Chevrolet Corsica Recalls

17 recalls on file.

• Recall07E021000March 12, 2007
  FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES

  CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

  Remedy

  DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

• Recall06E043000May 19, 2006
  FUEL SYSTEM, GASOLINE

  CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

  Remedy

  HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

• Recall93V157000September 24, 1993
  SUSPENSION:FRONT

  THE SUSPENSION SUPPORT ASSEMBLIES DO NOT MEET GENERAL MOTORS CORPORATION'S SPECIFICATION FOR WELD INTEGRITY AND THE AFFECTED WELD CAN FAIL CAUSING THE FRONT OF THE CONTROL ARM TO SEPARATE FROM THE SUSPENSION SUPPORT ASSEMBLY.

  Remedy

  INSTALL REVISED SUSPENSION SUPPORTS WITH ADEQUATE WELD INTEGRITY.

• Recall92V185000December 24, 1992
  EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH

  THE SERVICE BRAKE STOP LAMP SWITCH BECOMES INOPERATIVE.

  Remedy

  REPLACE THE STOP LAMP SWITCH AND CORRECT THE WIRING IN THE CONNECTOR OF THE STOP LAMP SWITCH WIRING HARNESS.

• Recall91V213000December 6, 1991
  WHEELS

  THE STYLED STEEL WHEELS CAN HAVE CRACKS DEVELOPING AT THE OUTER EDGES OF THE WHEEL WHERE THE SPOKES MEET THE RIM. THE CRACKS PROPAGATE FROM EACH SIDE OF A SPOKE TOWARD EACH OTHER, AND EVENTUALLY MEET. THE MEETING OF THE CRACKS RESULTS IN COMPLETE SEAPARATION OF A SPOKE FROM THE WHEEL.

  Remedy

  REPLACE THE INVOLVED WHEEL ASSEMBLIES.

• Recall91V206000November 26, 1991
  SEAT BELTS

  THE FRONT SHOULDER BELT RETRACTORS MAY HAVE REDUCED SENSITIVITY OF THE LOCK-UP FEATURE AND WOULD NOT FUNCTION IN A SUDDEN DECELERATION OR CRASH.

• Recall91V135000August 19, 1991
  STRUCTURE:BODY:HOOD

  SECONDARY HOOD LATCH ASSEMBLY ON THESE VEHICLES MAY NOT BE PROPERLY ADJUSTED AND COULD BECOME BENT. THIS WILL LEAD TO A CONDITION WHERE FULL PRIMARY LATCH ENGAGEMENT IS NOT ATTAINED.

  Remedy

  REPLACE THE PRIMARY HOOD LATCH ASSEMBLY, THE SECONDARY HOOD LATCH ASSEMBLY, AND THE SUPPORT BRACKET.

• Recall91V083000June 10, 1991
  STEERING: STEERING WHEEL/HANDLE BAR

  NUT ATTACHING STEERING WHEEL MAY NOT HAVE BEEN PROPERLY TIGHTENED DURING INSTALLATION.

  Remedy

  TIGHTEN THE NUT TO THE PROPER TORQUE AS NECESSARY.

• Recall90V065000April 5, 1990
  SEAT BELTS:REAR/OTHER

  OWNER'S MANUALS WERE PRINTED WITH REAR CENTER SEAT BELT INFORMATION OMITTED.

  Remedy

  INSERT MISSING INFORMATION INTO OWNERS MANUAL.

• Recall89V225000December 18, 1989
  STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS

  A DOOR HINGE (UPPER OR LOWER) MAY BREAK WHILE OPENING OR CLOSING THE DOOR MAKING IT DIFFICULT TO REPOSITION AND CLOSE PROPERLY.

  Remedy

  REPLACE DOOR HINGES ON BOTH DOORS.

• Recall89V087000May 22, 1989
  SEATS

  THE FRONT SEAT FRAME ASSEMBLY MAY CONTAIN AN IMPROPER, MISSING AND/OR MISLOCATED WELD THAT COULD FRACTURE.

  Remedy

  REPLACE BOTH FRONT SEAT ASSEMBLIES.

• Recall89V034000March 10, 1989
  SEAT BELTS

  FRONT SEAT BELT LATCH PLATES MAY NOT ENGAGE THE BUCKLE ASSEMBLIES.

  Remedy

  REPLACE IMPROPERLY FUNCTIONING BUCKLE ASSEMBLIES.

• Recall88V189000December 6, 1988
  FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY

  A FUEL TANK LEAK COULD OCCUR DUE TO SMALL CREASES ON THE TANK UNDERSIDE CRACKING DURING PRESSURE CYCLING WHICH OCCURS DURING NORMAL OPERATION.

  Remedy

  REPLACE FUEL TANK.

• Recall88V039000March 23, 1988
  LATCHES/LOCKS/LINKAGES:HOOD:LATCH

  SECONDARY HOOD LATCH ASSEMBLY MAY NOT HAVE BEEN PROPERLY ADJUSTED RESULTING IN LATCH BECOMING BENT.

  Remedy

  INSPECT AND REPLACE SECONDARY HOOD LATCH ASSEMBLIES AS REQUIRED.

• Recall87V062000May 7, 1987
  LATCHES/LOCKS/LINKAGES:HOOD:LATCH

  LOSS OF SKID PLATE COULD LEAD TO DISENGAGEMENT OF BOTH SECONDARY AND PRIMARY HOOD LATCHES.

  Remedy

  INSTALL A SECONDARY LATCH SKID PLATE AND/OR SECONDARY LATCH SKID PLATE RETAINING SCREWS.

• Recall86V164000December 15, 1986
  EXTERIOR LIGHTING:HEADLIGHTS:SWITCH

  PART OF PUSHBUTTON ATTACHMENT OF HEADLIGHT SWITCH MAY FRACTURE. CONSEQUENCE OF DEFECT: PUSH BUTTON WOULD NOT LATCH IN ON POSITION RESULTING IN INABILITY TO TURN ON HEADLIGHTS, REDUCED DRIVER VISIBILITY, AND THE POTENTIAL FOR A CRASH.

  Remedy

  INSTALL NEW HEADLIGHT SWITCH.

• Recall86V165000December 15, 1986
  LATCHES/LOCKS/LINKAGES:HOOD:LATCH

  SECONDARY HOOD LATCH MAY NOT PROPERLY ENGAGE DUE TO CONTACT WITH SUPPORT BRACKET AND/OR THE PRIMARY LATCH RETURN SPRING. CONSEQUENCE OF DEFECT: IF THIS OCCURS WHILE VEHICLE IS IN MOTION, HOOD COULD OPEN AND CONTACT THE WINDSHIELD, AFFECTING THE DRIVERS VISION AREA; THIS COULD RESULT IN A CRASH WITHOUT WARNING.

  Remedy

  INSTALL SECONDARY LATCH SKID PLATE ON CORSICA AND BERETTA MODELS. ALSO, INSTALL A REVISED SECONDARY LATCH ASSEMBLY ON BERETTA MODELS.