Volkswagen · Model Report
Safety data across 37 model years.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2021 Atlas Cross Sport, Tiguan LWB, Jetta NF, Jetta GLI, Golf GTI, Atlas FL and Arteon vehicles. The rear view camera could malfunction during an ignition cycle, leading to a black screen or infotainment system freeze. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
my car is 5 years old, only has 37291miles. Failed Component: Seat Belts (Right Rear Passenger Buckle) Description of Incident: The right rear passenger seat belt buckle assembly has suffered a complete mechanical latch failure. When attempting to insert the seat belt tongue into the buckle receptacle, the internal latching mechanism fails to engage, catch, or lock. The seat belt cannot be secured under any amount of pressure, rendering the entire passenger seating position completely unusable and unsafe. This is a premature component failure of a core, federally regulated safety restraint system on a vehicle with only 37,291 miles. The vehicle has not been involved in any prior collisions, and there is no physical damage or debris inside the buckle. The part has simply failed mechanically under normal, low-frequency usage. Crash/Injury/Fire: No crash or injury has occurred yet because the seating position is being left vacant due to the extreme safety risk. Nor was there any debris found by VW service technicians Remedy: The vehicle manufacturer (Volkswagen) has been notified of the component failure. Volkswagen corporate case number is 07656953.
No injuries · No fire · No crash
Since shortly after purchase, the vehicle has experienced intermittent drivability and shifting issues along with repeated EPC and check engine warnings. Diagnostic trouble code P0111 (intake air temperature plausibility) has been present along with other electrical and engine management faults. A Volkswagen dealership diagnosis indicated that the intake air temperature sensor and an additional engine insulation “hood blanket” component (not originally installed on the vehicle) are required to address the issue. These components were presented as necessary to correct the fault and resolve intermittent shifting behavior. The shifting issue is intermittent but occurs during normal driving and raises safety concerns due to unpredictable drivability and transmission behavior. The vehicle continues to exhibit warning lights and unresolved performance issues despite multiple repair attempts. The dealership has not identified a clear root cause, and prior repairs including sensor and EVAP-related components have not resolved the condition. Given the involvement of transmission-related drivability concerns and repeated unresolved electronic faults affecting engine performance, I am filing this complaint as a potential safety-related defect affecting normal vehicle operation.
No injuries · No fire · No crash
Headlight lens assembly of both headlights is cracking excessively. Upon review of online forums, this is happening frequently to many consumers. This impacts headlight output and looks to be manufacturing defect. Recently reported to dealer who indicated they have seen many of these recently and so far most have been handled by warranty but they would take pictures and submit. If this is known mfg defect why are their not proactive remedy/replacement?
No injuries · No fire · No crash
I was almost rear ended because Hill hold assist did not disengage quickly. I’ve driven manual transmission for over 40 years and find this hill hold dangerous!
No injuries · No fire · No crash
The last few months my schedule changed and I'm driving in the dark now. The auto dimming mirror does not function as expected, it is too slow in response to prevent glare and blinding from vehicles behind me. By the time the mirror decides to dim I'm already blinded from the glare and can no longer see what is in front of me. Also, since it does not dim to the edge I still get blinded from the glare around the perimeter of the mirror (there is no way to adjust this to prevent it). Since this mirror is also "rimless" (no plastic cover on the edge) the polished edge causes light refraction thereby blinding me in daylight. Currently the only way to prevent glare from the mirror is point it down to the floor rendering useless and dangerous.
No injuries · No fire · No crash
