Ford Ranger Recalls (1984)

8 recalls on file.

• Recall07E064000August 27, 2007
  FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

  CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

  Remedy

  FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

• Recall98E010000April 8, 1998
  SERVICE BRAKES, AIR:DISC:ROTOR

  EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.

  Remedy

  AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.

• Recall84V111000September 25, 1984
  LATCHES/LOCKS/LINKAGES:HOOD:LATCH

  SECONDARY HOOD LATCH COMPONENTS MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF THE HOOD IS NOT CLOSED TIGHTLY, OR IS INADVERTENTLY RELEASED, THE SECONDARY LATCH MAY NOT WORK AND THE HOOD MAY FLY UP WITHOUT PRIOR WARNING.

  Remedy

  THE HOOD ASSEMBLY WILL BE INSPECTED AND THE HOOD AND LATCH COMPONENTS WILL BE ADJUSTED, IF NECESSARY, WITHOUT CHARGE TO THE OWNER.

• Recall84V104000September 6, 1984
  SUSPENSION

  WEIGHT RATING INFORMATION IS INCORRECT ON VEHICLE MANUAL LABELS AND RATING DECALS.

  Remedy

  DEALERS WILL BE PROVIDED WITH THE REVISED VEHICLE INFORMATION. IF VEHICLE WEIGHT IS FOUND TO BE GREATER THAN THAT SPECIFIED ON WEIGHT RATING, THE AFFECTED VEHICLE"S REAR AXLE MAY BE REPURCHASED FROM FORD. A PRICE ADJUSTMENT WILL ALSO BE MADE IF APPROPRIATE.

• Recall84V082000July 9, 1984
  FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP

  IF TRUCK IS STRUCK FROM THE SIDE, THE CAP ON THE FUEL TANK COULD BECOME UNSEALED, ALLOWING UNSAFE LEAKAGE OF FUEL. THIS IS A FAILURE TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY". LEAKAGE CAN BE CAUSED BY AN ORANGE-COLORED PLASTIC DIESEL FUEL INFORMATION RING WHICH IS FOUND AROUND THE FUEL TANK NECK, OR BY THE TETHER.

  Remedy

  UPON INSPECTION, FUEL CAP TETHERS WILL BE REPLACED OR DIESEL FUEL INFORMATION RINGS WILL BE REMOVED.

• Recall84V023000March 6, 1984
  WHEELS:LUGS/NUTS/BOLTS/STUDS

  COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.

  Remedy

  CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.

• Recall83V134000December 20, 1983
  SEAT BELTS:FRONT:ANCHORAGE

  THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".

  Remedy

  DEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.

• Recall83V115000November 7, 1983
  FUEL SYSTEM, GASOLINE:STORAGE:AUXILLARY TANK

  VEHICLES MAY HAVE FUEL OR VAPOR LINE DAMAGE CAUSED WHEN AN INCORRECT PROCEDURE WAS USED IN TIGHTENING BOLTS ON ADJACENT COMPONENTS DURING ASSEMBLY. THE FUEL TANK MAY BECOME DAMAGED DUE TO A LOOSE CROSS MEMBER THAT SUPPORTS IT.

  Remedy

  VEHICLES WILL BE INSPECTED AND, WHEN NECESSARY, FUEL AND VAPOR LINES WILL BE REPLACED AND THE CROSS MEMBER WILL BE TIGHTENED.