The transmission under several circumstances will just stall out. Will NOT allow the vehicle to accelerate. Flooring the gas pedal does not do anything. RPM may go up a couple hundred RPM (not thousand) but the truck just will not move. After this now happening several times I can tell you that it happens when making a left or right hand turn without coming to a complete stop and the area turning into is an up hill section. Watching the gear indicator normally shows a very high gear of 8 or higher. Trans needs to down shift but it will not. Stomping accelerator to the floor does nothing. On and off to the floor does nothing. Pulling the shifter to manual and flicking the change gear does work and if you don't have on coming traffic bearing down that's fine. But if you have on coming traffic and you can't move it is a major safety issue in my mind. The vehicle feels like you have pulled up to a parking curb and after stopping you try to go over it with little to no power being applied. This has happened now seven times. Ford dealer says the vehicle shows no codes.
No injuries · No fire · No crash
The contact owns a 2024 Ford Ranger. The contact received notification of NHTSA Campaign Number: 26V238000 (Structure, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that there was an abnormal burning odor inside the vehicle, and the instrument cluster flickered while driving. The dealer was contacted and confirmed that parts were not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the failure and informed the contact that a second letter would be sent once the remedy was available, and parts were anticipated by the end of August 2026. The failure mileage was approximately 323.
No injuries · No fire · No crash
The drive mode randomly changes by itself while drive. When this occurs it can shift to 4 wheel drive will moving on dry pavement. This this not been checked out by the dealer because based on online forums others have the same issue and Ford can not reproduce or provide any fixes. I'm assuming there have been other complaints for this same issue reported to NHTSA. I'm adding a date for when this happened below, but it has happened at least six times since I have owned the truck online forums [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
No injuries · No fire · No crash
Please refer to Problema Espaldar de Asiento -Jun 07, 2026 - Attached Safety Concern Description: The rear seat backrest has a manufacturing defect that prevents the seat from properly locking into the secured position. The seat backrest remains loose and does not provide confidence that it is fully latched. To close or secure the seat, excessive force is required. Even after applying force, the issue persists, and the mechanism causes damage to the rear interior area of the vehicle. This condition may represent a safety risk because the rear seat backrest may not remain properly secured during vehicle operation or in the event of a crash. I am requesting a safety evaluation of this condition as a potential manufacturing defect.
No injuries · No fire · No crash
Hello, I have a 24-ford ranger raptor, this incident happened twice, I was driving approximately 60 MPH and vehicle on its own started changing drive modes. It switched itself to baja mode which is 4-wheel drive and very dangerous at these speeds. I took my truck to local ford dealer in Valencia Ca, Dealer stated no codes or issues found. This is deeply concerning to me; I Have family that also drives this vehicle. I have read online that other same vehicle owners are experiencing same symptoms and heavy concerns. Not sure where to go from here, any help or feedback would greatly appreciated. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
No injuries · No fire · No crash