Subaru · Model Report
Showing safety data for the 2006 model year only.
SUBARU IS RECALLING CERTAIN MODEL YEAR 2002-2007 IMPREZA, MODEL YEAR 2003-2008 FORESTER, AND MODEL YEAR 2005-2006 SAAB 9-2X VEHICLES MANUFACTURED FROM SEPTEMBER 5, 2000 THROUGH NOVEMBER 26, 2007 ORIGINALLY SOLD, OR CURRENTLY REGISTERED IN, MASSACHUSETTS, MARYLAND, MICHIGAN, NEW HAMPSHIRE, NEW YORK, PENNSYLVANIA, VERMONT, WISCONSIN, CONNECTICUT, DELAWARE, IOWA, ILLINOIS, INDIANA, MAINE, MINNESOTA, MISSOURI, NEW JERSEY, OHIO, RHODE ISLAND, WEST VIRGINIA AND THE DISTRICT OF COLUMBIA. THE FRONT LOWER CONTROL ARMS MAY BREAK AT THE HANGER BRACKETS DUE TO CORROSION IF THE HANGER BRACKET IS EXPOSED TO SALTY AND HUMID ENVIRONMENTS SUCH AS ROADS CONTAINING SNOW MELTING AGENT.
ON CERTAIN VEHICLES, THE WIRING HARNESS FOR THE AIR BAG OCCUPANT DETECTION SYSTEM IN THE FRONT PASSENGER SEAT MAY HAVE BEEN PINCHED DURING PRODUCTION. PINCHING OF THE WIRING HARNESS BETWEEN THE FLOOR CROSSMEMBER AND THE SEAT MOUNTING BRACKET COULD RESULT IN A SHORT CIRCUIT.
Front drivers side control arm broke at bracket point and lost control of vehicle steering. And car was damaged hitting a post. Vehicle per recall for control arm had already been “fixed” contacted Subaru if control arms were replaced under recall or the “rust proofing” applied.
The contact owns a 2006 Subaru Forester. The contact stated that upon purchase of the vehicle, he discovered that the vehicle was included in NHTSA Campaign Number: 11V464000 (Suspension). The contact then took the vehicle a dealer where he was informed that the recall was serviced. Less than two months later, the contact stated that while driving 60 MPH, the steering wheel began to shake as he began to lose control of the vehicle. There was no warning light illuminated. The contact used excessive force to steer the vehicle off to the highway shoulder. The contact inspected the vehicle and discovered that the front driver’s side lower control arm was fractured. The vehicle was towed to an independent mechanic where the contact discovered that no work was performed on the vehicle. The contact purchased the parts and replaced the control arm himself. The manufacturer was not notified of the failure. The vehicle was repaired. The failure mileage was approximately 189,000.
No injuries · No fire · No crash
Front control arm failed on car. Which snapped the front axle and sway bar link on right side. Found out it was a known issue that was taken care of by dealer. Waiting to see if they will cover repairs.
No injuries · No fire · No crash
It just the airbags light turn on
No injuries · No fire · No crash
I was made a turn at roughly 15mph and the front passenger side control arm sheared in half causing me to lose control of the vehicle and then abruptly come to an immediate stop. My family was in the car and at a higher speed this could have been fatal. Had there been any vehicles behind me that could have caused an accident with unknown results. Had this been moments early I would have been in a head on collision. This is a known issue for this year, make, and model that was not properly resolved in the past by the manufacturer. The part should not fail in that manner. There were no warnings. The failure was inspected by the tow truck driver.
No injuries · No fire · No crash