Ford · Model Report
Showing safety data for the 2014 model year only.
Mobility Transportation Services (MobilityTrans) is recalling certain 2014-2018 Ford Transit and Ram Promaster vehicles and 2014-2015 Ford Econoline vehicles modified to be equipped with Freedman GO-ES Foldaway Seats, part numbers 43705, 45467, 48923, and 75719. When the back seat cushion is rotated from the stowed position to the upright position, the seat cushion may not remain locked into place when under load, such as in a crash or a sudden stop.
New England Wheels (New England) is recalling certain 2008, 2013 and 2014 Ford E-250 vehicles modified to be equipped with Ricon Wheelchair lifts. The wheelchair lift positioning input cam may fail while the lift is in use, allowing the platform to travel higher than the vehicle's floor height. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 403, "Platform Lift Systems."
New England Wheels (New England) is recalling certain model year 2006-2014 Ford E-250, E-350, and 2015 Ford Transit vans equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts by Ricon. The platform side plate of the affected wheelchair lifts may crack. Additionally, the lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.
New England Wheels is recalling certain model year 2006-2014 Ford E-250, and E-350 cargo vans modified to be equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts built by the Ricon Corporation. The affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.
Mobility Specialists, Inc. (Mobility Specialists) is recalling certain model year 2006-2014 Ford E-250, and E-350 vehicles modified to be equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts manufactured by Ricon Corporation. The platform side plate of the affected wheelchair lifts may crack. Additionally, the affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.
The contact owns a 2014 Ford E-250. The contact stated that while driving approximately 40 MPH, the vehicle suddenly fishtailed, causing the rear passenger side of the vehicle to crash into an unknown object. The contact indicated that the vehicle would only operate in limp mode after the crash. After switching back to the drive position, the vehicle operated normally. During the crash, no injuries were reported, and no police report was filed. The contact used a scanner to determine that the PCU had malfunctioned and needed to be replaced. The contact also discovered that electrical wires in the vehicle were damaged by rodents. A Number 6 Injector Wire was chewed out by rodents, and the contact independently replaced the wire however, the vehicle continued to misfire. The vehicle was not yet repaired. The manufacturer and local dealer were notified of the failure, but no assistance was offered and was referred to the NHTSA Hotline. The manufacturer was aware that there was a software issue with the PCU and that it was a known failure, and the contact was concerned due to Ford acknowledging there was a fatality due to this known failure. The failure mileage was unknown.
TL* THE CONTACT OWNS A 2014 FORD E-250. THE CONTACT STATED THAT THERE WAS A KNOCKING NOISE COMING FROM UNDERNEATH THE HOOD OF THE VEHICLE. THE CONTACT TOOK THE VEHICLE TO A CERTIFIED MECHANIC WHO DIAGNOSED THAT THE ENGINE FAILED AND NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. A DEALER WAS NOT CONTACTED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AND THE CONTACT WAS INFORMED THAT THE REPAIR WAS NOT COVERED UNDER A RECALL OR WARRANTY. THE APPROXIMATE FAILURE MILEAGE WAS 200,000.
No injuries · No fire · No crash
ON NOVEMBER 27, 2019 I WAS DRIVING BACK TO MY OFFICE AFTER COMPLETION OF A CHIMNEY JOB WHEN MY MOTOR WENT WITH ONLY 73,660. I THEN HAD TO HAVE MY VEHICLE TOWED AND THAT'S WHEN MY MECHANIC PULLED THE VALVE COVERS AND DISCOVERED A BROKEN VALVE SPRING THAT HAD CAUSED IT TO DROP THE VALVE INTO THE PISTON WHICH THEN CAUSED THE COOLANT AND OIL TO MIX. IN RETURN, THIS CAUSED A CATASTROPHIC FAILURE TO THE ENGINE. AT THAT POINT THE ENGINE WAS PULLED. IT WAS ALSO NOTED THAT THE SIDE OF THE ENGINE BLOCK WAS CRACKED AND BENT THE OIL PAN. UPON CLEANING THE INTAKE MANIFOLD GASKET SURFACES HE FOUND THAT DUE TO A POSITIVE CRANKCASE FROM THE VALVE DAMAGING THE PISTON THAT THE INTAKE WAS FULL OF OIL COOLANT MIXTURE AS WELL AS PIECES OF METAL FROM THE PISTON SHATTERING.
No injuries · No fire · No crash
NUMBER 2 SPARK BELOW OUT OF THE MOTOR,WHEN DRIVING
No injuries · No fire · No crash
TL* THE CONTACT OWNS A 2014 FORD E-250. WHILE DRIVING VARIOUS SPEEDS AND DEPRESSING THE BRAKE PEDAL, A SNAPPING SOUND WAS HEARD COMING FROM THE VEHICLE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO DIAGNOSED THAT THE FRONT DRIVER SIDE INNER BRAKE PAD HAD SEPARATED. THE BRAKE PAD WAS REPLACED AND THE VEHICLE OPERATED NORMALLY. THE LOCAL DEALER (BASIL FORD, 1540 WALDEN AVE, CHEEKTOWAGA, NY) WAS NOTIFIED OF THE FAILURE. THE MANUFACTURER WAS NOT NOTIFIED. THE FAILURE MILEAGE WAS 24,000.
No injuries · No fire · No crash