Mazda CX-3 Service Bulletins
807 manufacturer communications on file.
- December 12, 2016•Document ID: 10186252Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 07-006-16
- Date Added:
- February 1, 2021
- Manufacturer:
- MAZDA
SummaryA/C blows warm air. Some customers may complain about warm air from the climate cointrol vents. This may be caused by improper brazing (A) of the evaporator (B) causing a refrigerant leak fr om the joint between the tubes © and the header (D)
Associated Products (2)Associated Documents - December 12, 2016•Document ID: 10186250Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 07-004-16
- Date Added:
- February 1, 2021
- Manufacturer:
- MAZDA
SummaryAuto A/C blows warm air (Canada/Mexico). Some customers may complain that it is difficult to adjuust the cabin temperature using the auto A/C. This may be more noticeable when the outside temperature is approximately 50 degrees Fahrenheit (10 Ceisius)
Associated Products (2)Associated Documents - December 5, 2016•Document ID: 10186257Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; ELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-062-16
- Date Added:
- February 1, 2021
- Manufacturer:
- MAZDA
SummaryActive driving display opens/closes improperly. Some vehicles may exhibit the active driving display opening/closing improperly as described below: * It does not open or close when the ignition is turned ON or OFF . * The display operation does not fully open/close. * It closes and then opens by itself while the vehicle is moving. This concern may be caused by voltage fluctuation to the act ive driving display which activates pinching detection. Customer having this concern should have their vehicle repaired using the following repair procedure.
Associated Products (3)Associated Documents - December 2, 2016•Document ID: 10186256Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT
- Mfr Comm. #:
- 09-061-16
- Date Added:
- February 1, 2021
- Manufacturer:
- MAZDA
SummaryFctry MESSAGE DISPLAYED AFTER INSTRUMENT CLUSTER REPLACEMENT. After the installatioin of a new instrument cluster, the message "F ctry" IS DISPLAYED INSTEAD OF THE ODOMETER. Some new instrument clusters are in the factory mode setting. Factory mode cancellation is required.
Associated Products (4)Associated Documents - November 3, 2016•Document ID: 10185837Service Bulletin/Repair InstructionsAIR BAGS
- Mfr Comm. #:
- SA327
- Date Added:
- January 25, 2021
- Manufacturer:
- MAZDA
SummaryTAKATA recalls for Air bag
Associated Products (9)Associated Documents - November 3, 2016•Document ID: 10185835Service Bulletin/Repair InstructionsPOWER TRAIN:CLUTCH ASSEMBLY
- Mfr Comm. #:
- MTI_1138
- Date Added:
- January 25, 2021
- Manufacturer:
- MAZDA
SummaryMulti-Model - Clutch Slippage or Smell after Clutch Disc Replacement
Associated Products (9)Associated Documents - November 3, 2016•Document ID: 10185834Service Bulletin/Repair InstructionsEQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
- Mfr Comm. #:
- MTI_1137
- Date Added:
- January 25, 2021
- Manufacturer:
- MAZDA
SummaryMulri-Model (Equipped with Mazda connect) - DTC U0323/U0423/U3000 Cannot be deleted (Update)
Associated Products (9)Associated Documents - October 21, 2016•Document ID: 10185827Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- 07-004-16
- Date Added:
- January 25, 2021
- Manufacturer:
- MAZDA
SummaryAuto A/C blows warm air
Associated Products (2)Associated Documents - October 10, 2016•Document ID: 10185824Service Bulletin/Repair InstructionsBACK OVER PREVENTION
- Mfr Comm. #:
- 02-010-16
- Date Added:
- January 25, 2021
- Manufacturer:
- MAZDA
SummaryKnocking/squeaking noise from front shock absorber, creaking noise from front lower arm bushing.
Associated Products (8)Associated Documents - October 7, 2016•Document ID: 10186918Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA234
- Date Added:
- February 8, 2021
- Manufacturer:
- MAZDA
SummaryNew IDs software version 102.00 and Update 102.01 is now available on MS3 IDs update 102.00 and 102.01 is now available on MS3 under the "IDs/Infotainment" tab.
Associated Products (9)Associated Documents - September 22, 2016•Document ID: 10186912Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 09-049-16
- Date Added:
- February 8, 2021
- Manufacturer:
- MAZDA
SummaryRattle noise from rear spoiler when closing liftgate
Associated Products (1)Associated Documents - August 30, 2016•Document ID: 10092577Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- 02-012-16-3181A
- Date Added:
- February 23, 2017
- Manufacturer:
- MAZDA
SummarySOME VEHICLES MAY EXPERIENCE A TIRE PRESSURE MONITORING SYSTEM (TPMS) WARNING LIGHT ON WHEN DRIVING ON A SMOOTH ROAD SURFACE EVEN IF THE TPMS SYSTEM HAS BEEN PROPERLY INITIALIZED AT THE SPECIFIED TIRE AIR PRESSURE. THE TPMS SYSTEM MAY HAVE BEEN IMPROPERLY INITIALIZED WHEN THE INITIALIZATION WAS PERFORMED ON CERTAIN TYPES OF ROUGH ROAD SURFACES. THEN, WHEN DRIVEN ON SMOOTH ROAD SURFACES, THE TPMS SYSTEM MAY DETECT IMPROPER TIRE AIR PRESSURE. THE DSC HU/CM CONTROL LOGIC HAS BEEN CHANGED FOR THIS CONCERN.
Associated Products (1)Associated Documents - August 26, 2016•Document ID: 10092566Service Bulletin/Repair InstructionsEQUIPMENT; ELECTRICAL SYSTEM
- Mfr Comm. #:
- 00-005-16-3245
- Date Added:
- February 23, 2017
- Manufacturer:
- MAZDA
SummaryIN SUPPORT OF THE NEW MAZDA MX-5 AND CX-3, MAZDA WILL MAKE AVAILABLE FOR LOAN ON A AS-NEEDED BASIS, A SPE-CIAL SERVICE TOOL (SST) TO ALLOW FOR THE RADAR AIMING OF THE BLIND SPOT MONITORING (BSM) SYSTEM. THE (BSM) RADAR AIMING IS PERFORMED WHENEVER THE (BSM) CONTROL MODULE, THE (BSM) BRACKET OR THE REAR BUMPER IS REPLACED. THE TOOL IS AVAILABLE FOR LOAN ON MAZDA E-STORE.
Associated Products (2)Associated Documents - August 25, 2016•Document ID: 10092563Service Bulletin/Repair InstructionsSTRUCTURE:BODY:HATCHBACK/LIFTGATE
- Mfr Comm. #:
- 09-049-16-3233
- Date Added:
- February 23, 2017
- Manufacturer:
- MAZDA
SummarySOME VEHICLES MAY EXHIBIT A RATTLE NOISE FROM THE REAR SPOILER WHEN CLOSING THE LIFTGATE.THIS MAY BE CAUSED BY TOO MUCH CLEARANCE BETWEEN THE REAR SPOILER AND LIFTGATE GLASS. THE EXCESSIVE CLEAR-ANCE MAY CAUSE THE REAR SPOILER TO RATTLE WHEN CLOSING THE LIFTGATE.THE REAR SPOILER PROTECTOR (B) THICKNESS HAS BEEN INCREASED AT PRODUCTION TO IMPROVE FIT BETWEEN REAR SPOILER AND LIFTGATE GLASS (C) TO ILLUMINATE THE NOISE WHEN CLOSING THE LIFTGATE.
Associated Products (1)Associated Documents - August 25, 2016•Document ID: 10092561Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- 02-014-16-3235
- Date Added:
- February 23, 2017
- Manufacturer:
- MAZDA
SummarySOME VEHICLES MAY EXHIBIT OIL SEEPAGE FROM THE REAR SHOCK ABSORBER(S) WHILE THE VEHICLE IS ON A HOIST (I.E. DURING NORMAL MAINTENANCE OR OTHER SERVICE). CHECK THE LABEL ON BOTH REAR SHOCK ABSORBERS FOR THE LOT NUMBER (EXAMPLE: RA5 IS THE LOT NUMBER SHOWN IN THE ILLUSTRATION BELOW). IF THE LOT NUMBERS ARE WITHIN THE PRODUCTION RANGE SHOWN IN THE TABLE BELOW, REPLACE THE REAR SHOCK ABSORBERS WITH NEW ONES.
Associated Products (1)Associated Documents - August 22, 2016•Document ID: 10186320Service Bulletin/Repair InstructionsVISIBILITY; VISIBILITY:WINDSHIELD WIPER/WASHER
- Mfr Comm. #:
- MT-001-17
- Date Added:
- February 1, 2021
- Manufacturer:
- MAZDA
SummaryWindshield washer fluid change - Factory filled windshield washer fluid has been changed to an ethanol type (yellow color) instead of athe conventional methanol type (blue color). This change is for European compliance Mazda has decided to make the change for all markets.
Associated Products (9)Associated Documents - August 16, 2016•Document ID: 10084957Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- MTI_1115
- Date Added:
- November 29, 2016
- Manufacturer:
- MAZDA
SummaryBSM SYSTEM VEHICLE DETECTION HAS CHANGED. ALTHOUGH THE OVERALL FUNCTION IS THE SAME AS PREVIOUS VEHICLES, VEHICLE DETECTION IS DIFFERENT. FOR DETAILED BSM SYSTEM INFORMATION, REFER TO SERVICE HIGHLIGHTS.
Associated Products (6)Associated Documents - August 11, 2016•Document ID: 10092487Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 00-004-16-3237
- Date Added:
- February 22, 2017
- Manufacturer:
- MAZDA
SummaryRAISING A VEHICLE WITH A JACK CAN BE DANGEROUS IF NOT DONE PROPERLY. THE VEHICLE CAN SLIP OFF THE JACK AND SERI-OUSLY INJURE SOMEONE. IN THIS SERVICE INFORMATION, SOME IMPORTANT WARNINGS AND CAUTIONS HAVE BEEN TAKEN FROM THE OWNERS MANUAL. FOR MAZDA CUSTOMERS WHO HAVE QUESTIONS ABOUT SAFELY LIFTING THEIR VEHICLE TO CHANGE A FLAT TIRE OR TO INSTALL SNOW CHAINS, PLEASE PROVIDE A COPY OF THE ATTACHED HANDOUT FOR THEM. ALSO, BE SURE TO ALWAYS DIRECT CUSTOMERS TO FOL-LOW THE DIRECTIONS IN THE OWNER'S MANUAL.
Associated Products (78)2017 Mazda CX-32017 Mazda CX-52017 Mazda CX-92017 Mazda Mazda22017 Mazda Mazda32017 Mazda Mazda62016 Mazda CX-32016 Mazda CX-52016 Mazda CX-92016 Mazda Mazda22016 Mazda Mazda32016 Mazda Mazda62015 Mazda CX-52015 Mazda CX-92015 Mazda Mazda22015 Mazda Mazda32015 Mazda Mazda62014 Mazda CX-52014 Mazda CX-92014 Mazda Mazda2+ 58 moreAssociated Documents - August 10, 2016•Document ID: 10084949Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- MTI_1111
- Date Added:
- November 28, 2016
- Manufacturer:
- MAZDA
SummaryWHEN INSTALLING A NAVIGATION SD CARD, CONFIRM THAT THE CARD IS UNLOCKED. ALSO, MAZDA DOES NOT RECOMMEND SWAPPING NAVIGATION SYSTEM SD CARDS FROM ONE VEHICLE TO ANOTHER FOR TESTING. IF SWAPPED, THE SD CARD THAT IS INSTALLED INTO THE OTHER VEHICLE BECOMES LINKED TO THE VIN OF THAT VEHICLE.
Associated Products (16)Associated Documents - July 29, 2016•Document ID: 10091921Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- 02-012-16-3181
- Date Added:
- February 16, 2017
- Manufacturer:
- MAZDA
SummarySOME VEHICLES MAY EXPERIENCE A TIRE PRESSURE MONITORING SYSTEM (TPMS) WARNING LIGHT ON WHEN DRIVING ON A SMOOTH ROAD SURFACE EVEN IF THE TPMS SYSTEM HAS BEEN PROPERLY INITIALIZED AT THE SPECIFIED TIRE AIR PRESSURE. THE TPMS SYSTEM MAY HAVE BEEN IMPROPERLY INITIALIZED WHEN THE INITIALIZATION WAS PERFORMED ON CERTAIN TYPES OF ROUGH ROAD SURFACES. THEN, WHEN DRIVEN ON SMOOTH ROAD SURFACES, THE TPMS SYSTEM MAY DETECT IMPROPER TIRE AIR PRESSURE. THE DSC HU/CM CONTROL LOGIC HAS BEEN CHANGED FOR THIS CONCERN.
Associated Products (1)Associated Documents