I am not a mechanic or a 'car person', so I may not know technical terms. This has occurred 4-6 times since purchasing the truck in March '26. After initial start up, it has a tendency to accelerate when applying the break. This is only within the first several minutes after startup. The most recent incident caused the truck to "roll" into the main street rather than coming to a complete stop. I was applying the break, but the truck was 'resisting' to come to a complete stop. The local Ford mechanic found this to be "undesirable, but normal characteristic". The situation that is occurring is anything BUT normal. The Ford dealer was able to replicate the situation, but deemed it to be "no further instructions on fixes or issues related to this concern and no further action can be perfomed" The truck is available for inspection. This is a major safety issue as I was unable to stop the truck before entering the main road. Yes, the truck was inspected by the dealer. There were no warning messages
No injuries · No fire · No crash
Vehicle received and installed an over-the-air software update to the Body Control Module, identified on the vehicle screen as BCM-26.6.3 and associated with Safety Recall 26S29 (A-pillar/sun visor wiring, NHTSA 26V238000). The update screen displayed a status of "Not Completed." Since that update the vehicle will not start and is inoperative. Current condition: opening the driver door wakes the center infotainment screen only. The instrument cluster does not illuminate. Pressing the brake pedal produces no response - no cluster illumination, no warning lamps, no chimes, no messages, no crank. 12V power is present; the manufacturer's telematics app still reaches the vehicle and returns status. Symptoms are consistent with a Body Control Module that is powered but not communicating on the vehicle network. No warning lamps, messages, or symptoms were present before the update. The vehicle operated normally until the update was installed. Safety risk: the vehicle became immobile without warning immediately following installation of a manufacturer-pushed safety recall remedy. The transmission cannot be shifted electronically, requiring the manual park release to move or tow the vehicle. Had this occurred away from home or in a traffic lane, the vehicle would have been stranded and unable to move under its own power. The BCM also governs exterior lighting and hazard lamp function. Note: the update screen header displayed "25S29" while the body text referenced completing Safety Recall 26S29. The vehicle has a dealer-installed Ford Performance ProCal calibration. The vehicle has not yet been inspected by the dealer or manufacturer. It is available for inspection upon request.
No injuries · No fire · No crash
Truck is randomly switching to Baja mode which engages the 4wheel drive making steering difficult
No injuries · No fire · No crash
I was exiting the freeway, and as I was turning off of the freeway onto a side street, at approximately 20mph, my vehicle did not respond to throttle input, and left me slowing to a stop in the middle of a busy intersection. I had to shift my vehicle into neutral and then back into drive, to get it to respond to throttle input. When I slow down at intersections, turn and then attempt to throttle my vehicle, it hesitates and struggles to output power until I throttle about halfway.
No injuries · No fire · No crash
No incident occurred. This is to report a safety issue related to the activation of the rear view camera while driving forward. There are times when a vehicle (automobile/motorcycle) may be following closely, and the rear view mirrors are inadequate to see the following vehicle clearly. If the rear view camera is activated, the image projected by the camera is obscurred by a message stating "Full View Not Available". There appears to be no way to remove this message so that the image in not obsurred. See attached photo.
No injuries · No fire · No crash