Ford · Model Report
Showing safety data for the 2018 model year only.
Ford Motor Company (Ford) is recalling certain 2015-2018 Focus and 2013-2016 Fusion vehicles previously repaired incorrectly under recall numbers 18V169 and 18V845. The clutch may fracture, resulting in damage to the transmission assembly and possibly a transmission fluid leak.
Ford Motor Company (Ford) is recalling certain 2012-2018 Focus vehicles previously repaired incorrectly under recall number 18V735. The Canister Purge Valve (CPV) may malfunction, causing the engine to stall unexpectedly while driving.
Ford Motor Company (Ford) is recalling certain 2016-2018 Focus, 2019 Explorer, and 2024 Explorer vehicles. The engine block heater may crack and develop a coolant leak, causing it to short circuit when the block heater is plugged in.
Ford Motor Company (Ford) is recalling certain 2013-2018 Focus, 2013-2019 Escape, and 2015-2016 MKC vehicles equipped with a 2.0L engine. The engine block heater may crack and develop a coolant leak, causing it to short circuit when the block heater is plugged in.
Ford Motor Company (Ford) is recalling certain 2016-2018 Ford Focus and 2018-2022 Ford EcoSport vehicles. The oil pump drive belt or drive belt tensioner may fail, resulting in a loss of engine oil pressure.
when the vehicle accelerates too quickly or up a very gradual hill, barely any slope, it will slow to a stop. this is in line with the current recalls with other Ford focus 2018s likely caused by the Canister Purge Valve. it has the exact same symptoms, poor fuel economy, rough idling so much so the entire vehicle shakes, and the dangerous part- stalling. I have now stalled 4 times and have been in and out of multiple mechanics for this issue and no one can seem to identify the root and it's getting costly. now they are saying it might be the canister purge valve but if it is I think it should be covered despite my vin not being perfectly aligned because it's ultimately the same issue with the same vehicle, make and model.
No injuries · No fire · No crash
The contact owns a 2018 Ford Focus. The contact stated that after the vehicle was repaired under a recall, while driving 45 MPH, the vehicle unexpectedly idled, causing the engine to misfire with the check engine warning light illuminated. The contact stated that the vehicle sputtered during the misfire. The vehicle was taken to the dealer, where the contact was informed that the engine needed to be repaired. The vehicle was repaired; however, the failure recurred. The vehicle was taken back to the dealer to be diagnosed, and it was determined that the cylinder wall had failed and the engine needed to be replaced. The contact was concerned that the failure was caused by an improper recall repair. The contact stated that the failure had not occurred until after the recall repair was performed. The manufacturer was made aware of the failure by telephone, and a case was opened. The failure mileage was approximately 63,126.
No injuries · No fire · No crash
My car had been driving fine. Until one day I leave my house and crank my car up and it does not go into reverse. It loses engine power and stalled into traffic. This is an on going issue as you can see stories from other people with the same make and model as my car with the same issue. No warning signs, hasn’t been checked out but I have contacted Ford and they only cover models with this issue 2012-2016. I think it should cover 2018 as well.
No injuries · No fire · No crash
"My 2018 Ford Focus was traveling uphill at highway speed. I fully depressed the accelerator because the vehicle was losing speed. The vehicle did not respond with additional acceleration and subsequently continued to lose speed despite the accelerator remaining fully depressed. The dealership inspected the vehicle and told me that the engine is not powerful enough for sustained uphill driving and that the vehicle performed as designed. I am reporting this because I am concerned about the loss of ability to maintain speed despite full accelerator input and whether this constitutes a safety defect."
No injuries · No fire · No crash
The contact owns a 2018 Ford Focus. The contact stated that on several occasions while driving uphill, the vehicle lost power, the check engine warning light illuminated, and the message "Engine Fault" was displayed. The contact inspected the vehicle and noticed that the check valve on the vacuum pump had separated. The check valve was replaced every 1,000 miles. The contact stated that while driving approximately 35 MPH, the vehicle lost power and the oil warning light flashed. The vehicle was taken to the residence and parked. The contact inspected the vehicle and checked the dipstick, noticing bits of rubber inside the oil. The failure mileage was approximately 32,000.
No injuries · No fire · No crash