Toyota · Model Report
Showing safety data for the 2025 model year only.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2025-2026 Camry Hybrid vehicles. The instrument cluster display may fail during vehicle startup, deactivating the hazard lights, turn signals, seat belt warning system, and smart key reminder. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 101, "Control and Displays," 108, "Lamps, Reflective Devices and Associated Equipment," 114, "Theft Protection and Rollaway Prevention," and 208, "Occupant Crash Protection."
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2025-2026 Camry Hybrid and 2026 Corolla Cross Hybrid vehicles. A bolt inside the inverter may not have been tightened properly, causing incomplete contact at the inverter terminal.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022-2026 Toyota, Lexus, and Subaru Solterra vehicles equipped with a Panoramic View Monitor (PVM) system. Please see the recall report for a complete list of models. A software error may cause the rearview camera to freeze or display a blank screen when the vehicle is in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2023-2024 Toyota Venza, 2023-2025 RAV4 Prime, RAV4, Highlander, GR Corolla, Crown, 2024-2025 Lexus TX, LS, Toyota Tacoma, Grand Highlander, and 2025 Lexus RX, Toyota Crown Signia, Camry, RAV 4 Plug-in Hybrid (PHEV), and 4 Runner vehicles. Due to an error in the instrument panel software at vehicle startup, the instrument panel may fail to display vehicle speed, brake system, and tire pressure warning lights.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2025 Toyota Camry Hybrid, Lexus NX250, NX350, NX350 Hybrid, 2024-2025 Lexus RX350, RX350 Hybrid, and RX500 Hybrid vehicles. The second-row center seat belt webbing may be damaged. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 209, "Seat Belt Assemblies."
The 2025 Toyota Camry shows a strong reliability outlook with no recalls or owner complaints reported to NHTSA. This profile details manufacturer service bulletins addressing smart key immobilizer resets, protective film removal, and iron particle rust contamination.
This Technical Service Bulletin (T-SB-0013-24 Rev1) from Toyota outlines the procedures for performing a Smart Key Immobilizer Reset, adding new keys, and permanently erasing lost or stolen keys for a wide range of 2023-2025 Toyota models, including the Camry.
Toyota has issued T-SB-0061-23 Rev2 detailing the proper procedure for removing Rapgard™ protective film from new 2023-2025 vehicles. This film protects painted surfaces during transport but must be removed within 90 days to prevent issues. Learn the steps and important warnings.
Toyota has issued Technical Service Bulletin T-SB-0062-23 Rev2 addressing iron particle rust contamination on the paint surfaces of 2023-2025 Toyota vehicles. This bulletin outlines a specific cleaning procedure to remove small, red or brown particles caused by airborne industrial debris.
The contact's son owns a 2025 Toyota Camry Hybrid. The contact and her son discovered razor-thin lines across the dashboard on the front passenger’s side air bag. The contact and her son were concerned that the passenger’s side air bag might not operate as intended due to the cracks on the dashboard. The vehicle was taken to the dealer and repaired under NHTSA Campaign Number: 26V511000 (Exterior Lighting, Seat Belts, Electrical System). The dealer determined that there were cracks in the dashboard and recommended that the dashboard be replaced. The dealer submitted photos to the manufacturer, and the manufacturer responded that the dashboard was not covered under warranty and the cracks were due to other issues. The manufacturer was notified of the failure by phone. The failure mileage was approximately 5,500.
No injuries · No fire · No crash
I had my front bumper cover on my Toyota Camry repaired and it continues to pop out and I am told it's the clips for the bumper.
While driving with cruise control engaged, came up behind a truck going slower than I was so pressed the minus (-) on the steering wheel to lower the speed. Usually what happens is the speed will drop 1 MPH for each press. This time (and this is the first time I've seen this happen) instead of slowing down, the car sped up! And the speed kept climbing from 54 to 80 MPH without pause. My foot was nowhere near the accelerator pedal. It was not related to the minus presses which I did maybe 3 times during that speed up sequence. I am positive that I was pressing the (-). I was far enough behind the truck (on a slight hill) that there was no danger but the car's speed kept climbing so I stepped on the brakes which disengaged the cruise control. When I later tried to reengage it, it gave a dash display warning that it couldn't be engaged. I waited ~5 minutes and it did reengage without cycling power.
No injuries · No fire · No crash
Dash panel goes blank and does not display information while driving. This happens periodically. Dealership will not fix.
No injuries · No fire · No crash
My dash clusters go blank periodically without warning.
No injuries · No fire · No crash