BMW Z4 Service Bulletins
513 manufacturer communications on file.
- October 1, 2020•Document ID: 10182618Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT
- Mfr Comm. #:
- B610120
- Date Added:
- November 16, 2020
- Manufacturer:
- BMW
SummaryACCESSORIES DO NOT POWER ON: Customer is unable to power up or charge accessories through a plug adapter inserted in the front 12-volt power socket plug. Alternatively, it will only operate when constant downward hand pressure is maintained. A design change was intended to reduce short circuits and blown fuses. When the plug adapter is inserted, the center contact pin may not make proper contact with the center pin of the power socket plug.
Associated Products (17)Associated Documents - October 1, 2020•Document ID: 10182616Service Bulletin/Repair InstructionsSEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER
- Mfr Comm. #:
- B520720
- Date Added:
- November 16, 2020
- Manufacturer:
- BMW
SummarySEAT HEATING NOT ACTIVATED WHEN ENGINE IS STARTED USING REMOTE STARTING SYSTEM: When preheating/precooling the vehicle via the remote starting system (Remote Engine Start), the seat heating on the driver's side is not activated.
Associated Products (28)Associated Documents - October 1, 2020•Document ID: 10182607Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; SUSPENSION
- Mfr Comm. #:
- B310120
- Date Added:
- November 16, 2020
- Manufacturer:
- BMW
SummarySERVICE ACTION - REPLACE THE WISHBONE OR TENSION STRUT: An incorrectly pressed-in rubber mount in the wishbone, or hydraulic mount in the tension strut can lead to acoustic abnormalities in the front axle. A process fault at the supplier resulted in the mounts of the affected wishbone or tension strut to be incorrectly pressed in.
Associated Products (9)Associated Documents - October 1, 2020•Document ID: 10182606Service Bulletin/Repair InstructionsEQUIPMENT; FUEL SYSTEM, GASOLINE
- Mfr Comm. #:
- B160320
- Date Added:
- November 16, 2020
- Manufacturer:
- BMW
SummaryDELIVERY STOP - REPLACE FUEL TANK: Over time, a fuel tank weld seam may start to separate at locations in which welding may have beeninsufficient.
Associated Products (3)Associated Documents - September 1, 2020•Document ID: 10181214Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B110208
- Date Added:
- October 19, 2020
- Manufacturer:
- BMW
SummaryPower Reduction, FC2A82 Intake VANOS and/or FC2A87 Exhaust VANOS Camshaft Fault: The ?Service Engine Soon? (MIL) lamp is illuminated and engine power reduction is perceived. This situation can occur after driving for some time with the engine at full operating temperature. If theignition is cycled, the engine then usually performs normally.
Associated Products (70)Associated Documents - September 1, 2020•Document ID: 10181225Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- B511219
- Date Added:
- October 19, 2020
- Manufacturer:
- BMW
SummaryKIDNEY GRILL ACTIVE AIR FLAP FAULTS: A check control message or MIL (Malfunction Indicator Lamp) may be illuminated.
Associated Products (24)Associated Documents - September 1, 2020•Document ID: 10181218Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- B310120
- Date Added:
- October 19, 2020
- Manufacturer:
- BMW
SummarySERVICE ACTION - REPLACE THE WISHBONE OR TENSION STRUT: An incorrectly pressed-in rubber mount in the wishbone, or hydraulic mount in the tension strut can lead to acoustic abnormalities in the front axle. A process fault at the supplier resulted in the mounts of the affected wishbone or tension strut to be incorrectly pressed in.
Associated Products (9)Associated Documents - August 1, 2020•Document ID: 10179825Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B662419
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryREMOTE CONTROL IS NOT DETECTED: Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column. Note: Opening, closing and starting via the BMW Digital Key or the Digital Key Card are not affected. Software error in the BDC (Body Domain Controller) module.
Associated Products (63)Associated Documents - August 1, 2020•Document ID: 10179824Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B661919
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryCOMFORT ACCESS AND COMFORT GO NOT POSSIBLE: Vehicle cannot be unlocked/locked or started via Comfort Access. Remote control functionality is restored by pressing any of the key buttons or by removing and reinstalling the remote control key battery.
Associated Products (71)Associated Documents - August 1, 2020•Document ID: 10179823Service Bulletin/Repair InstructionsLANE DEPARTURE
- Mfr Comm. #:
- B661519
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryLANE DEPARTURE WARNING - STEERING INTERVENTION TOO STRONG: The steering intervention for Lane Departure Warning (LDW) is too strong (severe), which can create an uncomfortable feeling for the driver. Background: Steering intervention helps keep the vehicle in the lane if the system detects that a lane marking has been crossed. The steering intervention can be noticed on the steering wheel and can be manually overridden at any time. Software error in the KAFAS (camera-based driver assistance system) control unit.
Associated Products (38)Associated Documents - August 1, 2020•Document ID: 10179821Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B651520
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryHEAD UNIT RESETS WHEN NAVIGATION IS USED IN CERTAIN LOCATIONS: The head unit resets sporadically causing the CID to turn black and then starts up again after a short time with the message "Start navigation system". This only occurs during navigation guidance when the "3D building" function is used Software in the Head Unit High (HU-H3).
Associated Products (71)Associated Documents - August 1, 2020•Document ID: 10179818Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B610120
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryACCESSORIES DO NOT POWER ON: Customer is not able to power accessories using the 12 volt power socket. Design change to reduce short circuits and blown fuses.
Associated Products (11)Associated Documents - August 1, 2020•Document ID: 10179815Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B511219
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryKIDNEY GRILL ACTIVE AIR FLAP FAULTS: A check control message or MIL (Malfunction Indicator Lamp) may be illuminated, with one or more of the following faults stored: 138207- Active cooling damper control (AKKS), top: blockage at warm ambient temperature 21B043- Active cooling damper control (AKKS), top: blockage at all ambient temperatures 138222- Active cooling damper control (AKKS), above: positional deviation error detected at warm ambient temperature 138209- Active cooling damper control (AKKS), top: Control deviation at all ambient temperatures 13822B- Active cooling damper control (AKKS), top: Control deviation at all ambient temperatures 21B042- Active cooling damper control (AKKS), below: blockage at all ambient temperatures 138206- Active cooling damper control (AKKS), bottom, blockage at warm ambient temperature 138225-Active air-flap control, bottom: top limit position not detected 138224-Active air-flap control, bottom: bottom limit position not detected Multiple potential issues may be the cause, including: 1. Faulty active air flap(s) (Upper and/or lower) 2. Software error in the DME 3. Debris or blockages from outside influence (non-warranty) 4. Information error memory that does not require a repair 5. For G20 only- Detached lower active air flaps
Associated Products (14)Associated Documents - August 1, 2020•Document ID: 10179809Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B090220
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryREMOTE SOFTWARE UPGRADE: For BMW, Remote Software Upgrade (RSU) is the next consequent step with regard to digitalization and customer satisfaction. With the introduction of RSU, customers now can update the vehicle software by themselves.
Associated Products (38)Associated Documents - August 1, 2020•Document ID: 10179748Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
- Mfr Comm. #:
- B090218
- Date Added:
- September 14, 2020
- Manufacturer:
- BMW
SummaryNEW ECU VALIDATION NEEDED AFTER REPLACING CERTAIN CONTROL MODULES: With introduction of the new Headunit HU-H3 (MGU Media Graphics Unit), there is a new protection mechanism against tampering. If one or more of the following components needs to be replaced, the secure connection between them must be re-established: MGU TCB Telematic Communication Box (ATM-02) RSE Rear Seat Entertainment and/or KOMBISP18 instrument cluster Prior to re-establishing this connection, an electronic certificate must be created in the BMW backend for importing into the Vehicle. After the replacement of one of the mentioned Modules, the Control Module needs a valid certificate for it to communicate with the other Modules.
Associated Products (68)Associated Documents - July 1, 2020•Document ID: 10179010Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B651220
- Date Added:
- August 31, 2020
- Manufacturer:
- BMW
SummaryBMW CONNECTEDDRIVE APPS ARE NO LONGER AVAILABLE AFTER PROGRAMMING: After programming vehicle with "20-03" software, BMW ConnecedDrive apps are no longer available in the head unit. Software in the Head Unit High (HU-H3).
Associated Products (71)Associated Documents - July 1, 2020•Document ID: 10179009Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B650709
- Date Added:
- August 31, 2020
- Manufacturer:
- BMW
SummaryNAVIGATION SYSTEM - REPORTING MISSING OR INCORRECT ROADMAP DATA: Do not replace parts and do not program the vehicle. Roads can change by up to 15% every year. To ensure the best navigation experience, we do everything in our power to create the best maps. Your reports help us to detect changes in your area and keep future versions of our maps as accurate as possible. Therefore, a road map error or missing data must be reported directly to the map supplier.
Associated Products (284)Associated Documents - July 1, 2020•Document ID: 10179007Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- B620119
- Date Added:
- August 31, 2020
- Manufacturer:
- BMW
SummaryINSTRUMENT CLUSTER AND ONBOARD COMPUTER INTERMITTENTLY INOPERATIVE: The audio source, radio station, or music track cannot be changed using the MFL. Normal functionality may possibly return after a sleep cycle or a battery reset. This affects vehicles with: Integration level S18A-18-11-5xx Live Cockpit Professional (option code 6U3) including the instrument cluster High 4.1. While the Kombi is not working properly the rest of the system is working properly. The customer can still use the Central Information Display (CID) for items such as entertainment settings, Driver Experience settings, etc, utilizing the I drive controller. The telephone functions are not affected. Unfavorable software at system start-up.
Associated Products (71)Associated Documents - July 1, 2020•Document ID: 10178996Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC; WHEELS
- Mfr Comm. #:
- B340517
- Date Added:
- August 31, 2020
- Manufacturer:
- BMW
SummaryTICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: Ticking noise coming from front wheel while cornering without brakes applied, noticeable at low speeds. The vehicle must be moving.
Associated Products (218)Associated Documents - June 1, 2020•Document ID: 10177623Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B340320
- Date Added:
- July 27, 2020
- Manufacturer:
- BMW
SummaryPREMATURE WEAR OF THE REAR AXLE BRAKE PADS WITH STANDARD BRAKES: The CBS data and Check Control (CC) message shows the rear axle brake pads are worn, and the vehicle has less than 15,500 miles. Increased residual braking forces in the rear axle brake calipers caused by production-related deviations on the surface of the piston ring seal.
Associated Products (6)Associated Documents