Mercedes-Benz · Model Report
Mercedes-Benz Sprinter2023
Showing safety data for the 2023 model year only.
Recalls
Checking records…
Complaints
Checking records…
Investigations
Checking records…
Service Bulletins
Checking records…
Mercedes-Benz · Model Report
Showing safety data for the 2023 model year only.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2023-2024 Mercedes-Benz Sprinter 2500 vehicles. The right longitudinal frame member may not be reinforced properly, decreasing the structural integrity of the third-row seats.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2023-2024 Mercedes-Benz Sprinter vehicles. The spring U-bolts for the rear axle may have reduced strength due to improper heat-treatment, which can cause the rear axle to shift out of position.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2023 Mercedes-Benz Sprinter vehicles. A 12-Volt ground connection may not be secured properly, which can result in the ground connection overheating and a loss of drive power.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2023 Mercedes-Benz Sprinter vehicles. The main wiring harness may chafe against the drive shaft and short circuit, which can result in a loss of drive power, power steering, and brake system control.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2019-2023 Mercedes-Benz Sprinter and 2019-2021 Freightliner Sprinter vehicles. The partition wall may be missing bolts, allowing the wall to detach during a crash.
The High-Pressure Fuel Pump (HPFP) and corresponding fuel delivery pressure regulator/sensors have suffered an internal mechanical failure. The system intermittently fails to maintain commanded rail pressure, leading to critical engine cylinder misfires (P0302, P0304) and severe long-term fuel adaptation breaches (P00C600, P008992, P017184, P218862). This defect is physically causing raw gasoline to leak into the combustion chambers, oil crankcase, and exhaust tract. The vehicle and all compromised components are fully intact and available for immediate inspection upon request. My life and the safety of surrounding motorists were put at risk during a severe incident on the highway. While driving uphill in fast-moving traffic, the high-pressure fuel pump experienced an abrupt mechanical failure/pressure drop. The Engine Control Unit immediately plunged the van into Limp Mode, causing an uncommanded, violent loss of propulsion. The vehicle became entirely unresponsive to the accelerator pedal. Managing a large, heavily loaded commercial vehicle that suddenly dropped speed on a highway incline nearly triggered a catastrophic multi-vehicle rear-end collision. The underlying mechanical defect has been repeatedly ignored by authorized dealerships due to diagnostic negligence. The vehicle has been presented to Mercedes-Benz of Fairfield and another authorized location three separate times. Technicians relied solely on surface-level live data, clearing active trouble codes and releasing the vehicle unrepaired. The problem routinely reproduces itself every 30 to 45 days once the computer's long-term fuel software can no longer mathematically compensate for the physical fuel drop. Independent diagnostic scans have verified the historical and stored fault codes, and physical evidence confirms heavy carbon/fuel fouling on Cylinder #
No injuries · No fire · No crash
The ECM harness was wired too close to a sharp metal piece within the engine bay, the clip MBZ uses to secure it was insufficient to hold it back, the thick wiring harness got caught on the metal piece and overtime got cut deeply causing a short with thermal issues spreading to other components, the wiring harness melted together and caused so much heat in the engine bay that other components touching the thick wiring also have visible melt spots, if it wasn't caught because we got a shock from a metall component of the car and therefore realized there must be a short it could've potentially posed a fire risk.
No injuries · No fire · No crash
On January 19, 2026, my neighbors / daughter noticed smoke was coming from under the van that had been parked for over 3 hours. Shortly after, he confirmed the van had caught fire. I asked him to call the fire department.
The contact owns a 2023 Mercedes-Benz Sprinter 3500. The contact stated that while driving 65 MPH, there was an abnormal metal grinding sound coming from the rear of the vehicle. While driving at various speeds, the vehicle went into LIMP Mode. The transmission was shifted into neutral(N) and the vehicle was restarted. The vehicle was taken to the dealer, who diagnosed the vehicle with pinion bearing failure and the LIMP Mode failure causing an Emissions issue. The rear axle, air charger GPS, turbo, and oil sensor were all replaced. The vehicle was taken to the dealer and was diagnosed with the same failure. The vehicle was repaired. The manufacturer was informed of the failure and a case was opened to discuss a buy-back offer for the failure. The failure mileage was approximately 9,600.
No injuries · No fire · No crash
The contact owns a 2023 Mercedes-Benz Sprinter 3500. The contact stated that while driving approximately 35-40 MPH, the vehicle went into LIMP Mode. The contact was able to shift to neutral and restart the vehicle. The failure reoccurred at approximately 40,000. The failure became more frequent and was recurring every 3,000 to 4,000 miles. The vehicle was taken to the dealer, who diagnosed the vehicle with an inoperable air charger for the turbo charger. The failure persisted, and the vehicle was returned to another dealer, Mercedes-Benz of Arrowhead (9260 W Bell Rd, Peoria, AZ 85382) to be diagnosed and the vehicle was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The engine was replaced, but the failure persisted. The manufacturer was informed of the failure, and a case was opened to discuss a buy-back offer. The failure mileage was approximately 33,000.
No injuries · No fire · No crash