Honda (American Honda Motor Co.) is recalling certain 2009-2014 Acura TSX, 2011-2014 TSX Sport Wagon, 2010-2013 ZDX, 2008-2012 Honda Accord, 2010-2011 Accord Crosstour, 2006-2011 Civic and Civic Hybrid, 2008-2010 Civic GX NGV, 2012-2015 Crosstour, 2007-2011 CR-V, 2009-2013 Fit, 2014 Fit EV, 2010-2014 Insight, and 2009-2015 Pilot vehicles. The vehicles are equipped with passenger frontal air bag inflators assembled as a recall remedy part or replacement service part, that may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.
Honda (American Honda Motor Co.) is recalling certain 2009-2014 Acura TSX, 2011-2013 TSX Sport Wagon, and 2010-2012 ZDX and 2008-2012 Honda Accord, 2010-2011 Accord Crosstour, 2006-2011 Civic, Civic Hybrid and Civic NGV, 2012-2014 Crosstour, 2007-2011 CR-V, 2009-2013 Fit, 2010-2013 Insight, and 2009-2015 Pilot vehicles. The front passenger air bag inflator may have been installed incorrectly during replacement.
Honda (American Honda Motor Co.) is recalling certain 2014 Honda Insight and Acura TSX and TSX Wagon, 2014-2015 Honda Crosstour and Pilot vehicles nationwide, as well as certain 2014 Honda FCX Clarity and Fit EV vehicles in Florida, Hawaii, Puerto Rico, Texas, Alabama, Georgia, Louisiana, Mississippi, South Carolina, California, American Samoa, Guam, the Northern Mariana Islands (Saipan) and the U.S. Virgin Islands. Honda is also recalling certain 2011-2013 Acura TSX, TSX Wagon and ZDX, Honda Crosstour, Insight, Fit and Pilot vehicles, 2011-2012 Honda Accord and 2011 Honda Civic NGV, Civic, Civic Hybrid and CR-V vehicles in Arizona, Arkansas, Delaware, the District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia and West Virginia. Lastly, Honda is recalling certain 2010-2013 Acura TSX and ZDX, Honda Crosstour, Fit, Insight and Pilot, 2011-2013 TSX Wagon, 2010-2012 Honda Accord and 2010-2011 Honda Civic NGV, Civic, Civic Hybrid and CR-V vehicles in Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin and Wyoming. These vehicles are equipped with certain air bag air bag inflators assembled as part of the frontal air bag modules, and used as original equipment or replacement equipment (such as after a vehicle crash necessitating replacement of the original air bags), may explode due to propellant degradation occurring after long-term exposure to higher absolute humidity, temperature and temperature cycling.
American Honda Motor Co. (Honda) is recalling certain model year 2015 Crosstour 4 Cylinder vehicles manufactured October 1, 2014, to November 4, 2014, Crosstour V6 2WD vehicles manufactured September 30, 2014, to November 13, 2014, and Crosstour V6 4WD vehicles manufactured September 30, 2014, to November 18, 2014. The inflator tube for the side curtain air bag may have been incorrectly manufactured.
HONDA IS RECALLING CERTAIN MODEL YEAR 2012 ACCORD AND CROSSTOUR VEHICLES. THE DRIVER-SIDE OR PASSENGER-SIDE SIDE CURTAIN AIRBAG INFLATOR MAY NOT HAVE BEEN MANUFACTURED ACCORDING TO CORRECT SPECIFICATIONS.
ABS Module failure causing anti-lock braking and tractional control issues due to known manufacturing defect with failed solder connections
No injuries · No fire · No crash
The contact owns a 2015 Honda Crosstour. The contact stated that the vehicle intermittently failed to immediately start and made an abnormal grinding sound while starting. The vehicle was taken to the dealer twice, but no cause for the failure was found. The vehicle was not repaired. Upon investigation, the contact associated the failure with the starter. The manufacturer was not made aware of the failure. The failure mileage was unknown.
No injuries · No fire · No crash
Driving on [XXX] with my [XXX] plus son in the back seat on car babysitting seat. Was turning right to next lane for exit, the steering wheel got stiff, very hard to turn like locked up then airbag suddenly deployed immediately car went to left side hitting the curb. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
An aftermarket ignition interlock device (Intoxalock eLERT model) installed in my vehicle repeatedly malfunctioned and disabled the vehicle’s ignition system, preventing the vehicle from starting and operating normally. The device was installed on October 6, 2025 as part of a state ignition interlock program. The first malfunction occurred only four days later. The device has malfunctioned multiple times since installation. The most serious failure occurred in March 2026 when the device would not power on at all. Because the device controls the ignition relay, the vehicle could not start and became completely inoperable. The vehicle had to be towed to the service center that installed the device. The component involved appears to be the ignition interlock handheld breath testing unit and relay system that communicates with the vehicle ignition. When the device fails to power on or function properly, the vehicle cannot start even when the driver is sober and compliant. This malfunction created a safety concern because the vehicle could not be operated or moved when needed, leaving the driver stranded and unable to safely transport family members. The problem has occurred multiple times and appears to be related to the device itself rather than the vehicle. The equipment has been returned to an authorized service center for inspection, and the device should be available for inspection upon request. There were no warning lights from the vehicle itself prior to the failure. The primary symptom was that the ignition interlock device would not power on or would malfunction during operation, which prevented the vehicle from starting. Because the ignition interlock device directly controls whether the vehicle can start, repeated device failures create a situation where the vehicle becomes unexpectedly disabled.
No injuries · No fire · No crash
An aftermarket ignition interlock device installed in my vehicle requires “rolling retests” while the vehicle is in motion. During these rolling retests, the device alerts the driver and requires a breath sample within a short time window. To complete the test, the driver must physically pick up and handle the handheld unit and blow into the device while driving. This requirement creates a driver distraction because the driver must remove at least one hand from the steering wheel and divert attention from the roadway in order to complete the breath test. This procedure appears to conflict with Pennsylvania’s hands-free driving law, 75 Pa.C.S. §3316 (Paul Miller’s Law), which prohibits drivers from holding or manually using an interactive electronic device while operating a vehicle. Although the ignition interlock device is intended to promote road safety, the design of the rolling retest requires the driver to manually interact with a handheld device while the vehicle is moving. Drivers may feel pressured to complete the test immediately because failing to do so can be recorded as a violation or trigger lockout procedures. This creates a situation where drivers must choose between complying with the device requirements or maintaining full attention on safe vehicle operation. In my experience, the alert can occur while driving in traffic, which forces the driver to handle the device during active driving conditions. Because this equipment directly affects vehicle operation and driver behavior while the vehicle is moving, I am submitting this report to raise a potential safety concern regarding whether rolling retest procedures create unsafe driver distraction and whether they conflict with hands-free driving safety laws.
No injuries · No fire · No crash