Nissan North America, Inc. (Nissan) is recalling certain 2014-2020 Rogue and 2017-2022 Rogue Sport vehicles equipped with a jackknife style ignition key. The jackknife key may collapse into a folded position while driving.
Nissan North America, Inc. (Nissan) is recalling certain 2017 Rogue vehicles. Water may leak into and corrode the dash side harness connector.
Nissan North America, Inc. (Nissan) is recalling certain 2017-2019 Rogue Hybrid vehicles. The hydraulic brake booster assembly may overheat internally, resulting in a loss of power brake assist. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 135, "Light Vehicle Brake Systems."
Nissan North America, Inc. (Nissan) is recalling certain 2017-2019 Rogue Hybrid vehicles. Contact with the Electronic Control Module (ECM) bracket may damage the engine harness, causing a blown fuse.
Nissan North America, Inc. (Nissan) is recalling certain 2016-2017 Nissan Rogue vehicles. The recliner joints on the lower seat frame for the rear seats may have improper welds. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standards (FMVSS) number 207, "Seating Systems," and 210, "Seat Belt Assembly Anchorages."
The contact owns a 2017 Nissan Rogue. The contact stated that while driving at approximately 15 MPH, there was a burning odor inside the vehicle. Moments later, smoke and flames were seen coming from under the driver's side dashboard. The vehicle was immediately parked, and the contact used a t-shirt to extinguish the flame. After extinguishing the flame, the contact discovered that the vehicle would not restart. The manufacturer and local dealer were notified of the failure. The contact stated that the windows had previously failed to roll up and stuck open. T The failure mileage was 99,000.
2017 Nissan Rogue AWD – CVT transmission failure at approximately 57,000 miles. Vehicle is currently undriveable. Diagnostic testing identified P0776 / Pressure Control Solenoid "B." Two independent mechanics have determined that the CVT requires complete replacement. Nissan has previously extended CVT warranty coverage and entered into class-action settlements involving CVT failures in 2014–2018 Rogue vehicles. Requesting that NHTSA record this premature CVT failure for consideration of a potential defect trend.
No injuries · No fire · No crash
I was adjusting the seat up and it felt like something broke loose and wentkind of sideways, and then the airbag light went on and freaked me out and about wrecked my car. I took it in to get it looked at and apparently the seat breaking loose caused the airbag to come unplugged and they said the rail and frame need replaced. The car doesn’t even have 80,000 miles on it and this is apparently a big problem with these seat frames and rails breaking loose, but yet my car is not part of the recall. It needs to be part of the recall. I think Nissan should help pay for the cost of this stuff. This is a serious safety issue and most people don’t have an extratwo grand to throw down to keep their car safe when it is poor manufacturing.
No injuries · No fire · No crash
I am reporting a severe safety hazard regarding unresolved secondary electrical component damage caused directly by the Recall PC934 factory defect on my 2017 Nissan Rogue SL AWD. The vehicle experienced severe moisture entry, heavy rust on the driver-side floorboard, a complete loss of Electronic Power Steering, an inoperable electronic trunk, and a massive parasitic battery drain with visible terminal corrosion. The dealership performed the physical PC934 wiring harness connector swap but left the vehicle completely undrivable with zero power steering assist, claiming the secondary component damage is my out-of-pocket responsibility. Nissan Corporate is actively denying recall assistance for the exact short-circuit failures detailed in their federal recall documentation, posing an immediate physical threat to drivers. My case number on the case is 57100798
No injuries · No fire · No crash
My vehicle is suffering from severe brake safety failures directly caused by federal recall R22A6 (ABS Actuator Thermal Damage). Under heavy stop-and-go conditions in a parking lot, the vehicle's ABS, Slip, and Brake warning lights all illuminated simultaneously, creating an immediate safety hazard on public roads.The problem and specific components have been verified via multiple diagnostic scans. Prior to the recall service, an OBD-II scan at Autozone revealed active codes C1111 (ABS Pump Motor Failure) and C1130, which perfectly match the thermal/electrical failure path of recall R22A6. The defective components are available for inspection upon request.However, Alhambra Nissan dealership merely completed the paperwork for the recall campaign but refused to remedy the actual collateral damage to the ABS pump motor, demanding an additional $240 diagnostic fee instead. Furthermore, immediately after their service, a new code P0113 (Intake Air Temperature Sensor Circuit High) appeared, proving the dealership technician damaged or left an engine sensor unplugged during the recall work. Contacted the dealer for the new code, they insist to do the diagnostic for that issue. Both the dealer and Nissan North America Corporate have ignored my formal safety inquiries and gone completely silent, forcing me to operate an unsafe vehicle.
No injuries · No fire · No crash