Nissan · Model Report
Showing safety data for the 2003 model year only.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
CERTAIN EAGLE EYES HEADLAMP ASSEMBLIES, P/NOS. DS517-B001L AND DS517-B001R, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. THE OPTICEL SURFACE OF THE REFLECTOR IS CORRODED INHIBITING THE PERFORMANCE OF THE UPPER AND LOWER BEAMS WHICH FAILS TO CONFORM TO THE PHOTOMETRIC REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN ANZO AFTERMARKET HEADLIGHTS, P/N 02-AZ-NA02-B-A, SOLD FOR USE ON 2002-2004 NISSAN ALTIMA VEHICLES. DURING PRODUCTION THE LAMP HOUSING SHAPE DEFORMED DISTORTING THE ASSEMBLY ANGLE OF THE REFLECTOR AND INFLUENCED THE AIMING POSITION. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN MAXZONE HEADLIGHT ASSEMBLIES, DEPO BRAND, P/NOS. 315-1145L-AS AND 315-1145R-AS, SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. DURING PRODUCTION THE LAMP REFLECTOR SHAPE DEFORMED CHANGING THE SHAPE OF THE OPTIC SURFACE. THIS WILL CHANGE THE OPPOSITE POSITION OF LOW BEAM AND HIGH BEAM OPTICSAND CHANGE THE ANGLE OF INCIDENCE AND ILLUMATED LOCATION WHICH FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN TRADESONIC COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
What component or system failed or malfunctioned, and is it available for inspection upon request? Engine will not start. If I get the engine to start the car may act as if it wants to cut off in traffic. How was your safety or the safety of others put at risk? Engine may stop while in traffic possibly resulting in someone hitting me in traffic. Has the problem been reproduced or confirmed by a dealer or independent service center? No the dealership service department are refusing to service or even inspect my car. At first he lied like there wasn’t a recall. Now because we are in MS he is refusing to provide service because we are not in a cold state. I called Nissan to verify this information prior to speaking with the dealership and Nissan specifically stated that for my VIN there is an open campaign for a fuel pump screen. Then they were the ones who referred me to the nearest dealership which is Gray Daniels Nissan North in Jackson. MS.
No injuries · No fire · No crash
Faulty crankshaft and camshaft sensors UNKOWN
No injuries · No fire · No crash
The contact owns a 2003 Nissan Altima. The contact stated that while driving 65-75 MPH, the sunroof detached from the vehicle. There were no reported injuries. There were no warning lights illuminated. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure however, no further assistance was provided. The approximate failure mileage was 177,000.
No injuries · No fire · No crash
The contact owns a 2003 Nissan Altima. The contact stated that while her son was driving approximately 45 MPH, the vehicle suddenly stalled and lost motive power. The vehicle had to be pushed to the side of the road and jump-started. There were no warning lights illuminated. The vehicle was taken to a certified mechanic who replaced the CAM Sensor. The contact stated a day later the vehicle stalled and shut-off. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the dealer. The approximate failure mileage was 187,000.
No injuries · No fire · No crash
The contact owns a 2003 Nissan Altima. The contact stated that while the vehicle was being repaired at an independent mechanic, the mechanic informed the contact that there was rusting on the front driver’s side floor pan. The contact also noticed that the front driver’s side floorboard was soft to the touch and a fuel odor was detected while driving at various speeds. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 87,000.
No injuries · No fire · No crash