THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
THE ALTERNATOR QUIT WHICH CAUSED THE COOLING FAN TO STOP , THE HEAT LIGHT DIDNT COME ON SO THE CAR RAN HOT AND EXPLODED THE RADIATOR, THE TOP OF THE RADIATOR CRACKED AND SPEWED OUT ALL OF THE WATER , THE BRAKES FAILED TWICE AND HAD TO REPLACE THE MASTER CYLINDER AND REAR BRAKES ,
No injuries · No fire · No crash
MECHANIC WAS INFORMED BY MAZDA TO CAREFULLY OBSERVE BELT TENSION. MECHANIC FEELS THAT MAZDA'S DESIGN ON THE CRANKSHAFT HAS TOO LITTLE METAL LEFT AFTER THE FRONT JOUNAL TO PROVIDE ADEQUATE STRENGTH FOR CRANK NOT TO BREAK OVER LONG PERIOD OF TIME. CRANKSHAFT IS CUT DOWN A LOT FROM THE JOURNAL SIZE. MECHANIC NOTED THAT MAZDA HAS A SERVICE BULLENTIN IN REFERENCE TO ACCESORY BELT TENSIONS AND FEELS THAT MAZDA IS NOT WANTING TO ADMIT THAT CRANKSHAFT IS TOO SMALL. DIAMETER OF SHAFT LENDS ITSELF TO PERMATURE FAILURE DUE TO METAL FATIGUE. MECHANIC NOTED OTHER REPORTS ON NHTSA WEBSITE IN REFERENCE TO THIS PROBLEM. FELT NOTICE NEEDS TO BE OUT THERE. PROPERLY SIZED CRANKSHAFTS WITH PROPER LUBRICATION DO NOT BREAK. THEY ARE REUSED IN MOTOR CORES FOR REBUILDING. THIS RESULTED IN A PURCHASE OF A NEW ENGINE, NOT A REBULIT, FROM MAZDA.*AK
No injuries · No fire · No crash
RIGHT/LEFT TIRES ARE JERKING REAL BAD WHEN TRAVELING AT ABOUT 60 MPH. *AK
No injuries · No fire · No crash
WHILE DRIVING AT 50 MPH THERE IS VIBRATION WITHIN THE STEEING WHEEL AND THE STEERING IS OFF CENTER. *AK
No injuries · No fire · No crash
CONSUMER HAS A VEHCLE WHERE NEITHER ONE OF THE REAR RESTRAINT BELTS WORK. DEALER HAS BEEN CONTACTED. *AK
No injuries · No fire · No crash