Chevrolet · Model Report
Showing safety data for the 1996 model year only.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.
THESE VEHICLES WERE ASSEMBLED WITH THE THROTTLE CABLE CONTACTING THE DASH MAT WHICH COULD BIND THE THROTTLE. THIS DOES NOT MEET WITH THE MAXIMUM RETURN TIMES REQUIRED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS."
IT KEEPS STALLING ON US. WE HAVE REPLACED ALL THE CENSORS, THE CONTROL MODULE AND WE EVEN REPLACED THE REAR END WE HAVE SPENT WELL OVERA THOUSAND DOLLARS AND THIS VEHICLE STILL WONT STAY RUNNING IT STALLS WON'T START WE HAVE FIXED EVERYTHING THE CODES ARE READING. THIS CONTINUES TO STALL IT SHUTS DOWN BY ITS SELF IT ALMOST KILLED MY WIFE AND KIDS A FEW TIMES I WANT THIS VEHICLE FULLY REPAIRED FOR FREE. I HABE ONE INCOME AND I CANT EVEN CATCH UP ON MY BILLS AS WE HAVE SPENT MORE ON HER VEHICLE TO STILL CAUSE PROBLEMS AND ME ALMOST LOOKING MY FAMILY MULTIPLE TIMES IN THIS VEHICLE. THIS VEHICLE WAS IN MOTION AND DRIVING DOWN A ROAD AND ALL OF A SUDDEN IT STALLED IT HAS DONE THIS MULTIPLE TIMES THIS YEAR.
No injuries · No fire · No crash
DISCOVERED WHILE REPLACING THE REAR AXLE ASSEMBLY, THE U BOLTS THAT CONNECT THE REAR AXLE HOUSING TO THE LEAF SPRINGS HAD ALMOST RUSTED THRU. THIS PROBLEM IS NOT EASILY RECOGNIZABLE AS THE CONFIGURATION OF LOWER PLATE THAT THE U BOLTS GO THRU CONCEALS THE RUSTED PORTIONS OF THE U BOLT. ALSO, THE CONFIGURATION OF THE ABOVE-MENTIONED PLATE CAPTURES ROAD SALT, CORRODING THE U BOLTS. IF THESE BOLTS FAILED, THE REAR AXLE WOULD DISLODGE FROM THE VEHICLE WITH DISASTROUS RESULTS.
No injuries · No fire · No crash
TL* THE CONTACT OWNS A 1996 CHEVROLET SUBURBAN. THE CONTACT STATED THAT WHILE DRIVING 20 MPH WHILE TOWING A TRAILER, THE TRAILER BRAKES MALFUNCTIONED CAUSING THE WHEELS TO LOCK AND BLOWING THE TRAILER FRONT PASSENGER SIDE TIRE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC. THE TECHNICIAN DIAGNOSED THAT THE STEERING COLUMN HARNESS WAS UNDERSIDE CAUSING ONE OF THE WIRES TO BURN OUT. AS A RESULT, THE WIRING HAD TO BE REPLACED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE VEHICLE WAS REPAIRED. THE FAILURE MILEAGE WAS 140,000 AND THE CURRENT MILEAGE WAS 250,000. UPDATED 08/11/2014*LJ
No injuries · No fire · No crash
NOVEMBER 2010, I WENT TO STOP, THE BRAKE PEDAL WENT TO THE FLOOR. I WAS ABLE TO STOP USING THE PARKING BRAKE, BUT WAS VERY CLOSE TO REAR-ENDING A CARLOAD OF PEOPLE. I HAD THE TRUCK TOWED TO A REPAIR SHOP. THE MECHANIC TOLD ME THAT THE FRONT BRAKE LINE HAD RUSTED OUT BECAUSE IT WAS MOUNTED AT THE FACTORY TO THE FRONT AXLE ON THIS 4-WHEEL DRIVE TRUCK CAUSING IT TO VIBRATE AND COLLECT DEBRIS ON IT LEADING TO A PREMATURE FAILURE DUE TO RUST. IN DECEMBER 2012, AGAIN WHEN I WENT TO STOP FROM ABOUT 55 MPH ON THE FREEWAY, THE BRAKE PEDAL AGAIN WENT ALMOST COMPLETELY TO THE FLOOR, BUT AGAIN I WAS ABLE TO STOP BEFORE HITTING ANOTHER VEHICLE BY USING THE PARKING BRAKE AND RUNNING UP ON THE SHOULDER OF THE FREEWAY. THE MECHANIC TOLD ME THAT THIS TIME THE REAR BRAKE LINE HAD RUSTED OUT AT THE "T - INTERSECTION" WHERE THE BRAKE LINE RUNS FROM THE FRONT MASTER CYLINDER TO THE REAR AXLE AND SPLITS INTO 2 LINES AT THE T INTERSECTION. THE MECHANIC TOLD ME THAT THIS WAS A VERY COMMON PROBLEM ON THESE TRUCKS AS IT WAS A BAD DESIGN, BECAUSE THE T LAYS IN A RECESSED HOLDER ATTACHED TO THE REAR AXLE, ALLOWING DIRT, SALT AND WETNESS TO ACCUMULATE IN THIS AREA AND CAUSE PREMATURE RUST AND FAILURE OF THE BRAKE LINES. THIRD, LAST WEEK, WHILE DRIVING, I NOTICED A RAW GAS SMELL AND STOPPED THE VEHICLE. AGAIN I HAD TO HAVE IT TOWED AS GAS WAS POURING OUT OF THE FUEL LINE BY THE GAS FILTER ON THE DRIVER'S SIDE REAR WHEEL. THIS WAS TOWED TO A DIFFERENT MECHANIC'S REPAIR SHOP WHO AGAIN SHOWED ME THAT THE METAL FUEL LINE HAD RUSTED OUT DUE TO ITS BEING MOUNTED TO THE FRAME RAIL, CAUSING SALT, DIRT AND DEBRIS TO ACCUMULATE THERE ALSO. HE WARNED ME THAT THESE TRUCKS FREQUENTLY CATCH FIRE WHEN THESE HIGH PRESSURE FUEL INJECTION LINES RUST OUT. HE SAID HE HAD SEEN 5 OF THESE TRUCKS BURNED IN JUST THE LAST 2 YEARS AT HIS SMALL SHOP.PLEASE HELP. THESE TRUCKS ARE INHERENTLY DANGEROUSLY DESIGNED TO FAIL. *TR
No injuries · No fire · No crash
TL* THE CONTACT OWNS A 1996 CHEVROLET SUBURBAN. THE CONTACT STATED THAT WHILE REVERSING FROM A DRIVEWAY, THE FUEL PUMP OVER HEATED, MELTED, AND DESTROYED THE CONNECTORS. THE VEHICLE WAS REPAIRED BY THE CONTACT AND THE MANUFACTURER WAS NOT NOTIFIED. THE APPROXIMATE FAILURE MILEAGE WAS 240,000.