2024-2025 Jeep Compass Engine Won't Start TSB 14-008-25

Owners of certain 2024-2025 Jeep Compass vehicles may experience a condition where the Jeep Compass engine won't start. This issue is addressed by Technical Service Bulletin (TSB) 14-008-25, which has also been released as Rapid Service Update (RSU) 25-048. The bulletin, issued on March 29, 2025, points to low fuel pump pressure as the underlying cause, potentially necessitating the replacement of the fuel pump module.

This TSB applies to 2024-2026 Jeep Compass (M1) and RAM Rampage (N4) models equipped with a 2.0L I4 Turbo Diesel Engine (Sales Code EBT) or a 2.2L I4 FAMB Turbo Diesel Engine (Sales Code EBK). Specifically, it affects vehicles built on or after August 23, 2024 (MDH 0823XX) and on or before February 28, 2025 (MDH 0228XX).

Symptoms

The primary symptom customers may experience is that the "Engine will not start." This indicates a failure in the vehicle's fuel delivery system, preventing the engine from igniting.

Diagnosis and Trigger Conditions

If your 2024-2025 Jeep Compass engine won't start, technicians will first check your vehicle's VIN against the Rapid Service Update (RSU) VIN list or in the VIP system. If the VIN is listed, the repair procedure should be followed. However, even if a vehicle is not on the specific VIN list but exhibits the "Engine will not start" symptom, the repair procedure outlined in TSB 14-008-25 should still be performed.

Repair Procedure Summary

The repair procedure for a Jeep Compass engine won't start condition involves a diagnostic sequence to determine if the fuel pump module needs replacement. Initially, the technician will cycle the ignition on and off five times, with a six-second pause between each cycle. After this, an attempt will be made to start the vehicle.

If the engine starts, the bulletin is considered completed, and further diagnostics using Labor Operation Number (LOP) 14-50-01-9C (Fuel Pump - Inspect) will be performed. If the engine does not start, the ignition cycling and start attempt steps are repeated up to four times. If the engine still fails to start after these attempts, the fuel pump module will be replaced. The detailed service procedures for removing and replacing the fuel pump module can be found in the DealerCONNECT/Service Library under Service Info>1040A70 - Conjunto Bomba Submersa Completa de Comando Indicador de Nível de Combustivel (Elétrica) - Remoção/Recolocação.

Required Parts

Should a replacement be necessary, the following parts may be used:

• For Engine 2.0L: Module, Fuel Pump/Level Unit (Part No. 7098215 - EMEA / 68741586AA - NA)
• For Engine 2.2L: Module, Fuel Pump/Level Unit (Part No. 7098216 - EMEA / 68741585AA - NA)
• Common: Fuel Pump Joint (Part No. 7096922 - EMEA / 68727309AA - NA)

Important Warnings

It is important to note that this bulletin applies specifically to the Brazil and Argentina markets. For these markets, new parts requests will only be approved if the order is placed through the "Recall Order with VIN" screen in CSPS. This process must adhere to the Standard Procedure "00 - Request for campaign parts," as published in the Service Library.

Warranty Information

All repairs performed under TSB 14-008-25 are reimbursable within the provisions of the vehicle's warranty.

Source: NHTSA ID: 11016256