Audi A8 Service Bulletins (2013)
1,506 manufacturer communications on file.
- July 1, 2014•Document ID: 10226532Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- 371433202930510
- Date Added:
- November 21, 2022
- Manufacturer:
- AUDI
SummaryHarsh downshifts when braking or harsh 1-2 upshift under acceleration
Associated Products (7)Associated Documents - July 1, 2014•Document ID: 10210683Service Bulletin/Repair InstructionsPOWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE:SOFTWARE; UNKNOWN OR OTHER; ELECTRICAL SYSTEM:IGNITION; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL
- Mfr Comm. #:
- 37 14 34 2028985
- Date Added:
- May 2, 2022
- Manufacturer:
- AUDI
SummaryTransmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
Associated Products (18)Associated Documents - July 1, 2014•Document ID: 10210682Service Bulletin/Repair InstructionsPOWER TRAIN; ENGINE; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE:SOFTWARE
- Mfr Comm. #:
- 37 14 33 2029305
- Date Added:
- May 2, 2022
- Manufacturer:
- AUDI
SummaryFurther transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
Associated Products (8)Associated Documents - July 1, 2014•Document ID: 10122534Service Bulletin/Repair InstructionsPOWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)
- Mfr Comm. #:
- A371434 2028985-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 37 number 14-22 dated May 1, 2014. Transmission warning may appear in instrument cluster. After ignition cycle, the warning message is no longer present. DTC P074100 (Torque Converter Clutch Circuit Performance) or ?Stuck Off? is stored in transmission control module (TCM). The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
Associated Products (17)Associated Documents - July 1, 2014•Document ID: 10122533Service Bulletin/Repair InstructionsPOWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)
- Mfr Comm. #:
- A371433 2029305-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 37 number 13-96 dated March 4, 2013. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration. Further transmission control module (TCM), J217 (address word 02), software calibration to improve shift concerns.
Associated Products (8)Associated Documents - June 30, 2014•Document ID: 10228296Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 00146420355812
- Date Added:
- January 3, 2023
- Manufacturer:
- AUDI
SummaryAlthough the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
Associated Products (4)Associated Documents - June 30, 2014•Document ID: 10224975Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION: OIL COOLER
- Mfr Comm. #:
- 00146420355812
- Date Added:
- October 31, 2022
- Manufacturer:
- AUDI
SummaryAlthough the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
Associated Products (4)Associated Documents - June 30, 2014•Document ID: 10221948Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 00146420355812
- Date Added:
- September 26, 2022
- Manufacturer:
- AUDI
SummaryAlthough the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
Associated Products (4)Associated Documents - June 30, 2014•Document ID: 10231130Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING:COOLING SYSTEM
- Mfr Comm. #:
- Edition92
- Date Added:
- February 6, 2023
- Manufacturer:
- AUDI
SummaryIdenifying and mixing factory fill engine coolants
Associated Products (282)Associated Documents - June 30, 2014•Document ID: 10122412Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- A001464 2035581-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 00 number 13-55 dated October 21, 2013. Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to a W12 engine, the increased oil flow rate forces oil into the intake manifold or combustion chamber and damages the engine.
Associated Products (4)Associated Documents - June 26, 2014•Document ID: 10216685Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 143420350735
- Date Added:
- August 1, 2022
- Manufacturer:
- AUDI
SummaryThe NVLD pressure switch may erroneously detect a very small leak.
Associated Products (16)Associated Documents - June 26, 2014•Document ID: 10122416Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- A201434 2035073-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 20 number 14-32 dated March 21, 2014. The MIL is on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected. The NVLD pressure switch may erroneously detect a very small leak.
Associated Products (16)Associated Documents - June 20, 2014•Document ID: 10122415Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- A191450 2025303-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 19 number 13-41 dated June 20, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
Associated Products (226)Associated Documents - June 16, 2014•Document ID: 10231128Service Bulletin/Repair InstructionsEQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
- Mfr Comm. #:
- Edition90
- Date Added:
- February 6, 2023
- Manufacturer:
- AUDI
SummaryTechnical bulletins and updates
Associated Products (43)Associated Documents - June 10, 2014•Document ID: 10242631Service Bulletin/Repair InstructionsUNKNOWN OR OTHER; STRUCTURE:BODY:TAILGATE
- Mfr Comm. #:
- SM552014
- Date Added:
- September 25, 2023
- Manufacturer:
- AUDI
SummaryDrive Unit
Associated Products (3)Associated Documents - June 9, 2014•Document ID: 10231127Service Bulletin/Repair InstructionsEQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- Edition89
- Date Added:
- February 6, 2023
- Manufacturer:
- AUDI
SummaryElsaPro Software update and technical bulletins
Associated Products (270)Associated Documents - June 2, 2014•Document ID: 10066351Service Bulletin/Repair InstructionsSEATS; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- 2035757/3
- Date Added:
- May 19, 2016
- Manufacturer:
- AUDI
SummarySUMMARY TO BE PROVIDED ON A FUTURE DATE.
Associated Products (7)Associated Documents - June 2, 2014•Document ID: 10122421Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; SEATS
- Mfr Comm. #:
- A741420 2035757-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 74 number 14-17 dated February 21, 2014. Customer may complain that the seat pneumatics (side bolsters and lumbar support) actuate without any input from the customer. This condition can occur when the vehicle is driven at high altitudes or when the outside temperature fluctuates. DTCs may be present in the front seat pneumatics control modules, J873 and J872 (address words 88 and 89) or in the rear seat pneumatics control modules (in certain A8 models only), J875 and J874 (address words 8A and 8D). No leak is present. There is a software issue in the seat pneumatics control modules that causes the seat pneumatics to automatically actuate in high altitudes (change in air pressure) or in fluctuating temperatures in order to maintain pressure.
Associated Products (7)Associated Documents - May 29, 2014•Document ID: 10212703Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- 37 13 07 2033658
- Date Added:
- May 31, 2022
- Manufacturer:
- AUDI
SummaryVehicle lacks power or will not move after stop due to simultaneous depressing of the brake and accelerator pedals
Associated Products (223)Associated Documents - May 28, 2014•Document ID: 10228295Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 00146320335762
- Date Added:
- January 3, 2023
- Manufacturer:
- AUDI
SummaryAlthough the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
Associated Products (189)Associated Documents