Nissan 200SX Recalls

5 recalls on file.

• Recall06E049000May 24, 2006
  EXTERIOR LIGHTING

  CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

  Remedy

  CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.

• Recall98V093000May 5, 1998
  VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. WATER CAN ENTER AND DISPLACE THE GREASE IN THE WIPER ARM LINKAGE BALL JOINT WHERE THE WIPER LINKAGE ATTACHES TO THE WIPER MOTOR LINKAGE.

  Remedy

  TO PREVENT GREASE FROM BEING WASHED OUT OF THE JOINT, THE DEALERS WILL MODIFY BY ADDING A WATER DIVERSION SEAL THAT WILL PREVENT WATER FROM ENTERING THE WINDSHIELD WIPER LINKAGE BALL JOINT AREA.

• Recall95I006000November 1, 1995
  FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM

  THIS IS NOT A SAFETY RECALL CAMPAIGN IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CAMPAIGN WILL REPLACE THE FUEL INJECTORS AND RELATED HOSES OF AFFECTED VEHICLES WHICH COULD LEAK.

  Remedy

  NISSAN DEALERS WILL REPLACE THE FUEL INJECTORS AND RELATED HOSES ON THE AFFECTED VEHICLES.

• Recall95V103002May 24, 1995
  SEAT BELTS:FRONT:BUCKLE ASSEMBLY

  THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

  Remedy

  OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED FREE OF CHARGE.

• Recall95V028000March 1, 1995
  SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

  THE ANTI-LOCK BRAKING SYSTEM (ABS) HYDRAULIC ACTUATOR WAS NOT PROPERLY PURGED OF ALL AIR DURING THE FILL AND EVACUATION PROCESS CAUSING AIR BUBBLES TO GET INTO THE BRAKE SYSTEM.

  Remedy

  DEALERS WILL BLEED THE ABS HYDRAULIC ACTUATOR TO REMOVE ANY AIR BUBBLES IN THE BRAKE SYSTEM.