2022-2024 Toyota Camry Tapping/Ticking B-Pillar Noise TSB

Owners of 2022-2024 Toyota Camry and Camry Hybrid vehicles may notice a specific "tapping/ticking noise near the B-pillar area and seat belt anchor point". This condition is detailed in Toyota Technical Service Bulletin T-SB-0036-24, which outlines a repair procedure for this issue.

Symptoms

The primary symptom is a "tapping/ticking noise near the B-pillar area and seat belt anchor point" on either the driver's or passenger's side of the vehicle. This noise is typically heard when driving on non-smooth road conditions and tends to be more prevalent during warmer weather.

Diagnosis / Trigger Conditions

The condition is confirmed by the presence of the tapping/ticking noise near the B-pillar and seat belt anchor point. If the noise is not present, the bulletin does not apply, and further diagnosis would be required using the applicable Repair Manual. The noise is often triggered by non-smooth road surfaces and warmer ambient temperatures.

Repair Procedure Summary

The repair for the "Toyota Camry tapping ticking noise" involves accessing the B-pillar welds and reinforcing them. The procedure begins by confirming the noise and then disconnecting the 12V auxiliary battery for safety.

Technicians will then remove several interior components on the affected side, including the front and rear door scuff plates, the front and rear door opening weatherstrip trim from the B-pillar, and the lower and upper center pillar garnishes. These steps require careful reference to the Toyota Technical Information System (TIS) Repair Manual for specific instructions tailored to the 2022-2024 Camry and Camry Hybrid models.

Once the B-pillar is exposed, as shown in Figure 1 of the bulletin, a brass punch and hammer are used. The technician will strike specific welds on the B-pillar (as depicted in Figure 3) two times with moderate to firm force, as demonstrated in Figure 2. This action is intended to address the source of the tapping/ticking noise.

After striking the welds, the 12V auxiliary battery is reconnected, and the technician will confirm that the noise is no longer present. Finally, all removed weatherstrip, garnishes, and scuff plates are reinstalled, again following the detailed instructions in the TIS Repair Manual.

Required Tools or Parts

The primary tools required for this repair are a brass punch and a hammer. No specific part numbers are listed for replacement parts, as the repair focuses on reinforcing existing welds.

Owner Action

If your 2022-2024 Toyota Camry or Camry Hybrid exhibits a "tapping/ticking noise near the B-pillar area and seat belt anchor point", you should schedule an appointment with an authorized Toyota dealership. The repair, identified by OP Codes BD2407 and Combo A, is covered under the Toyota Basic Warranty. This warranty is valid for 36 months or 36,000 miles, whichever comes first, from the vehicle's in-service date. Warranty application is limited to the occurrence of the specified condition described in this bulletin.

NHTSA ID: 11003590