Volkswagen · Model Report
Showing safety data for the 2018 model year only.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Volkswagen Golf R and Atlas, 2017 Golf Alltrack and E-Golf and 2016-2018 Passat vehicles. These internal use vehicles were sold without confirmation that they were built to all applicable regulatory requirements and may have been modified prior to sale. As such, these vehicles may fail to comply with the requirements of various Federal Motor Vehicle Safety Standards.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2012-2020 Volkswagen Passat and 2018-2019 Atlas vehicles. The blocking cap disabling the adjustment of the headlight's horizontal aim may not have been installed. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Volkswagen Atlas and 2017-2018 Volkswagen Passat vehicles. The brake caliper bracket mounting bolts on these vehicles may not have been tightened sufficiently.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Volkswagen Atlas, Passat, Beetle, Beetle Convertible, Golf, Golf SportWagen and GTI and Audi Q5 and SQ5 vehicles. The brake caliper pistons on these vehicles may have insufficient coating, potentially reducing the brake performance.
I was driving my 2018 Volkswagen Passat when suddenly I felt the car started to lose acceleration even though my foot was still on the acceleration paddle. The car started to slow down, not knowing what was going on, I started to pull to the shoulder. I came to a complete halt and was trying to figure out what might have happened. In few seconds I saw black smoke and a lady from the other side of the road was shouting run run. I immediately ran out of the car and noted fire under the front of the car. I called 911 and police came to the scene in few minutes followed by the fire truck. In next few minutes the whole car was burnt. By God's grace I was safe but my car was lost.
A major engineering and material design failure occurred involving internal fluid containment seals, resulting in a severe electrical safety hazard. Pressurized engine coolant breached an internal component seal and began migrating internally directly through the vehicle's engine wiring harness via capillary/siphoning action. The fluid used the sealed wiring loom as a literal pipeline, traveling inside the wire insulation to bypass all outer weather seals and completely flood the Engine Control Module (ECM) pin connectors. The vehicle's dealership service department documented extensive galvanic corrosion and shorting inside the primary vehicle computer pins due to this blue-green fluid pooling. Because the dealership has not yet completed the full repair, the exact originating component source of the leak (e.g., the engine coolant temperature sensor or the coolant expansion tank housing barrier) remains unconfirmed. However, the physical mechanism of the coolant migration through the sealed harness into the primary electrical architecture is fully verified. This defect presents a critical safety risk. The sudden flooding and short-circuiting of the Engine Control Module can cause an immediate and unexpected loss of engine propulsion, power steering assist, and electrical control while driving at highway speeds, creating an imminent risk of a high-speed collision.
No injuries · No fire · No crash
The contact owns a 2018 Volkswagen Passat. The contact stated that while driving at an undisclosed speed, the infotainment screen failed to respond to touch commands, preventing the contact from viewing the GPS feature. The contact performed a hard reset on the vehicle, but the failure persisted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 70,000.
No injuries · No fire · No crash
The contact owns a 2018 Volkswagen Passat. The contact stated that while driving at an undisclosed speed, the vehicle stalled. There was no warning light illuminated. The vehicle was unable to restart and was towed to the dealer to be diagnosed. The vehicle was diagnosed with battery failure. The contact was informed that the battery needed to be replaced. The vehicle was repaired; however, the failure recurred. The vehicle was then towed to a different dealer; however, the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 136,000.
No injuries · No fire · No crash
I initially brought my vehicle in for service due to a strong gasoline odor and the vehicle failing to start. At that time, I was informed that no gasoline smell was detected and that the issue was instead a faulty starter, which I authorized for repair. Approximately two weeks later, my vehicle again would not start. I was then informed that the issue was a lower fuel injector, which required additional repairs. Just three days after that service, the vehicle once again failed to start, and I was told this time that the upper fuel injector was the cause. As a result of these events, I incurred a total of $3,946.96 in repair costs across two service visits and was forced to have my vehicle towed three separate times. Before the third visit, I was informed that I would need to pay an additional $1,500, on top of the nearly $4,000 I had already paid. I challenged the accuracy and consistency of the diagnoses at that point, and ultimately, the vehicle was repaired without charging me the additional $1,500. While I appreciate that the final repair was completed without further cost, I am deeply concerned about the pattern of repeated breakdowns, inconsistent diagnoses, and the financial burden placed on me as a customer. The original concern of a gasoline smell appears to have been valid from the outset, yet it took multiple failures, repairs, and significant expense before the underlying issue was resolved.
No injuries · No fire · No crash