The contact owns a 2021 BMW X3. The contact received notification of NHTSA Campaign Number: 26V438000 (Electrical System). The local dealer confirmed that the remedy was not yet available. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The contact had not experienced a failure.
No injuries · No fire · No crash
I am reporting a potential safety issue involving my **2026 BMW X3 30 xDrive**. I was parked on the right side of a parking lot. I moved the vehicle partially out of the parking space and slightly to the left to allow someone to enter the vehicle. I came to a stop and removed my foot from the brake while the vehicle was being held. I then turned toward the rear of the vehicle. The vehicle suddenly accelerated/moved forward across the parking aisle and struck two vehicles. The incident happened extremely quickly. I cannot state with certainty whether my foot inadvertently contacted the accelerator, and I do not want to speculate. I believe I attempted to brake. Of particular concern, I experienced **no apparent automatic collision-avoidance/emergency braking intervention before striking the vehicles**. Prior to this accident, I had expressed concern to a BMW advisor about the speed and acceleration of this vehicle while using its automated parking system. While the advisor was demonstrating the automated parking feature, I specifically commented that the vehicle was moving unusually fast and that I was uncomfortable with the amount of acceleration. I was told that this behavior was normal. On another occasion while using the automated parking/reverse function, I became sufficiently concerned about the vehicle's speed and acceleration that I applied the brake myself because I was afraid the vehicle could cause a collision. I had also previously raised concerns regarding inconsistent operation of the vehicle's Lane Departure Warning/assistance system. I have contacted BMW of North America and requested that BMW preserve and examine the vehicle's electronic and diagnostic data, including accelerator and brake inputs, Auto Hold status, automated parking system activity, Forward Collision Mitigation/Automatic Emergency Braking activity, sensor information, diagnostic/event logs and available crash/event data. I have specifically asked BMW to determine whether acc
2022 BMW X3 M40i. The Driver Assistance system appears to activate normally after startup with no warning or indication that a fault is present. However, within approximately 3–5 minutes of driving, a Check Control message appears stating “Driver Assistance limited. Camera vision.” The vehicle then identifies affected systems including Pedestrian Warning, Frontal Collision Warning, Side Collision Warning, Automatic Lane Change, Active Blind Spot Detection, and Steering Assistant. A separate message states that Active Cruise Control is reduced and there may be no brake intervention for stationary vehicles. The safety concern is that the system can appear active and available before the warning appears, even though at least some driver-assistance functions may already not be operating. Before the warning was displayed, I observed that Steering Assistant/lane-keeping did not intervene and I crossed out of my lane without steering correction or a lane-departure warning. There was no prior warning that the camera-based system was malfunctioning. I cannot confirm whether the other affected safety functions were operational during this interval. A BMW dealer inspected the vehicle and physically found the KAFAS camera hood/trim warped from heat. The warped component was removed and shown to me, and the dealer ordered a replacement. BMW has issued SIB 66 13 23 addressing KAFAS camera hood deformation on affected vehicles. Fault memory also contained KAFAS codes 800ABF, 800ABE, and 800AC4 for camera field-of-view disturbance and calibration failure. This creates a potential safety defect because the driver may reasonably believe lane-keeping and other camera-based safety systems are functioning until the vehicle detects the failure several minutes later. The vehicle/component can be made available for inspection
No injuries · No fire · No crash
The contact owns a 2021 BMW X3. The contact stated that while attempting to start the vehicle, the engine hesitated while turning over. The contact received notification of NHTSA Campaign Number: 26V438000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. The failure mileage was 76,494.
No injuries · No fire · No crash
I was pulling out of a parking spot and my X3 completely stalled and lost power. I got infomation on my screen to take my car to my dealer as soon as possible. I was able to start and drive it home. The following week I took it to the dealer for the problem. My local BMW dealer has had my X3 since July 27th over 2 weeks. They said they waiting for a code or fix for what happened. I don’t know if it’s a power train or engine problem. My X3 only has 21,000 miles on it. My concern is this problem could have happened on highway and I could have had a different outcome.
No injuries · No fire · No crash
