Ford Motor Company (Ford) is recalling certain 2007-2011 Ranger, 2006-2012 Fusion, Lincoln Zephyr, Lincoln MKZ, 2006-2011 Mercury Milan, 2007-2010 Ford Edge, and Lincoln MKX vehicles. The driver's side air bag inflator may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.
Ford Motor Company (Ford) is recalling certain 2005-2014 Mustang, 2004-2011 Ranger, 2009-2011 Mercury Milan, 2006 Ford GT, 2008-2012 Fusion, 2007-2010 Edge and Lincoln MKX, and 2009-2010 Lincoln MKZ vehicles. These vehicles may be equipped with a driver or passenger frontal air bag inflator used as a replacement service part, that may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.
Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.
Ford Motor Company (Ford) is recalling certain 2013 Ford Mustang vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, Ford is recalling certain 2010 Ford Edge, Fusion, Mustang and Ranger, Lincoln MKX and Zephyr/MKZ, and Mercury Milan vehicles ever registered in the states of Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia or "Zone B." Ford is also recalling certain 2009 Ford Edge, Fusion, Mustang and Ranger, Lincoln MKX and Zephyr/MKZ, and Mercury Milan vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with air bag inflators assembled as part of the passenger frontal air bag modules, used as original equipment or replacement equipment (such as after a vehicle crash necessitating replacement of the original air bags), that may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.
Ford Motor Company (Ford) is recalling certain 2012 Ford Fusion and Mustang and Lincoln Zephyr and MKZ vehicles originally sold, or ever registered, in Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Ford is recalling certain 2009 Ford Ranger, Edge, Fusion and Mustang, Lincoln MKX, MKZ and Zephyr and Mercury Milan vehicles originally sold, or ever registered, in Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia and West Virginia, or "Zone B." Additionally, unless included in "Zone A" or "Zone B" above, Ford is recalling certain 2007-2008 Ford Ranger, Edge and Lincoln MKX, 2006-2008 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ, 2005-2008 Ford Mustang and 2005-2006 Ford GT vehicles originally sold, or ever registered, in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
The contact owns a 2009 Mercury Milan. The contact stated while driving at an undisclosed speed, the brake pedal was depressed and traveled to the floorboard. There was no warning light illuminated. The contact engaged the parking brake to stop the vehicle. The vehicle was restarted. The vehicle was taken to the dealer where it was diagnosed and determined that the ABS hydraulic control unit had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and confirmed that the VIN was not included in NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic). The approximate failure mileage was 100,000.
No injuries · No fire · No crash
Check engine light airbag light brake light on my car they turned them off and they turned on right after
No injuries · No fire · No crash
I RECEIVED A LETTER IN JULY OF 2021 ABOUT THE ABS CONTROL UNIT PROBLEM MY VEHICLE HAS. AT THE MOMENT THAT CONTROL MODULE IS NON-FUNCTIONAL. TO DATE FORD HAS NOT PRODUCED OR MADE AVAILABLE ANY OF THE PARTS NEEDED FOR THIS REPAIR AND WILL NOT EVEN ACKNOWLEDGE THE VEHICLE WHEN I CALLED THEM. I WOULD LIKE TO KNOW HOW LONG I HAVE TO DRIVE A VEHICLE WITH KNOWN DEFECTIVE BRAKES BEFORE FORD IS FORCED TO COMPLETE THIS REPAIR? THERE IS ALSO A BRAKE FLUID ISSUE WITH THIS VEHICLE THAT CANNOT BE ADDRESSED UNTIL THE NON-FUNCTIONING ABS MODULE IS REPAIRED. THE DEALER REFUSED TO CHANGE THE SAID CORROSIVE FLUID BECAUSE OF THE NON-FUNCTIONING ABS MODULE.
No injuries · No fire · No crash
Brake pedal going to floor extending stopping distance. Early in 2022 I took it in for recall S1954. HCU passed test and dealer replaced DOT3 brake fluid with DOt4. 5/24/2022 Brake pedal started going to floor again. Dealer performed self test of hcu and electronic bleed hcu and said pedal was somewhat better but needed $400 of brake work to for Brake pads, lining and turn rotors. Car functioned fine for a few days. In early June I was driving on a wet street and put on the brakes. It appeared the ABS system was trying to kick in and suddenly the pedal again went to the floor. I was barely able to miss rear-ending a city bus. I pulled into a gas station, turned the car off. When I started it again the brake pedal went to the floor. After pumping it a number of times it came back up and was again functioning. Took it to dealer on 6/1/22. Dealer again tested the hcu test which once again it passed. They could find no other problems. Dealers recommended replacing the abs modlule and master cylinder to the tune of $1,400. Seems like they can test and find out which part isn't malfunctioning (hcu which is under recall), but cant test to find out which part is malfunctioning (ABS module or master cylinder) There is obviously still serious issue with the brake system on these cars that is not being corrected by the initial hcu recall. It needs to be fixed before someone is killed. There were no warning lights or messages relating to the brakes.
No injuries · No fire · No crash
The problem I am having is with the cars braking system. I have extended brake travel required to stop the vehicle for which I have been issued two recalls. Because of the extended brake travel, I was unable to stop in time and had a front end collision with minor damage, which was not reported. The problem first showed up when I was forced to brake hard a few years causing the ABS to engage. The brake pedal traveled to the floor until the next time the ABS was engaged. Shortly after that, I was issued a recall stating the exact problem I was having. When I took it to my local dealership to get it fixed, they performed a test, changed the brake fluid, and said the system was working properly. It was not. Took it back to the dealership when hydraulic control valve became permanently locked open. They inspected it again and said the ABS unit needed to be replaced but the parts were not available. Contacted FMC customer service, and they were unable to help me either. I asked for a loaner vehicle, and received no response. Since then, I have been issued another recall and am still driving an unsafe car in a Michigan winter. All I want is a safe car to drive.
No injuries · No fire · No crash