General Motors, LLC (GM) is recalling certain 2025 Chevrolet Blazer, Blazer EV, and Equinox vehicles. The door strikers were not properly heat-treated, which can cause them to break.
3 Times, while travelling at highway speeds, infotainment module and driver display went dark for at least 3 minutes. While in this state, there were no visual controls such as speed, turn signals, etc. - the entire dashboard was dark. Recurring codes are: U11FD(00) Raw code: D1FD00 ECU: 40[Archive (inactive)] Status: Confirmed, Test failed since last DTC clear
No injuries · No fire · No crash
The contact owns a 2025 Chevrolet Blazer. The contact stated that the Forward Collision Avoidance system had erroneously activated on several occasions. While driving very slowly, the braking system suddenly activated while leaving a dealer. Additionally, while driving approximately 30 MPH, the braking system erroneously activated, causing the vehicle to abruptly stop. The automatic braking system was turned off, and the vehicle was later driven to the local dealer. The local dealer was unable to determine the cause of the failure and advised to deactivate the Collision Avoidance System. The contact sustained a neck injury during the failure while seated in the driver’s side rear seat. Medical attention was required. The failure mileage was 7,000.
I was going to park in a parking lot, when my car suddenly accelerated rapidly crashing into the building.
windshield leaking water inside of drivers compartment, headliner & side pillars (causing stained areas) as well as the top of onstar and electrical buttons on the overhead console . Found wet cup holder. Vehicle does not have a sun roof. GM is aware of this issue from the factory GM plant in Ramos Arizpe, Mexico. This defect is because of lack of not being sealed properly during the assembly process. The windshield has a factory OEM rubber seal attached to a NEW windshield. This rubber seal is NOT a part that can be purchased separately to fix the problem. By replacing the entire windshield with the new factory rubber seal and the channel that the entire windshield fits into is resealed with urethane should fix the issue.. Trying to reuse the current windshield & rubber seal and using sealer to reinstall it stretches out the rubber seal & will still leak. This leak can get into the electrical controls for safety system overhead controls. Extra care must be taken to remove the windshield as to not damage the roof line in anyway. Vehicle is going back into dealership to fix issue again. Vehicle was resealed with existing windshield and showing signs of leaking on L&R pillars.
No injuries · No fire · No crash
Complete and total failure of the telematics module resulting in loss of self driving, onstar, WiFi, gps, and all connected services. Severe battery drain due to module forcing the vehicle to completely shut down while driving, resulting in loss of power steering and brakes.
No injuries · No fire · No crash