On multiple occasions the U-Connect system in the listed 2026 RAM 3500 has gone completely black and was inoperable until a reset was performed. The trailer brake gain control and exhaust brake are accessed and controlled via the touch screen U-Connect system. This failure poses a significant safety issue when the screen goes black and the controls cannot be accessed when pulling a trailer. This can lead to failure to slow/stop the vehicle while in motion, tire failure on the trailer etc. The only method to regain access to the brake controls is to perform a reset of the U-Connect system which can take 2-3 minutes to complete. Stelantis is and has been aware of this issue for some time and has no resolution at this time.
No injuries · No fire · No crash
When driving the Anti lock brakes, cruise control, front and rear collision warning system, automatic emergency breaking system and lane keeping system are disabled. All of these alerts are displayed on the display cluster. All of these systems are disabled at the same time. I was told by the dealership that this is caused by a faulty Wheel Speed Sensor. The Wheel Speed Sensors have been replaced 3 times and have not fixed this problem. This has happened when towing a 14,000lbs trailer and the stability of the truck and load are compromised when breaking with a load.
No injuries · No fire · No crash
I have been submitting reports to you for several months with no resolution. The truck yet again experienced the same problem, twice, within 1 week. It would start but then claim that it couldn't detect what gear it was in and said "can't shut off until transmission is in park". After cutting electrical power to get it to shut off, it would not start. After getting it started, it would not go into gear. Once I got the engine running and transmission to go into gear, it no longer had ABS.
No injuries · No fire · No crash
The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures.
No injuries · No fire · No crash
The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. My truck has been to 2 dealerships for a total of 5 repair attempts so far.
No injuries · No fire · No crash