Freightliner · Model Report
Showing safety data for the 2012 model year only.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2012-2018 Mercedes Benz Sprinter 3500 and Freightliner Sprinter 3500 vehicles upfitted into campers or recreational vehicles. The Electronic Stability Control (ESC) unit may become disabled on these vehicles.
Daimler Vans USA, LLC (DVUSA) is recalling certain 2012 Freightliner and Mercedes Benz Sprinter 2500 and 3500 vehicles. These vehicles are equipped with certain air bag inflators assembled into the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
Daimler Vans USA, LLC (Daimler Vans) is recalling certain model year 2007-2009 Dodge Sprinter 2500 and 3500 vehicles manufactured July 1, 2006, to July 31, 2008, 2007-2014 Freightliner Sprinter 2500 and 3500 vehicles manufactured July 1, 2006, to July 1, 2014, and 2010-2014 Mercedes Benz Sprinter 2500 and 3500 vehicles manufactured July 1, 2010, to July 1, 2014. Upon deployment of the driver's frontal air bag, excessive internal pressure may cause the inflator to rupture.
THE VEHICLE DASH BOARD HAD 4 {ECM, ABS, TRACTION AND SKID} LIGHTS, REDUCED SPEED TO 20MPH ON THE HIGHWAY RPM INCREASED OVER 3000 LOST ABILITY FOR ABS, STEARING CONTROL AND SPEED. CHECK ENGINE LIGHTS P003A AND P0037 POINTING TO BOTH REAR WHEEL SPEED SONSORS.
No injuries · No fire · No crash
ABS SPEED SENSOR, TRACTION REAR SPEED SENSOR FAULT CODE C0037 AND C003A. SPEED REDUCES TO 20MPH HIGH ENGINE RPM REV OVER 3000 RPM
No injuries · No fire · No crash
I NEED TO KNOW IF THE RECALL FOR THE DRIVER SIDE AIR BAG WAS IN EFFECT BECAUSE THIS IS SOMETHING VERY SERIOUS. MY HUSBAND DRIVES THIS VEHICLE EVERYDAY AND I WOULDN'T WANT A DEPOLYMENT OF THE BAG DUE TO A RUPTURE AND HE WOULD BE HURT. HOW DO I FIND OUT IF IT WAS DONE? I READ ABOUT THIS ON A TELEVISION INVESTIGATION AND IT MAKES ME NERVOUS.
No injuries · No fire · No crash
LOCATION OF CRUISE CONTROL ARM IS TOO CLOSE TO THE STEERING WHEEL AND TURN SIGNAL ARM. ACCIDENTAL ACTIVATION IS LIKELY AND HAS OCCURRED DURING NORMAL OPERATION OF THE VEHICLE BY EITHER ACCIDENTAL CONTACT OF THE LEFT HAND WHILE STEERING OR WHILE ATTEMPTING TO OPERATE THE TURN SIGNAL. THIS CONDITION IS COMPOUNDED BY THE ORIENTATION OF THE CRUISE CONTROL ARM, WHERE AN UP OR DOWN MANIPULATION WILL 'SET' OR 'RESUME' THE CRUISE SPEED, BOTH OF WHICH CAN ACTIVATE THE CRUISE SYSTEM. SUCH MANIPULATION (UP OR DOWN) IS MOST LIKELY TO OCCUR DUE TO THE CONTROL ARM'S RELATIVE POSITION TO THE STEERING WHEEL AND TURN SIGNAL CONTROL ARM. THIS CONDITION IS FURTHER COMPOUNDED BY THE LACK OF ANY INDICATION TO THE DRIVER THAT THE CRUISE CONTROL SYSTEM IS ACTIVATED. THERE IS ALSO NO SEPARATE CRUISE CONTROL ENABLE SWITCH FOR THE DRIVER TO BE AWARE THAT THE CRUISE CONTROL SYSTEM MAY ACTIVATE. THE RESULT OF THIS CONDITION IS THAT THE DRIVER MAY ACCIDENTALLY AND UNKNOWINGLY ACTIVATE THE VEHICLE'S CRUISE CONTROL SYSTEM, RESULTING IN UNEXPECTED VEHICLE BEHAVIOR OR POSSIBLE LOSS OF CONTROL FROM UNEXPECTED ACCELERATION. RECOMMEND REPLACEMENT OF CRUISE CONTROL ARM WITH A DIFFERENT DESIGN TO MOVE IT AWAY FROM THE STEERING WHEEL AND TURN SIGNAL CONTROL ARM. ALTERNATIVELY, CHANGING THE SWITCH ORIENTATION SO THAT UP/DOWN MANIPULATION CAUSES THE CRUISE SETTING TO 'CANCEL', WHICH IS A SAFER UNINTENDED ACTION (DEACTIVATE) THAN THE CURRENT 'SET' ACTION (ACTIVATE). *TR
No injuries · No fire · No crash