1997-2003 JEEP WRANGLER. THE COCKPIT COVER MAY NOT STAY LATCHED TO THE ROOF RACK BECAUSE THE LATCH BRACKET MISPOSITIONS THE ROTARY LATCH TO THE COCKPIT COVER. AS A RESULT, THE COCKPIT COVER MAY NOT STAY LATCHED TO THE ROOF RACK AND COULD SEPARATE FROM THE ROOF RACK. THIS RECALL ONLY PERTAINS TO AFTERMARKET REAR SHELL ROOF RACKS AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON JEEP WRANGLER VEHICLES BY DAIMLERCHRYSLER.
ON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH A 4.0L ENGINE ONLY, THE DESIGN OF THE INTAKE AND EXHAUST MANIFOLDS COULD ALLOW DEBRIS TO ACCUMULATE AT THE #3 CYLINDER LOCATION.
The contact owns a 1994 N/A Jeep Wrangler. The contact stated that the vehicle failed the State Inspection because the VIN was included in NHTSA Campaign Number: 02V041000 (PARKING BRAKE). However, the part to do the recall repair was no longer available. The contact had not experienced a failure. The vehicle was not repaired. The manufacturer was notified of the issue. The mileage at the failure of the State Inspection was 262,384.
No injuries · No fire · No crash
The contact owns a 1993 N/A Jeep Wrangler. The contact stated that there was a strong fuel odor coming from the vehicle after the vehicle was refueled. Additionally, the contact stated that the vehicle was experiencing rough idling and reduced power while driving. The vehicle was taken to the dealer, where the contact was informed that the VIN was included in NHTSA Campaign Number: 94V106000 (Fuel System, Gasoline); however, the dealer later informed the contact that the recall part had been discontinued. The vehicle was not repaired. The manufacturer was contacted and confirmed that the recall part had been discontinued. The contact requested that the manufacturer replace the entire fuel pump assembly. A case was filed. The failure mileage was 172,000.
No injuries · No fire · No crash
WE HAVE FOUND THAT AFTER REMOVING THE BOLTS FROM THE CROSS MEMBER UNDER THE JEEP THAT THE HOLES ARE RUSTED OUT. IN FACT THE FRAME ON BOTH SIDES OF OUR JEEP ARE RUSTED THROUGH FROM NOT HAVING ANY DRAIN HOLES FOR THE WATER TO DRAIN OUT.
No injuries · No fire · No crash
FRAME ROTTED FROM THE INSIDE OUT AROUND THE LOWER CONTROL ARMS. THE CHASSIS IS OTHERWISE RUST FREE, BUT IT SPONTANEOUSLY ROTTED FROM THE INSIDE OUT. THE LOWER CONTROL ARM DISCONNECTED WHILE DRIVING DOWN THE HIGHWAY, LEAVING THE REAR AXLE FREE FLOATING, UNSTABLE, AND VERY LIKELY TO CAUSE A CRASH. THE FRAME HAS HOLES IN IT THAT LET WATER IN. THERE IS NO DRAINAGE HOLE WHERE THE FRAME GOES FROM FLAT ON THE BOTTOM AND CURVES UP AROUND THE WHEEL WELLS. WATER GETS INTO THE FRAME, SITS THERE, AND ROTS IT FROM THE INSIDE OUT. THERE IS NO WAY TO SEE THIS ROT FROM THE OUTSIDE AND THERE IS NO WAY TO FIX IT WITHOUT CUTTING OPEN THE FRAME AND WELDING IN REPAIRS. IF YOU GOOGLE IMAGE SEARCH "JEEP TJ FRAME ROT" YOU CAN SEE OTHER CASES OF THE FRAME FAILING IN THE EXACT SAME LOCATION. HERE'S A BLOG POST WITH SEVERAL INSTANCES OF IT HTTPS://SARAHSTONESADIE.BLOGSPOT.COM/2019/05/JEEP-TJ-FRAME-RECALL.HTML IF YOU GOOGLE "TJ FRAME CAP" YOU'LL SEE THERE'S AN ENTIRE SUB MARKET OF PRODUCTS SPECIFICALLY MADE TO ADDRESS THIS FAILURE. TOYOTA HAD A FRAME RECALL, WHY CAN'T JEEP? IT'S CLEARLY FAILING IN THE EXACT SAME PLACE AND CAN CAUSE SEVERE SAFETY ISSUES. ATTACHED IS A PICTURE "PRE_ROT" THAT SHOWED IT ABOUT 6 MONTHS(?) BEFORE IT COMPLETELY ROTTED THROUGH. THE OTHER PICTURE IS AFTER IT FAILED WHILE DRIVING DOWN THE HIGHWAY. IT WAS A SMALL RUST BUBBLE THAT STARTED FROM THE INSIDE OUT THAT FAIRLY RAPIDLY RESULTED IN COMPLETE STRUCTURAL FAILURE.
No injuries · No fire · No crash
THE FRONT FRAME CAP, OR MOUNTING BRACKET HAS STARTED IS ROTTING AND DETERIORATING. THIS IS A MAJOR CONCERN WHICH HAS COURSES MANY OTHER SEVERE ISSUES. THIS IS A MAJOR SUSPENSION COMPONENT THAT IS ROTTING AWAY.
No injuries · No fire · No crash