Ford · Model Report
Showing safety data for the 1997 model year only.
FORD IS RECALLING CERTAIN 1997 THROUGH 2003 MODEL YEAR FORD F-150, 2004 MODEL YEAR FORD F-150 HERITAGE, 1997 THROUGH 1999 MODEL YEAR F-250 LESS THAN 8,500 LBS. GROSS VEHICLE WEIGHT RATING (GVWR), AND 2002 AND 2003 LINCOLN BLACKWOOD VEHICLES MANUFACTURED FROM JUNE 20, 1995, THROUGH AUGUST 4, 2004, ORIGINALLY SOLD, OR CURRENTLY REGISTERED IN, CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, KENTUCKY, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WEST VIRGINIA, WISCONSIN, AND THE DISTRICT OF COLUMBIA. PROLONGED EXPOSURE TO ROAD DEICING CHEMICALS MAY CAUSE SEVERE CORROSION OF THE FUEL TANK STRAPS WHICH SECURE THE TANK TO THE VEHICLE.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY.
The contact owns a 1997 Ford F-150. The contact stated that while driving at undisclosed speeds, the transmission hesitated while shifting gears. The contact stated that when the gear changed, the vehicle would jerk. The contact replaced the control sensor however, the failure recurred. A dealer was not contacted. The manufacturer was not made aware of the failure. The failure mileage was 245,000.
No injuries · No fire · No crash
on two occasions now while traversing a slight downgrade (approx 8-10mph) applied brake (per pedal) and vehicle failed to stop! (felt as though it was sliding) which it wasn't. continued to roll! after re-gaining composer and control of the vehicle (avoiding any collision) brake system returned to normal !!!!!!!!! different circumstances could have resulted in collision damage,injury perhaps loss of life!! would appreciate any feedback your engineers have to offer in the matter!! i purchased the vehicle in 1998 and currently displays 87!!! k miles.
No injuries · No fire · No crash
The contact owns a 1997 Ford F-150. The contact stated that while attempting to park the vehicle, the vehicle failed to shift into park(P). The contact stated that when he attempted to shift the vehicle into reverse(R), the vehicle shifted instead shifted into drive(D) and vice versa. Additionally, the contact stated that he had to turn the vehicle off and turn the steering wheel towards the direction of the curb in case the vehicle rolled away, increasing the risk of a crash or an injury. No warning light was illuminated. The vehicle was taken to an independent mechanic where it was diagnosed that the shifter cable assembly had detached from the bracket and needed to be replaced. The vehicle was not repaired. The dealer was not notified of the failure. The contact referenced NHTSA Campaign Number: 97V171000 (Power Train). The manufacturer was notified of the failure and the contact was informed that the VIN was not included in the recall and advised the contact to call the NHTSA Hotline. The failure mileage was approximately 40,000.
No injuries · No fire · No crash
1997 Ford F150, had recall 25527072 05S28 performed in March of 2006. The switch installed as part of the recall has failed and brake fluid has leaked from the switched and the harness. It is not apparent that the switch is leaking until the harness connector is removed from the switch. The integrity of the brake system is compromised and the previous recall was for fires because of brake fluid in the wire harness. UPDATE 5/11/23 BRAKE SWITCH HARMESS RECALL 05S28 WAS REPLACED WITH A MITORCRAFT PART SW6350 AND CONSUMER IS REQUESTUING REFUND FOR PARTS FROM FORD.
No injuries · No fire · No crash
I filled the fuel tank and let the vehicle set in my drive over night. In the morning as I was approaching the vehicle in preparation to drive to work, I smelled a strong odor of gasoline. I looked under the vehicle and saw a wet spot about 3 feet in diameter. The wet spot was gasoline. As i was investigating the leak, I noticed the front fuel tank retaining band rusted in two and fuel tank hanging low. Further investigation revealed there was a leak from the fuel pump access seal and hose connecting the filler neck to the tank. I had just driven the vehicle 130 miles the day before filling the fuel tank. If it hadn't been for the leaking fuel, I would have not have discovered that the tank was only secured by one badly rusted retaining band and would have continued to operate the vehicle normally and probably ultimately the second band would have broken allowing the fuel tank to fall from the vehicle. Ford informed there was a recall and the vehicle had been repaired in 2011. I purchased the vehicle in Jan. 30, 2012 and drive it daily.
No injuries · No fire · No crash