Ford · Model Report
Ford F-2502025
Showing safety data for the 2025 model year only.
Ford · Model Report
Showing safety data for the 2025 model year only.
Ford Motor Company (Ford) is recalling certain 2025-2026 F-250 SD, F-350 SD, F-450 SD, F-550 SD, F-600, 2026 F-150, and F-750 SD vehicles. The analog clusterâs tachometer and speedometer may become stuck or move erratically, providing inaccurate readings to the driver. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) Number 101, "Controls and Displays."
Ford Motor Company (Ford) is recalling certain 2021-2023 F-150 and 2023-2026 F-250 SD vehicles equipped with 8-inch SYNC infotainment screens. A software error may cause the rearview camera image to be obstructed by the infotainment home screen menu when the vehicle is placed in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
Ford Motor Company (Ford) is recalling certain 2026-2025 F-250 SD and F-350 SD vehicles. The driveshaft friction weld may fail, resulting in rear driveshaft separation and a sudden loss of drive power.
Ford Motor Company (Ford) is recalling certain 2021-2026 F-150, 2022-2026 F-250 SD, F-350 SD, F-450 SD, F-550 SD, Maverick, 2024-2026 Ranger, 2023-2026 F-600 SD, 2022-2027 Lincoln Navigator, Expedition, and 2026 E-Transit vehicles. When towing a trailer, the integrated trailer module (ITRM) may lose communication with the vehicle, possibly causing a loss of brake and turn signal lights, or a loss of brake function. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, " Lamps, Reflective Devices, and Associated Equipment."
Ford Motor Company (Ford) is recalling certain 2025-2026 F-550 SD, F-450 SD, F-350 SD, F-250 SD, and 2025 F-150 vehicles. The Instrument Panel Cluster (IPC) may fail at startup.
During collision seat did not retain its upright position and collapsed/reclined backwards fully.
Driving for 10 minutes when I started smelling a burnt smell. 30 to 45 seconds later I noticed smoke coming out the vents. A few seconds later (while at a stop sign at this point) I see smokecoming out of the hood. Vehicle would not go into park. After several attempts I finally was able to get the vehicle in park and get it to shut off. Opened the hood, saw a small 1 inch flame behind the motor near the firewall on the driversside and immediately called the fire department or emergency responders. Within 3 mins my vehicle was up in flames for a catastrophic vehicle loss.
For years FORD vehicles, especially pickup trucks, have blinded drivers with their improperly adjusted headlights; because FORD gives incorrect instructions to adjust them. I refer to page 474 of the 2025 Superduty owners manual as evidence. The instructions FORD gives are to set the low-beam LEVEL, shinning the beam onto a vertical surface 25 feet from the vehicle with the beam at the same height as the headlight on the truck. This is incorrect. There should be at least a 3 inch drop of the low-beam at 25 feet. If there is no drop of the tall truck's headlight (the F-250 stock ride height of the headlight is 44 inches above the ground) it will always blind other drivers of cars/sedans--especially via the outside mirrors. This problem has become acute now that the extra bright LED headlights are becoming the norm; making two-lane roads on a rainy night a truly blinding experience. Please require FORD to correct their dangerous mistake.
No injuries · No fire · No crash
The contact owns a 2025 Ford F-250. The contact stated that while driving at various speeds, the steering wheel inadvertently turned to the right, then pulled to the opposite direction. The contact stated the steering wheel was cocked to the left or right even though the vehicle was driving straight down the road. There was no warning light illuminated. The contact stated the failure was due to the steering angle sensor. The vehicle was taken to the local dealer, where it was diagnosed that an alignment was needed. The vehicle was repaired, but the failure recurred. The manufacturer was contacted, and a complaint was filed. The failure mileage was approximately 13.
No injuries · No fire · No crash
The contact was an insurance company that called on behalf of the previous owner. The contact's Insurance Company took possession of a 2025 Ford F-250. The contact stated that while driving at an undisclosed speed, a loud popping noise was heard coming from the vehicle with no warning lights illuminated. The contact stated that following the failure, the driver lost control of the vehicle, which resulted in a collision with another vehicle. The contact also stated that a tire unexpectedly detached from the vehicle during the incident. The vehicle then veered off the roadway and collided with a tree, where it came to a stop. No injuries were sustained, and no medical attention was required. A police report was filed. The contact confirmed that the air bags deployed during the crash. The vehicle was towed from the scene and deemed a total loss by the insurance company. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The contact mentioned that there was an unknown Ford recall regarding the suspension but was unable to reach Ford to confirm if the VIN was associated. The failure mileage was not available.