2025-2026 Audi e-tron GT "Exit warning: fault" TSB
Audi has issued Technical Service Bulletin 64 24 03 2076109/1 for 2025-2026 e-tron GT, RS e-tron GT, and S e-tron GT models. This TSB addresses the "Exit warning: fault. Please contact workshop" message appearing in the instrument cluster, linked to DTC B122B11.
Sarah Mitchell2026 Audi S e-tron GT
Also applies to
- Audi e-tron GT
- 2025
Audi has released Technical Service Bulletin (TSB) 64 24 03 2076109/1 to address a specific instrument cluster warning message in certain 2025-2026 e-tron GT, RS e-tron GT, and S e-tron GT models. This TSB, dated November 27, 2024, describes conditions leading to an "Exit warning: fault" message and a related diagnostic trouble code.
This TSB is classified as a Pending Service Solution (PSS), indicating that a final repair is still under development. Owners experiencing this specific Audi e-tron GT exit warning should be aware of the information provided in this bulletin.
Symptoms
Owners of affected vehicles may observe a yellow warning message in the instrument cluster. This message, which appears after getting into the vehicle and selecting a gear, states: "Exit warning: fault. Please contact workshop”. The customer complaint regarding this Audi e-tron GT exit warning cannot always be consistently reproduced.
Fault Codes / DTCs
When the
Frequently Asked Questions
- What does "Exit warning: fault. Please contact workshop" mean in my Audi e-tron GT?
- This message indicates that your vehicle's central locking system may be experiencing an incorrect short circuit detection. It is linked to Diagnostic Trouble Code (DTC) B122B11, as described in Audi TSB 64 24 03 2076109/1.
- What is DTC B122B11?
- DTC B122B11 stands for "Central Locking motors Short Circuit to ground." This code can be stored in various door electronics modules, including J386 (Driver Door), J387 (Front Passenger Door), J388 (Driver Side Rear Door), and J389 (Passenger Side Rear Door).
- Can I fix the "Audi e-tron GT exit warning" myself?
- No, Audi explicitly states in TSB 64 24 03 2076109/1 that no repairs are necessary at this point, and replacing components will not resolve the concern. A solution is expected to be available by the end of the first quarter of 2025.
- Is there a recall for this central locking issue?
- No, this is currently addressed by a Technical Service Bulletin (TSB) and a Pending Service Solution (PSS), not a recall. This means Audi is aware of the issue and is working on a permanent fix, but it's not yet deemed a safety recall.
Related Articles
2022-2026 Audi e-tron GT 12V Battery Discharged TSB 2075846/3
Audi Technical Service Bulletin 2075846/3 addresses a discharged 12V battery condition in 2022-2026 e-tron GT and RS e-tron GT vehicles, often accompanied by DTC P1D6C00. This TSB outlines a software update procedure to resolve the issue.
2025-2026 Audi e-tron GT Active Suspension Noise TSB
Audi has released Technical Service Bulletin 2080798/1 for 2025-2026 e-tron GT and RS e-tron GT models equipped with active suspension (PR code 1P8). It addresses noises heard when driving over bumps and outlines diagnostic procedures for technicians.
2026 Audi e-tron GT Roll Stabilization Configuration Aborted TSB
Audi Technical Service Bulletin 2080608/1 addresses an issue where roll stabilization configuration for diagnostic addresses 00D4 and 00D5 is aborted on 2026 Audi e-tron GT and RS e-tron GT vehicles. This TSB provides diagnostic steps for technicians.
2021-2026 Audi Ceramic Brake Repair Advisory
Audi has released a manufacturer communication, NHTSA ID 11027374, regarding ceramic brake repairs on various 2021-2026 Audi models. Technicians are required to contact the Technical Assistance Center (TAC) before proceeding with any brake service on vehicles equipped with ceramic brakes.
2022-2026 Audi e-tron GT C1399F0 Brake-In Mode TSB
Audi Technical Service Bulletin (TSB) 2063679/6 addresses Diagnostic Trouble Code (DTC) C1399F0 in 2022-2026 Audi e-tron GT, RS e-tron GT, and S e-tron GT models. This code indicates the vehicle is in a normal brake application mode for new or replaced brake components and typically requires no…
Leave a comment
Comments are moderated and may take a moment to appear. Only your first name and the initial of your last name are shown publicly.
Comments
Be the first to comment.