Audi Q5 Service Bulletins (2013)
1,661 manufacturer communications on file.
- March 18, 2014•Document ID: 10122307Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; ENGINE
- Mfr Comm. #:
- A971441 2036764-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummaryThe MIL is on. Vehicle will not start. DTC P068A00 is stored in the engine control module (ECM), J623 (address word 01). Numerous unrelated DTCs are also stored in the system. The motronic engine control module power supply relay, J271, is not functioning properly. Because the J271 relay controls battery voltage (Terminal 30) via a ground signal sent from the ECM, numerous faults can occur in multiple control modules when it is not functioning properly.
Associated Products (40)Associated Documents - March 17, 2014•Document ID: 10231133Service Bulletin/Repair InstructionsEQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
- Mfr Comm. #:
- Edition77
- Date Added:
- February 6, 2023
- Manufacturer:
- AUDI
SummaryTechnical bulletins and updates
Associated Products (189)Associated Documents - March 13, 2014•Document ID: 10226436Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:STARTER ASSEMBLY
- Mfr Comm. #:
- 97144120367641
- Date Added:
- November 21, 2022
- Manufacturer:
- AUDI
Summary97 No start (DTC P068A00)
Associated Products (40)Associated Documents - March 13, 2014•Document ID: 10216609Service Bulletin/Repair InstructionsSERVICE BRAKES
- Mfr Comm. #:
- 147120367611
- Date Added:
- August 1, 2022
- Manufacturer:
- AUDI
SummaryUpdated oil pressure switch
Associated Products (24)Associated Documents - March 13, 2014•Document ID: 10122279Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- A011471 2036761-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummaryThe MIL is on. DTC P164B(00) is stored in the ECM. The oil pressure switch is defective.
Associated Products (24)Associated Documents - March 11, 2014•Document ID: 10122297Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING:COOLING SYSTEM
- Mfr Comm. #:
- A801406 2033806-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 80 number 13-05 dated September 11, 2013. Malfunction Indicator Lamp is on. Climate system heating performance is insufficient. Coolant level warning is on. Engine temperature is elevated. "Limp Home" mode is active. Faults are stored in the transmission control module (address word 02). Coolant loss is found from one or more control valves: N82, N509, or N488. Coolant may have migrated into the wiring harness through the connector and into various control units. Climate system heating performance is insufficient due to coolant loss, or due to a faulty N82 control valve. Inspection of the coolant control valves N82, N509, or N488 reveals the presence of coolant inside the electrical connector as shown in the illustration. The connectors, wiring harness, and/or connected control units may have been damaged from exposure to coolant.
Associated Products (24)Associated Documents - March 10, 2014•Document ID: 10250987Service Bulletin/Repair InstructionsSTEERING
- Mfr Comm. #:
- 44144820301945
- Date Added:
- March 4, 2024
- Manufacturer:
- AUDI
SummarySteering wheel vibration and/or oscillation at low mileage - Repair Authorization
Associated Products (3)Associated Documents - March 7, 2014•Document ID: 10066929Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 2034404/3
- Date Added:
- May 23, 2016
- Manufacturer:
- AUDI
SummarySUMMARY TO BE PROVIDED ON A FUTURE DATE.
Associated Products (3)Associated Documents - March 7, 2014•Document ID: 10057287Service Bulletin/Repair InstructionsEXTERIOR LIGHTING:HEADLIGHTS
- Mfr Comm. #:
- 9414582036670/2
- Date Added:
- May 11, 2015
- Manufacturer:
- AUDI
SummaryAUDI : 2013-2016 Q5 : THE HIGH BEAM NOT WORKING ON ONE SIDE OF THE VEHICLE. LOW BEAMS WORKING PROPERLY, THE HIGH BEAM SHUTTER IS NOT CONNECTED IN THE HEADLIGHTS. *LJ
Associated Products (3)Associated Documents - March 7, 2014•Document ID: 10122304Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EXTERIOR LIGHTING:HEADLIGHTS
- Mfr Comm. #:
- A941434 2036670-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummaryThe high beam is inoperative on one side of the vehicle. The low beams operate correctly. A warning may appear in the instrument cluster. DTCs may be present in the central electrics control module, J519 (address word 09). The connection for the high beam shutter is not connected in the affected headlight.
Associated Products (4)Associated Documents - March 7, 2014•Document ID: 10122288Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- A461472 2034404-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 46 number 13-48 dated July 18, 2013. Customer may report that the vehicle does not start due to a discharged battery. DTC U101100 (supply voltage too low) is stored in the gateway, J533 (address word 19), and/or the electronic parking brake (EPB) control module, J540 (address word 53). According to the test plan "19-Read Data Bus Keep-Awake Manager", the EPB control module kept the data bus active for prolonged periods of time. The EPB switch appears to be permanently operating (applying or releasing the parking brake) due to an internal mechanical issue or because it is jammed or blocked by debris or by a foreign object. Test plan "19-Read Data Bus Keep-Awake Manager" identifies the EPB control module as keeping the data bus active for prolonged periods of time.
Associated Products (3)Associated Documents - March 6, 2014•Document ID: 10122301Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM)
- Mfr Comm. #:
- A911428 2036576-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 91 number 14-26 dated February 24, 2014. The MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when a phone is connected to the vehicle via Bluetooth when the user searches for a contact name in the MMI address book (by using the MMI control knob or the voice recognition system). This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact.
Associated Products (39)Associated Documents - March 4, 2014•Document ID: 10226435Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES
- Mfr Comm. #:
- 96148220363441
- Date Added:
- November 21, 2022
- Manufacturer:
- AUDI
Summary96 Alarm sounds when driver door is unlocked with mechanical key
Associated Products (65)Associated Documents - March 4, 2014•Document ID: 10122306Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:ANTI-THEFT DEVICES; LATCHES/LOCKS/LINKAGES:DOORS:LATCH
- Mfr Comm. #:
- A961482 2036344-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummaryThe vehicle's anti-theft alarm sounds when the driver door is unlocked with a mechanical key. No DTCs are stored. The keyless remote was not used to unlock the vehicle. In order to minimize current draw after the ignition has been turned off, the electronics system of the vehicle goes into sleep mode. During this time, each module monitors the CAN bus more slowly than when the electronics system is awake. Because the system is being monitored more slowly, there is a delay in the waking of the central locking system. This delay causes a delay in the disabling of the anti-theft alarm system when the manual key is used. If the key is turned in less than a quarter of a second, the system can unlock the vehicle even though the anti-theft alarm has not been disabled.
Associated Products (65)Associated Documents - March 4, 2014•Document ID: 10122300Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM)
- Mfr Comm. #:
- A911427 2036575-
- Date Added:
- November 8, 2017
- Manufacturer:
- AUDI
SummaryThe addresses and contacts stored in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus disappear intermittently in vehicles with MMI3G+ Navigation, and in vehicles with or without Audi connect. Intermittently, the MMI system does not appear to remember that the user's myAudi PIN has already been entered, and it requires the user to enter the PIN again in vehicles with Audi connect. If a user stores addresses and contacts in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus while a Bluetooth phone is paired to the vehicle, those addresses and contacts will only be visible any time that the same phone is paired to the vehicle. Any time that the same phone is not paired to the vehicle, the addresses and contacts will not be available. If a user stores addresses and contacts in the Navigation >> Favorites, Navigation >> Directory, and Navigation >> Last destinations submenus while a Bluetooth phone is not paired to the vehicle, the addresses and contacts will be available any time. In vehicles with Audi connect, the user is prompted to enter the myAudi PIN when selecting online destinations or when importing contacts from the myAudi account. If the user?s Bluetooth phone (the same phone that was paired to the vehicle when the PIN was entered initially) is paired to the vehicle, the user will not be prompted to re-enter the PIN after it has been entered.
Associated Products (27)Associated Documents - March 1, 2014•Document ID: 10055712Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 2036670
- Date Added:
- July 9, 2014
- Manufacturer:
- AUDI
SummaryTHE HIGH BEAM ON ONE SIDE OF THE VEHICLE ISNT OPERATING. 07/09/14*LJ
Associated Products (1)Associated Documents - February 27, 2014•Document ID: 10125561Service Bulletin/Repair InstructionsEQUIPMENT:APPLIANCE:AIR CONDITIONER
- Mfr Comm. #:
- A871447 2010146-
- Date Added:
- December 14, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 87 number 12-27 dated April 24, 2012. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor. If the odor is noticeable in the vehicle when the engine is not turned on, the cause may be mold and mildew in the passenger compartment, and not be related to the A/C system. All other possible sources of the odor must be investigated before this bulletin can be performed.
Associated Products (131)Associated Documents - February 24, 2014•Document ID: 10231120Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- Edition74
- Date Added:
- February 6, 2023
- Manufacturer:
- AUDI
SummaryDiagnostics and updates
Associated Products (19)Associated Documents - February 24, 2014•Document ID: 10125564Service Bulletin/Repair InstructionsSEATS
- Mfr Comm. #:
- A911426 2036576-
- Date Added:
- December 14, 2017
- Manufacturer:
- AUDI
SummaryThe MMI screen goes blank then restarts or the MMI screen freezes for a few minutes then recovers when the user searches for a contact name in the MMI address book when a phone is connected to the vehicle via Bluetooth. This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact.
Associated Products (39)Associated Documents - February 24, 2014•Document ID: 10125560Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- A851420 2033596-
- Date Added:
- December 14, 2017
- Manufacturer:
- AUDI
SummarySupersedes Technical Service Bulletin Group 85 number 13-17 dated May 15, 2013. DTCs may be stored in the heating and air conditioning electronics control module (address word 08). Improper operation of the fresh air blower could be caused by a faulty printed circuit board in the fresh air blower control module and/or the carbon brushes bind in the brush holder and, as a consequence, lose contact with the motor commutator of the fresh air blower.
Associated Products (19)Associated Documents