Chrysler (FCA US, LLC) is recalling certain 2014-2019 Fiat 500 vehicles. The tire pressure monitoring system (TPMS) warning light may not illuminate as intended. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 138, "Tire Pressure Monitoring Systems."
Chrysler (FCA US LLC) is recalling certain 2012-2013 Fiat 500 vehicles equipped with 6-speed automatic transmissions. The shifter cable bushing may fail allowing the cable to detach from the transmission.
DLT, LLC. is recalling certain CravenSpeed Fiat Short Shifter shafts sold for use in 2011-2019 Fiat 500 vehicles. The Shifter Shaft may have been improperly manufactured with a through hole for the set screw rather than a blind hole, which may lead to the breakage of the Shifter Shaft.
Chrysler (FCA US LLC) is recalling certain model year 2016 Fiat 500 vehicles manufactured June 11, 2015, to July 27, 2016. The tire placard on the affected vehicles lists a tire inflation pressure for the spare tire that exceeds the maximum pressure listed on the sidewall. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."
Chrysler (FCA US LLC) is recalling certain model year 2012-2016 Fiat 500 vehicles manufactured June 21, 2010, through January 12, 2016, equipped with a manual transmission. The clutch diaphragm spring may fracture and fail, causing an inability to switch gears.
The contact owns a 2013 Fiat 500. The contact stated that the vehicle failed to start. The vehicle was towed to the dealer, where it was determined that the shifter cable bushing had failed. The vehicle was repaired under NHTSA Campaign Number: 19V817000 (Power Train); however, the failure recurred 25 miles later. Upon inspection, the contact became aware that the shifter cable bushing under the hood had detached again. The dealer was notified of the failure and informed the contact that the vehicle was repaired with the part provided by the manufacturer. The manufacturer was notified of the failure and initially informed the contact that a case was pending authorization for a loaner vehicle, tow truck service, and repair assistance; however, the dealer later informed the contact that the manufacturer had only agreed to cover the repair. The failure mileage was 117,627.
No injuries · No fire · No crash
Gear cable broke. Automatic engine could not allow gears to shift. Would like for my vehicle to be included under NHTSA TECALL 19V-817. FCA Campaign Vb4.Fiat 500c 2012-13. MOPAR Fiat case #98205553.
No injuries · No fire · No crash
The contact owns a 2012 Fiat 500. The contact stated that upon shifting the gear shifter into drive(D), park(P), or reverse(R), the transmission failed to shift into the intended gear and shifted into a different gear. The vehicle was towed to the dealer after each failure. The dealer repaired the vehicle under NHTSA Campaign Number: 19V817000 (Power Train); however, the failure persisted. The manufacturer was notified of the failure several times by phone and by an online complaint. Several cases were filed and the contact was referred to the dealer for assistance.
No injuries · No fire · No crash
The contact owns a 2017 Fiat 500. The contact stated that while driving 25 MPH, the check engine, TPMS, and several unknown warning lights illuminated. Additionally, the vehicle was jerking and making an abnormal sound. The failure was recurrent. The vehicle was towed to an independent mechanic, who was unable to duplicate or determine the cause of the failure. The dealer was contacted by phone. The failure mileage was approximately 15,873.
No injuries · No fire · No crash
I am filing a complaint concerning a recurring gear shift failure in my 2012 fiat 500c. The same failure has occurred three times between June 10 and September 8, 2026. On June 10, 2026 I was able to move shift lever but the transmission remained in reverse and would not shift into another gear despite multiple attempts. I did not know what the cause or problem was and had no knowledge that it might be related to a safety recall. I had vehicle towed to an independent repair shop who subsequently diagnosed a faulty gear shifter and replaced it and this restored the vehicles operation. The shop was able to replace the faulty part and the car was returned to me on June 12, 2026. On August 21, 2026the same failure occurred again. I was able to move the shifter but the transmission remained in neutral regardless of the selected shifter position and I had to push the vehicle onto the side of the road. Again the vehicle was undriveable and was towed to an authorized dealership who diagnosed a faulty gear shifter. The dealership performed the repair under safety recall VB4/NHTSA recall 19V-817 concerning the gear shifter cable adjust/bushing. The dealership then returned the vehicle to me as repaired on September 4, 2026. The vehicle sat parked for the following 3 days and was operated on September 8, 2026. On September 8, 2026 the exact same failure occurred a third time and after the authorized dealership completed the recall repaired. The gearshift lever moved, but the transmission would not change gears and the indicator remained in drive. The vehicle was again undriveable and had to be towed back to the dealership. Stellantis/FCAopened several case numbers and a case manager informed me the dealership would not be able to inspect the vehicle for 8 days. I was also informed that Stellantis/FCAand the dealership would not provide rental or alternate transportation assistance while the disabled vehicle awaited inspection.
No injuries · No fire · No crash