Chevrolet · Model Report
Showing safety data for the 2011 model year only.
General Motors is recalling certain model year 2010-2012 Chevrolet Colorado and GMC Canyon vehicles manufactured from November 9, 2009, through August 28, 2012, for failing to comply with the requirements of Federal Motor Vehicle Safety Standard No. 113, "Hood Latch System." The hood may be missing the secondary hood latch.
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON PASSENGER VEHICLES EQUIPPED WITH A 2.9 OR 3.7 LITER ENGINE AND A FOUR-SPEED AUTOMATIC TRANSMISSION FOR FAILING TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." THESE VEHICLES MAY HAVE BEEN BUILT WITH AN AUTOMATIC TRANSMISSION ADJUSTMENT CLIP THAT MAY NOT RETAIN THE SHIFT CABLE IN THE CORRECT POSITION. IF THE SHIFT CABLE IS NOT IN THE CORRECT POSITION, THE PRNDL SHIFT LEVER MAY NOT ACCURATELY REFLECT THE POSITION OF THE TRANSMISSION GEAR. THE DRIVER COULD MOVE THE SHIFTER TO "PARK" AND REMOVE THE IGNITION KEY, BUT THE TRANSMISSION GEAR MAY NOT BE IN "PARK."
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON VEHICLES MANUFACTURED FROM SEPTEMBER 22, 2010, THROUGH NOVEMBER 5, 2010. SOME OF THESE VEHICLES HAVE THE CONDITION IN WHICH THE WINDSHIELD WIPER MOTOR CRANK ARM NUT MAY NOT BE TIGHTENED TO SPECIFICATION. WHEN THE WIPERS ARE OPERATED WITH A BUILD-UP OF SNOW OR ICE, OR IF THE WIPERS ARE OPERATED ON A DRY WINDSHIELD, THE NUT COULD LOOSEN. IF THERE IS SUFFICIENT LOOSENING OF THE NUT, THE WIPERS COULD BECOME INOPERATIVE.
GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, COLORADO, EXPRESS, SILVERADO, SUBURBAN, TAHOE; AND GMC CANYON, SIERRA, SAVANA, YUKON AND YUKON XL VEHICLES. THE REAR AXLE CROSS PINS WERE NOT PROPERLY HEAT TREATED AND COULD FRACTURE AND BECOME DISPLACED WITHIN THE REAR AXLE. SHOULD THE PIN SHIFT OUT OF POSITION, IT COULD CREATE AN INTERFERENCE CONDITION AND CAUSE THE REAR AXLE TO LOCK.
GM IS RECALLING CERTAIN MODEL YEAR 2004-2011, CHEVROLET COLORADO, GMC CANYON, MODEL YEAR 2006, ISUZU I-280/I-350, AND MODEL YEAR 2007-2008, I-290/I-370, REGULAR CAB VEHICLES AND EXTENDED CAB VEHICLES WITHOUT A REAR SEAT AND EQUIPPED WITH A FRONT 60/40 SPLIT BENCH SEAT. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEMS." THE TOP TETHER ANCHOR FOR THE FRONT CENTER SEAT IS NOT ACCESSIBLE AND THE OWNER MANUAL DOES NOT INCLUDE INSTRUCTIONS REGARDING HOW TO USE THE TOP TETHER.
Excessive frame corrosion that has caused the bed of the truck to touch the cab which has made me apprehensive to drive it. The truck has ROT holes on the bottom sections of the frame where water collects. The truck is available for inspection upon request at any time. The problem has not been inspected by a dealer, independent service center, vehicle manufacturer, police or insurance representative. However, I have 40 years experience of being an automobile technician and am qualified to make the above claims. Thank you for your assistance.
No injuries · No fire · No crash
The vehicle has an electronic issue where it does not recognize the original key to the car. It does not let you start the vehicle. There is a bad sensor in the ignition lock housing unit located where the key is inserted into the vehicle. This issue will nit let the driver start the car and the problem happens at random. For me it is 1 out of 20 times i try to start my vehicle it does not start due to this issue. This is a dangerous situation for me, as I live in a cold weather state in the US. I have been left stranded dozens of times because the car doesn’t recognize the key. If you search “chevy colorado passlock” hundreds of videos will come up, each video with thousands of views (from users like myself). GM charges hundreds to fix the issue. It is a well known issue with this vehicle. I fixed the issue myself. I replaced the faulty sensor and the issue is gone.
No injuries · No fire · No crash
The drivers-side airbag indicator light remains on. The light warns that the airbag is not working. This is the third time it has happened, first at 89,000 miles, then at 111,000 miles, and now at 133,000 miles. Previous repairs were for broken wires in the wire harness to the extended cab rear door. Wiring in the harness for the airbag is related to the seat belt tensioner. This is a defect that was reported to NHTSA by several others, some of whom were injured in accidents. The repair is costly; the dealer charged around $400.
No injuries · No fire · No crash
Frame is rusted through/broken in same spot on both sides. Bed of truck is flipping up and there is no gap left between the bed of the truck and the cab at the top but there is 1.5 inch gap at bottom of bed/cab. The truck only has 56,000 miles and I have only put 26,000 miles on it since I bought it in 2017.
No injuries · No fire · No crash
Brake lights will not come on. There is no fuse and lights are new. Many people have reported this as a problem. Has something to do with some switch that the dealer must replace. I have driver nearly 2000 miles this month without any idea the brake lights were not working until I could not get the cruise control to work. After some research it was discovered the cruise control is associated with the switch
No injuries · No fire · No crash