The contact owns a 2018 Cadillac XT5. The contact stated that during a scheduled routine maintenance, the independent mechanic informed the contact that front driver's side CV axle was fractured and leaking grease and needed to be replaced. However, the part was on a national backorder. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 114,000.
No injuries · No fire · No crash
Check engine light sensor came on in mid-May which is the result of a faulty thermostat, also triggering a "Steering Assist is Reduced" message on the dashboard which I consider to be a safety issue. This is a known and common problem for this make, year and model and the cost to fix the problem is very expensive. This issue has been reported by many Cadillac owners on their forum. My mechanic confirmed the problem with the thermostat caused the steering assist is reduced message, along with the air conditioning malfunctioning.
No injuries · No fire · No crash
Thermostat failure causes steering assist to be reduced. This leaves more difficult steering especially in an emergency situation, thus a safety concern. The vehicle displays a warning: "Steering Assist Is Reduced, Drive with care". An internet search shows this is a well-known problem across all General Motor vehicles. This is also indicated by the technician notes on my repair invoice that a bulletin from the manufacturer has been issued. After restart the warning clears leaving the driver to believe all is well. After a number of miles it reappears.
No injuries · No fire · No crash
My windshield has a lot of spider and has never been hit with anything. They spread from the bottom up
No injuries · No fire · No crash
While driving at highway speeds, I needed to accelerate hard in order to pass another vehicle and while accelerating there was a downshift and increase in RPM. After passing, the RPM remained high even after I took foot off accelerator and it seemed the transmission did not shift back out of lower gear, keeping the car traveling at a high rate of speed, endangering myself and other traffic. Applying the brakes would not cause the engine to slow down and the engine kept working hard and traveling fast, causing strain on the brakes to slow down. I pulled over and initially shifted to neutral, but the engine was still revving high (4000 rpm observed). Then I placed the car in park which did not change the high RPM. Then I shut off engine and let it rest. Then I turned auto back on and all was normal. The problem has not yet been reported to dealer but will occur in coming days. There were no prior symptoms, problems, or warning lights on dash display prior to this occurring.
No injuries · No fire · No crash