2021-2023 Audi Suspension Control Module Malfunction DTC B200FF0

Audi has released Technical Service Bulletin (TSB) 43 22 63 2051336/6 to address an internal malfunction within the suspension control module, which triggers the diagnostic trouble code (DTC) B200FF0. This issue primarily affects various 2021-2023 Audi models equipped with Electronic Damper Control. The TSB supersedes an earlier bulletin, Group 43 number 21-56, dated September 16, 2021, due to updated information.

Symptoms

Owners of affected vehicles may observe a specific warning indicator in their instrument cluster. The primary symptom associated with this condition is:

• "The warning lamp for the damper control in the instrument cluster is on."

Fault Codes / DTCs

When diagnosing the issue, technicians will find the following diagnostic trouble code (DTC) stored in either the drivetrain control module (J775, address word 0074) or the electronic damping control module (J250, address word 0014):

Code	Description	Module
B200FF0	Internal malfunction	J775 (Drivetrain) or J250 (Electronic Damping)

Diagnosis / Trigger Conditions

The presence of DTC B200FF0 indicates an internal malfunction within the suspension control module system. This code is typically stored when the damper control warning lamp illuminates. The TSB clarifies that this specific DTC B200FF0 does not impact the vehicle's handling characteristics.

Important Warnings

Audi explicitly states a critical warning regarding this issue:

• "Parts replacement does not solve this issue. Claims for replaced parts will be subject to review."

This means that attempting to replace components like the suspension control module will not resolve the DTC B200FF0 and may result in warranty claims being denied.

Repair Procedure Summary

The repair for the Audi A5 DTC B200FF0 is straightforward and does not involve part replacement. The procedure outlined in TSB 43 22 63 2051336/6 involves the following steps:

1. Delete the DTC: The stored DTC B200FF0 should be cleared from the respective control module.
2. Perform Suspension Basic Settings: Technicians must perform the necessary basic settings for the suspension system.
3. Perform GFF: A Guided Fault Finding (GFF) session should be conducted to ensure no other diagnostic trouble codes are present in the control module after the repair.

Warranty Information

This repair is covered under Audi's warranty program, with specific conditions:

• Claim Type: 110 for vehicles up to 48 months or 50,000 miles. G10 for Certified Pre-Owned (CPO) vehicles, requiring owner verification.
• Out of Warranty: If the vehicle is outside of any applicable warranty, this Technical Service Bulletin serves as informational guidance only.
• Service Number: 4316
• Damage Code: 0040
• Diagnostic Time: GFF 0150 0000, with a maximum of 90 Technical Units (TU) for the diagnostic protocol.
• Claim Comment: As per TSB 2051336/6.

All warranty claims must adhere to the Audi Warranty Policies and Procedures Manual and are subject to review or audit by Audi Warranty.

Owner Action

If your 2021-2023 Audi A5, or other affected model, displays a damper control warning lamp or you suspect an Audi A5 DTC B200FF0, it is recommended to schedule an appointment with an authorized Audi service center. Since parts replacement is not the solution, the repair typically involves diagnostic and software-based procedures.

---

Source: NHTSA ID: 10214468