Nissan · Model Report
Showing safety data for the 2005 model year only.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.
CERTAIN TYC HALOGEN TYPE HEADLAMP ASSEMBLIES P/N 20-6644-00 SOLD AS AFTERMARKET EQUIPMENT FOR 2005-2006 NISSAN ALTIMA PASSENGER VEHICLES. THE PHOTOMETRIC WERE MISALIGNED WHICH DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
While driving my 2005 Nissan Altima in active traffic with my [XXX] child, the vehicle suddenly stalled without any warning. The engine completely shut off while in motion, creating an immediately safety hazard in live traffic conditions. Immediately after the stall, I observed oil leakage and smoke entering the cabin. The vehicle became inoperable and we were stranded roadside. This failure is consistent with a known defect involving the crankshaft position sensor and engine control system addressed in NHTSA Campaign 07V-527, which describes sudden engine stall without warning due to sensor signal interruption. Although my vehicle previously received recall-related service, this incident suggests the prior remedy did not prevent recurrence of the defect. Sudden engine shutdown while driving in traffic Loss of vehicle power without warning Smoke entering passenger cabin Risk of crash involving child passenger Request: I am requesting that NHTSA: Review this incident for potential recall remedy failure Investigate whether this represents recurrence of a known defect Determine whether additional corrective action is needed for this vehicle population INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Vehicle: 2005 Nissan Altima | VIN: [XXX] To the Executive Team and Legal Counsel, I am writing this under extreme duress following a catastrophic, life-threatening vehicle failure on April 23, 2026, in Ripley, WV. While transporting my [XXX] son, my 2005 Nissan Altima suffered a sudden engine stall, followed by the engine bay becoming saturated with oil and emitting heavy smoke. This event is the direct result of Nissan’s failure to remediate known federal safety defects, specifically NHTSA Recall 07V527000 (Crankshaft Sensor/Stalling) and NHTSA Recall 06V223000 (Oil Consumption/Fire Risk). INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
No injuries · No fire · No crash
The contact owns a 2005 Nissan Altima. The contact stated while driving approximately 45 MPH and depressing the accelerator pedal, the vehicle made an abnormal grinding and whining sound. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, where an unknown diagnosis was made, and the contact was referred to the dealer for assistance. The vehicle was taken to a local dealer, where it was diagnosed and determined that the power steering pump needed to be replaced. The vehicle was repaired; however, the failure recurred, and the vehicle stalled while driving at various speeds and while at a complete stop at the red traffic light. The vehicle was towed to an independent mechanic, where it was diagnosed and determined that the crankshaft position sensor had failed and needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 07V527000(Engine and Engine Cooling); however, the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was approximately 120,000.
No injuries · No fire · No crash
The contact owns a 2005 Nissan Altima. The contact stated while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The contact stated that several unknown warning lights were illuminated. Additionally, the contact stated that the vehicle stalled and felt as if the vehicle was going to stop. The vehicle was taken to an independent mechanic where it was diagnosed with a failed crank shaft sensor. The contact was informed that the crank shaft sensor needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and a case was filed. The failure mileage was approximately 210,000.
No injuries · No fire · No crash
Hello, I am the owner now of this vehicle snd I see the recalls have not been taken care of? What do I do in order to get them repaired ?
No injuries · No fire · No crash