Chevrolet · Model Report
Showing safety data for the 1994 model year only.
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
CERTAIN R&B, INC. CENTRAL MULTIPORT FUEL INJECTION (CMFI) FUEL RETURN LINES, MODELS HELP 55163, NAPA BALKAMP 700-3270, AND THE CONNECTION 2560001, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE FUEL RETURN LINE HAS A MECHANICAL BLEED VALVE WHICH WAS NOT INSTALLED AT THE PROPER TORQUE.
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: CERTAIN LIGHT DUTY PICKUP TRUCKS, SPORT UTILITY VEHICLES, OR MINIVANS EQUIPPED WITH 3-SENSOR ABS (ANTILOCK BRAKING SYSTEM) EBC4 UNITS.
VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE.
I WAS DRIVING HOME EARLY THIS MORNING, AFTER DOING A LITTLE HILL CLIMBING THE NIGHT BEFORE WITH A FRIEND. ON THE WAY HOME I WAS DRIVING UNDER THE SPEED LIMIT, WHEN THE VEHICLE ABOUT 3 SECONDS IN FRONT OF ME STOPPED, I IMMEDIATELY HIT THE BRAKES, THE BRAKES DID NOT WORK PROPERLY, CAUSING ME TO HIT THE REAR END OF THE CAR IN FRONT OF ME, CAUSING DAMAGE TO BOTH VEHICLES, I RECEIVED A TRAFFIC VIOLATION, AND A NECK SPRAIN. *TR
I WAS DRIVING DOWN THE ROAD, CAME TO A STOP SIGN, THEN STARTED TO ACCELERATE. ALL THE SUDDEN MY SEAT BACK BROKE AND FOLD BACKWARD, IN A LAID DOWN POSITION, ALMOST CAUSING ME TO CRASH. A FEW MONTHS LATER, THE PASSENGER SIDE SEAT BACK DID THE EXACT SAME THING. I REMOVED THE BROKEN SEATS, AND INSTALLED TWO NON ADJUSTABLE SEATS FROM A OLD AURORA, USING THE ORIGINAL SEAT BRACKET, WHICH BOLTS THE SEAT TO THE FLOOR PAN. THESE SEATS ARE UNSAFE ALSO, BECAUSE WHEN I REPLACED THE SEATS, THE BOLT HOLES IN THE FLOOR BECAME STRIPPED WHILE REMOVING THE BOLTS. I CANNOT SAFELY DRIVE THE VEHICLE ANY LONGER. *TR
No injuries · No fire · No crash
LOST BRAKES HOSES RUSTED. *TR
No injuries · No fire · No crash
DRIVER'S SIDE FRONT SEAT/SHOULDER BELT WILL NOT RETRACT. IT IS FULLY EXTENDED AND WILL NOT RETRACT TO TIGHTEN ON THE SHOULDER. IT STAYS COMPLETELY LOOSE. THIS IS FOR A 1994 FULL SIZE CHEVY BLAZER. *TR
No injuries · No fire · No crash
1994 CHEVROLET S10 BLAZER. CONSUMER STATES SEVERAL PROBLEMS WITH VEHICLE *TGW THE CONSUMER STATED THE VEHICLE HAD BROKE DOWN A TOTAL OF 9 TIMES 5 OF WHICH THE VEHICLE WAS TOWED BACK TO THE USED CAR DEALER. THE FUEL PUMP, BATTERY, STARTER, STUDS AND LUG NUTS ALL HAD TO BE REPLACED. ALSO, THE BRACKET FOR THE ALTERNATOR, A BOLT FOR THE POWER STEERING, THE PITMAN ARM, HUB WHEEL ASSEMBLY, 4- WHEEL DRIVE ACTUATOR AND UPPER AND LOWER BALL JOINTS ALL NEEDED TO BE REPLACED. *JB
No injuries · No fire · No crash