GMC Yukon XL Complaints (2021)

230 consumer complaints on file.

#11774053October 27, 2026
ELECTRICAL SYSTEM, ENGINE, FUEL/PROPULSION SYSTEM
**Mileage at repair:** 76,165 miles **Component:** Fuel Pump Power Control Module While driving my 2021 GMC Yukon XL on [XXX] on a treacherous stretch decending [XXX] the engine unexpectedly stopped running, resulting in a complete loss of propulsion. This occurred on a section of interstate where there was no safe shoulder or suitable location to pull off the roadway. The unexpected failure created an extremely dangerous situation, exposing me and other motorists to the risk of a serious collision. The vehicle was subsequently towed, diagnosed and repaired by Darrell Waltrip Buick GMC in [XXX]. The dealership documented diagnostic trouble code P129F, "Fuel Pump Driver Control Module Fuel Pump Speed Signal Incorrect." The technician verified that the control module had proper electrical power, that there was no pin damage or connector fitment issue, and that the module required replacement. The dealership's written diagnosis specifically acknowledges that a failing fuel pump driver module can cause the engine to shut down. The original factory-installed module was replaced with GM part number 13554821, and the vehicle was subsequently tested and confirmed to operate correctly. The repair was performed at no charge, and GM provided a loaner vehicle while the replacement part was unavailable. I am particularly concerned that General Motors has previously acknowledged this same type of safety hazard under NHTSA Safety Recall 21V-739 (GM N212332040), involving fuel pump power control modules on certain 2021 GM full-size SUVs. That recall identifies unexpected engine stalling and increased crash risk as consequences of module failure. My experience demonstrates the potentially catastrophic consequences of this failure in actual highway operation. I request that NHTSA investigate whether a mandatory recall and replacement of these defective components is necessary as the consequences of immediate complete unexpected loss of propulsion. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11771151October 14, 2026
ENGINE
High oil consumption, will have oil changed and days later need oil, catalyst converter failed causing what was said for the check engine light to come on, truck now has a shutter around 50 mph, my radio is in and out, and sometimes it sounds like a computer shutting down. It has been one thing after the next.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11771244October 14, 2026
ENGINE
On September 21, 2026, my 2021 GMC Yukon XL Denali with the 6.2L V8 engine experienced a serious engine failure at approximately 83,330 miles while traveling on Interstate 10 near Litchfield Road in Arizona. The vehicle developed engine knocking and subsequently stalled, leaving my family and me at risk on the highway. This was a serious safety concern because the engine failed unexpectedly during operation. The GMC dealership determined that the engine needed to be replaced under warranty. The replacement engine was installed in October 2026, and I received the vehicle back on October 13, 2026. My concern is that the dealership installed a remanufactured engine, and I have not received sufficient documentation confirming whether the replacement addresses the underlying defect associated with the GM 6.2L engine failures. I am concerned about the possibility of another catastrophic engine failure, particularly while traveling at highway speeds with my family. I am requesting that NHTSA investigate this engine failure and determine whether the replacement engine adequately addresses the safety defect. I believe these failures present a serious risk to drivers, passengers, and other motorists.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11768123September 30, 2026
POWER TRAIN
Rear wheel lock up for a slight second and then down shifted and revved way up to high RPM then went into reduced power. then slowed down and had to drive about 15 miles an hour. to shop mechanic.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11767641September 29, 2026
ENGINE
The vehicle is consuming every bit of oil at about 1500 to 1800 miles of the 3000 mile guidelines before the next oil change. No leaks. No smoke. No knocking in motor.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11766052September 22, 2026
POWER TRAIN
While driving the vehicle on a roadtrip in Missouri, the engine lost power and had a flashing check engine light. Upon diagnosis by three different technicians, the 6.2L Engine needs replaced after only 123000 miles. The lifters and camshaft have failed. This is a known safety issue and numerous recalls have been implemented, but my high end Denali is mysteriously absent from the recall. This is unsafe and unsatisfactory.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11766090September 22, 2026
FUEL/PROPULSION SYSTEM
part number 13554821 fuel pump control module has failed 2 times. April 2023 on Interstate 95 near Savannah GA in very busy traffic. Vehicle buckled and seized, just barely made it to the shoulder of the road. Same part failed again 9/18/26 while turning onto Sunrise Hwy in NY another very dangerous situation as we were stranded in the middle of a very busy intersection
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11765500September 19, 2026
ENGINE
Engine coolant control valve has failed three times. This last time so severely the car forced me to come to a complete stop in the middle of a busy street. Dangerous to drive while severe reduced acceleration is all that’s available during the episodes.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11765506September 19, 2026
FUEL/PROPULSION SYSTEM
6.2L engine has the oil change update, and engine failed recently. took vehicle for repair to Golling GMC dealer. waiting on feedback.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11765236September 18, 2026
ENGINE
Vehicle has been consuming engine oil at a rate of approximately 1 quart per 500 miles. On XXX, owner added 1 quart of oil in [XXX], then drove a round trip to [XXX] and back (approx. 860 miles). On XXX at 55,329 miles — only 9 days and roughly 860 miles after that quart was added — an oil change was performed at an independent shop; the technician noted no oil was present on the dipstick prior to service. On XXX at 55,829 miles — exactly 500 miles later — the vehicle was taken to an authorized GMC dealership, and the dipstick again showed no oil prior to service. The dealer began the manufacturer's oil consumption test protocol, performing an oil and filter change and other maintenance. Within approximately 74 miles of this service (current mileage 55,903), the engine began making an audible knocking noise. Oil level was checked and confirmed full/normal, ruling out low oil as the cause. The knock has been intermittent — not present at cold idle start, but returning during driving conditions, raising concern about potential engine failure or loss of power while driving. They can not get it back in till XXX. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11764288September 15, 2026
ENGINE
The rod bearing failed while traveling at highway speeds, so yes our safety as well as others traveling on the interstate. It is available for inspection. A dealership inspected and confirmed the reported problem. The manufacturer is aware of the persistent problems with these vehicles' engine components, reliability and safety. There were not any symptoms, warning lights, etc. prior to failure. I had just purchased the vehicle and it was inspected by two independent mechanics prior to failure. I have contacted the manufacture to find that my VIN was not covered under the recall. The recall covers vehicles manufactured starting 3/1/2021, my vehicle was manufactured 10/2020. THE RECALL SHOULD BE EXPANDED TO COVER ALL OF THESE VEHICLES.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11764136September 14, 2026
ENGINE, FUEL/PROPULSION SYSTEM
According to the GM Dealership the rod bearing failed disabling the engine. Dealer recommends replacing the entire engine. This consistent with recall N 252494000-N252494003 but my VIN is not included in the recall. Estimated repair $11,200. Our family was traveling roughly 55 mph on the interstate at the time of incident.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11763845September 12, 2026
ENGINE
The engine failed, shop confirmed and replaced motor. No warning lamps on dash.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11763260September 10, 2026
ENGINE
My 2021 GMC Yukon XL Denali with the 6.2L L87 V8 has experienced two significant lifter/valvetrain failures. The first occurred at approximately 6,500 miles and was repaired by a GMC dealer. That failure involved cylinder #4, including a collapsed/stuck lifter and bent pushrod. The current failure occurred at approximately 110,269 miles. The vehicle initially operated normally. While traveling about 10 mph and approaching a major thoroughfare, the engine suddenly began making a loud knocking noise and the vehicle began shaking violently. There were no warning lights or other symptoms beforehand. Three children were in the vehicle. When the driver attempted to accelerate, the vehicle failed to gain speed normally, and additional accelerator input made the knocking and shaking significantly worse. The check-engine light began flashing, and “Service ESC” and “Service Traction Control” warnings appeared, along with multiple other warning lights. The engine continued running. The driver made a U-turn before entering the major roadway and drove about 0.2 miles very slowly back home. An independent repair facility diagnosed P0305, cylinder #5 misfire. Moving the ignition coil and spark plug did not move the misfire, and the #5 spark plug was oil-soaked. A GMC dealer later confirmed a stuck lifter on cylinder #5 and advised that the failed lifter damaged the camshaft. My concern is the sudden loss of normal acceleration and severe engine malfunction without warning, especially because this same L87 engine previously suffered a major lifter failure at low mileage. I am asking NHTSA to determine whether repeated L87 lifter/valvetrain failures represent an additional safety-related defect or failure pattern.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11763520September 10, 2026
ENGINE
I own a 2021 GMC Yukon XL Denali equipped with the 6.2L L87 V8 engine. On September 10, 2026, we checked the engine oil and discovered that it was approximately two-thirds low. Mechanical inspection confirmed that the engine is consuming and burning oil internally rather than losing it through an external leak. The vehicle’s last oil change was performed in May 2026, and it is still more than 1,000 miles away from its next scheduled oil change. The vehicle provided no low-oil, low-oil-pressure, check-engine, or other dashboard warning, despite being severely low on oil and having its alerts enabled. I had no indication that the engine was operating with an unsafe amount of oil. I am concerned that the continued internal oil consumption could cause premature engine damage, engine seizure, or sudden loss of propulsion without adequate warning. I regularly use this vehicle to transport my young children. My VIN is not currently included in Recall 25V-274, although my vehicle has the same model year and 6.2L L87 engine involved in the ongoing NHTSA investigation. I am reporting this confirmed internal oil consumption and lack of driver warning so that problems occurring in currently excluded vehicles can be properly documented and investigated.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11762576September 7, 2026
ENGINE
I purchased this vehicle 06/14/2026 The vehicle dash started lighting up like a Christmas tree. It was taken to GM Ed Morse Freedom Chevrolet X 3 separate occasions. The lights in the dash were intermittent. Dealership couldn't duplicate the issue. I was told if they aren't active they can't duplicate. The vehicle continued to illuminate on and off after it was returned July 26th. Then August 23 i was driving and it died right in the highway putting me in a bad spot in traffic. I. There was no illuminated symbols in the dash it just died as the symbols them lit up in the dash. I had it towed by AAA thinking just a battery or starter. I was told by GM dealership the engine seized. Propulsion, metal in the oil and the crankshaft failure. The exact recall problem. My Vin fell just outside of GM internal N252494003 program of 150,000 10 year extended warranty. I have 114, 689. 2021 yukon Denali. THE exact engine failure GM put out. GM is refusing to replace the engine. The engine has been torn down. I received pictures of my claim above. It's still at GM . I've opened a corporate GM case. I'm hitting a brick wall
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11762580September 7, 2026
ENGINE
We had to have an engine replaced because of engine failure. The new engine was provided by GMC free of charge. The second engine also failed and was also replaced by GMC.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11761201September 1, 2026
ENGINE
Our 2021 YukonXL started running rough and the check engine light came on. We took it to the shop the next day and was told there was complete lifter failure and that we need a new engine.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11761330September 1, 2026
ENGINE, POWER TRAIN
Vehicle is equipped with the 6.2L L87 V8 engine. Prior to receiving the dealer service for Recall 25V-274, the vehicle experienced a distinct highway vibration, powertrain shudder, and fluctuating/jumping RPMs on the highway. The dealer subsequently performed the recall remedy by updating the vehicle to the thicker 0W-40 oil specification. However, the underlying transmission torque converter had already suffered catastrophic failure due to the powertrain stress/shudder and required a complete transmission replacement at 84,000 miles. I am reporting this because the initial 6.2L engine defect and subsequent recall remedy overlap heavily with severe powertrain and torque converter failures at low mileage
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11761076August 31, 2026
ENGINE
the engine started knocking and vehicle shaking while on interstate. vehicle was towed to service center and they determined that one valve was stuck and another one turned 90 degrees and the cam shaft was also ruined. It was required to replace the engine as that was a less costly option than replacing the damaged parts. A dash light came on and was flashing while my daughter was driving it to [XXX]. The vehicle was towed from the parking lot they were at when reaching [XXX]. Unsure of where the engine went to after the service center removed it, but I think they had to send it back to GM. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0

← Back to GMC Yukon XL