2023-2026 Jeep Compass Collision Warning Light TSB
A Technical Service Bulletin (TSB 08-364-25) has been issued for 2023-2026 Jeep Compass vehicles experiencing illuminated collision warning and lane-keeping lights, often accompanied by DTCs B178F-15 or B1051-15. The repair involves replacing the signal lever assembly.

También aplica a
- Jeep Compass
- 2023–2025
Important Market Applicability Note
It is crucial for owners in the United States to be aware that Technical Service Bulletin (TSB) 08-364-25 explicitly states that it applies to the South America market. This means that while the symptoms and repair described are relevant, this specific bulletin is not intended for vehicles sold in the US market. If you are experiencing these symptoms in a US-market vehicle, your dealer may need to refer to different diagnostic procedures or bulletins.
Symptoms
Owners of affected 2023-2026 Jeep Compass vehicles may experience a Malfunction Indicator Lamp (MIL) illuminating on the instrument cluster. The primary symptom is the illumination of the "collision warning light and lane-keeping light" on the Instrument Panel Cluster (IPC) specifically "when the steering wheel is turned." This indicates a potential issue with the vehicle's active safety systems. There are no other abnormal behaviors reported in the vehicle due to this concern, focusing solely on the warning lights and the associated diagnostic trouble codes.
Fault Codes / DTCs
When the "Jeep Compass collision warning light" or lane-keeping light illuminates, one or more of the following Diagnostic Trouble Codes (DTCs) may be set:
- B178F-15: Turn Signal Switch-circuit Short To Battery Or Open.
- B1051-15: Column Switch Module Turnlights - Circuit Short To Battery Or Open.
These codes point to an electrical issue within the turn signal switch or column switch module.
Diagnosis
To properly diagnose this concern, technicians are instructed to use a Scan Tool, such as wiTECH or an equivalent diagnostic system. They should follow the appropriate Diagnostic Procedures available in DealerCONNECT/Service Library to verify that all related systems are functioning as designed. If any DTCs or symptom conditions other than those described in TSB 08-364-25 are present, these should be recorded and addressed before proceeding with the bulletin's repair.
Repair Procedure Summary
The repair outlined in TSB 08-364-25 addresses the manufacturing issue causing the illuminated warning lights and associated DTCs. The procedure involves the following steps:
- Inspect Electrical Connectors: Technicians must first check the electrical connectors and terminations of both the turn signal lever and the Body Control Module (BCM). If these connections are found to be in compliance, the next step is to replace the signal lever.
- Replace Signal Lever Assembly: The faulty signal lever assembly is to be replaced. Detailed service procedures for this replacement can be found in the DealerCONNECT/Service Library under reference 5550A12 - Comando Indicadores de Direção - Remoção/Recolocação para Veículos com Air Bag.
- Clear DTCs: After the replacement is complete, all stored Diagnostic Trouble Codes must be cleared from the vehicle's system.
It is important to note that after applying this TSB, it is not necessary to send DID-I or DID-A data.
Required Tools or Parts
The primary part required for this repair is a new signal lever assembly. The specific part number varies depending on the vehicle model and whether it is equipped with a rain sensor:
- For 2025-2026 Jeep Compass (with Rain Sensor): Part No. 60986337 or 6XC86LXHAC (Turn Signal Lever / Chave De Seta)
- For 2023 Jeep Compass (with Rain Sensor): Part No. 60937587 or 6XC86LXHAA (Turn Signal Lever / Chave De Seta)
- For Jeep Compass (without Rain Sensor): Part No. 60986336 or 6XC85LXHAC (Turn Signal Lever / Chave De Seta)
Additionally, a wiTECH or equivalent scan tool is required for diagnosis and clearing DTCs.
Owner Action
If your 2023-2026 Jeep Compass is exhibiting the "Jeep Compass collision warning light" or lane-keeping light when turning the steering wheel, and you are in a market where this TSB applies (South America), you should contact your authorized service center. The repair is reimbursable within the provisions of the vehicle's warranty. The estimated labor time for this repair is 0.4 hours.
Source: NHTSA ID: 11025027
Galería
2 imágenes
Frequently Asked Questions
- What is TSB 08-364-25 about?
- TSB 08-364-25 addresses a manufacturing issue in certain 2023-2026 Jeep Compass vehicles that causes the collision warning and lane-keeping lights to illuminate when the steering wheel is turned, often accompanied by specific Diagnostic Trouble Codes (DTCs).
- What are the common symptoms of this issue in the Jeep Compass?
- The main symptoms include a Malfunction Indicator Lamp (MIL) illuminating and the 'collision warning light and lane-keeping light' appearing on the instrument cluster when the steering wheel is turned. There are no other reported abnormal vehicle behaviors related to this specific concern.
- Which DTCs are associated with the Jeep Compass collision warning light problem?
- The Diagnostic Trouble Codes (DTCs) commonly associated with this issue are B178F-15, indicating a Turn Signal Switch-circuit Short To Battery Or Open, and B1051-15, for Column Switch Module Turnlights - Circuit Short To Battery Or Open.
- How is this issue repaired according to the TSB?
- The repair involves inspecting the electrical connectors of the turn signal lever and Body Control Module (BCM). If these are compliant, the signal lever assembly is replaced, and then all stored DTCs are cleared from the vehicle's system.
- Does TSB 08-364-25 apply to Jeep Compass vehicles in the US market?
- No, TSB 08-364-25 explicitly states that it applies to the South America market. Owners in the US experiencing similar symptoms should consult their dealer for applicable diagnostic and repair information specific to their region.
Related Articles
2026 Jeep Compass ACC Module Update for DTC C14A4-00
Jeep has released TSB 08-158-26 for the 2026 Compass addressing issues with the Adaptive Cruise Control (ACC) module. Owners may see a Malfunction Indicator Lamp (MIL), DTC C14A4-00, or the message 'ACC/FCW Unavailable, Service Required'. A software update is the fix.
2026 Jeep Compass ACC Software Update TSB 08-153-26
This TSB addresses Adaptive Cruise Control (ACC) software issues in the 2026 Jeep Compass, which can cause Malfunction Indicator Lamp illumination, DTC C14A4-00, and 'ACC/FCW Unavailable, Service Required' messages. A software reprogramming resolves the issue.
2017-2026 Jeep Taillamp Condensation TSB 08-220-25
Jeep Technical Service Bulletin (TSB) 08-220-25 provides a procedure to clear condensation and fogging from rear taillamp assemblies in 2017-2026 Jeep Compass, Cherokee, Grand Cherokee, and Wagoneer vehicles, preventing unnecessary replacements.
2026 Jeep Compass Radar Alignment TSB 08-145-26
A Stellantis Technical Service Bulletin, TSB 08-145-26, addresses a corner radar dynamic alignment calibration issue in the 2026 Jeep Compass. Owners may see a Malfunction Indicator Lamp (MIL) and DTC B2EF9-78. The fix involves a software update and recalibration.
2026 Jeep Compass Steering Angle Sensor Fault U053B 81
Owners of the 2026 Jeep Compass (MW) may encounter warning messages like 'Lane Keeping Assistance' or 'Blind Spot Monitoring System' on their instrument cluster. These warnings are often linked to a steering wheel angle sensor fault (DTCs U053B 81, B2EF8 9E, U1205 81) and can occur after battery…
Leave a comment
Comments are moderated and may take a moment to appear. Only your first name and the initial of your last name are shown publicly.
Comments
Be the first to comment.