Ford · Model Report
Showing safety data for the 2026 model year only.
Ford Motor Company (Ford) is recalling certain 2026 Ranger vehicles equipped with a 10.1-inch center stack screen. The screen may lose power and fail to display the rearview camera image. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Ford Motor Company (Ford) is recalling certain 2026 Explorer, Bronco, Bronco Sport, Mustang, and Ranger vehicles. The engine piston domes may have been manufactured incorrectly, which can result in piston dome failure and lead to a loss of drive power.
Ford Motor Company (Ford) is recalling certain 2025-2026 Explorer, Ranger, and Bronco vehicles. The engine may fail, which can result in a loss of drive power.
Ford Motor Company (Ford) is recalling certain 2026 Ranger and Bronco vehicles. The vehicle specifications listed on the tire placard and safety certification labels may be incorrect, including the VIN, capacity weight, seating capacity, front and rear gross axle weight rating (GAWR), tire and rim dimensions, and recommended cold tire pressure. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims" and 49 CFR Part 567, "Certification."
Ford Motor Company (Ford) is recalling certain 2024-2026 Ranger and Bronco vehicles. The front seats may have a loose or dislodged seat frame height-adjust pivot bolt.
This is a follow up to previous report 11773016. This morning we had Triple "A" haul the 2026 ford ranger lariat to the Corwin Ford dealership here in Reno. Upon arriving to pick up the vehicle the Tow vehicle driver looked under the vehicle and discovered ALL attaching bolts on the left front brake caliper missing and the caliper floating loosely. He was shocked that we had not had a critical incident!! I had reported earlier to Corwin Ford unusual locking up on left turns and was told by the dealership that there was NOTHING WRONG. We have been driving the vehicle at highway speeds to and from RENO- This is outrageous!!!!!!!!!!!!!!!!!!!!!
No injuries · No fire · No crash
After arriving in Carson City from Reno, NV and running errands on local city side streets the vehicle began making a loud ticking noise which transitioned to a whomp/whomp/whomp noise. I pulled over at the nearest opportunity into a business parking lot and the vehicle brakes immediately locked up. I received the following error messages on screen; > Anti lock brake system failure >Hill start assist failed >Electric parking brake failed >Collision assist unavailable >Check engine brake light >I checked documentation for release of parking brake and followed directions and the brake would not release. After multiple attempts the brakes would not release. Next I tried putting the vehicle into reverse and the brake finally released. All warning lights now remain on and brakes pull to the rights when applied.
No injuries · No fire · No crash
truck goes in and out of 4wd high while driving, even though the selector dial is in 2wd.
No injuries · No fire · No crash
When setting up my vehicle for neutral towing behind my motorhome and having parts installed for the proper operation of my turn signal and brake lights when vehicle is flat towed it was found that for it to happen were the brake lights do not override the turn signal when both activated at the same time you have to let the vehicle enter into a sleep mode for 10 minutes with the key FOB completely isolated from the vehicle for 10 minutes. If you stayed near the vehicle or approached with the key fob closer than 30ft it would come out of the sleep mode and when pushing on the brake pedal and using your turn signal at the same time from your motorhome you would override the turn signal with the brake lights. Normal checks for RV'ers would not identify this issue as you would stand behind the vehicle you are towing to check right and left turn signals then shut them off and check the brake light then final check would be rear, front and marker lights never pushing the break and having the turn signal on at the same time. This is a safety issue for anyone behind you as they can see you are braking but not be aware you are turning if you have awaken your vehicle modules by it getting a signal from the Key FOB. This issue was found and verified by my installer and myself when checking as to why the turn signal would shutoff at the same point I pushed the brake pedal in my RV. The manufacturer has no information in its manually about this 10 minute delay nor that the FOB can keep the delay from occurring by being near the vehicle. When you actually keep the vehicle in the sleep mode what happens is the active turn signal blinks and the opposite light indicates a brake light.
No injuries · No fire · No crash
8/4/2026 @ approximately 0630 When making a right hand turn vehicle (transmission) stalled for approximately 3-4 seconds before restarting. Reported to Corwin Ford Service Dept. here in RENO,NV who declined to investigate. Said it was my responsibility even though vehicle is under warranty. 8/27/2026 @ approximately 0830 while entering high traffic roadway with 55mph speed limit with foot depressed on gas pedal transmission completely stalled while traffic rapidly approached. Transmission engaged at last minute before rear end impact.
No injuries · No fire · No crash