GMC · Model Report
Showing safety data for the 2022 model year only.
General Motors, LLC (GM) is recalling certain 2022 Chevrolet Tahoe, Chevrolet Suburban, GMC Yukon, GMC Yukon XL, Cadillac Escalade, and Cadillac Escalade ESV vehicles equipped with 10 Speed Transmission with ETRS (Electronic Transmission Range Select). The transmission control valve may fail and lock up the rear wheels.
General Motors LLC (GM) is recalling certain 2021-2024 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, and Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles equipped with a 6.2L V8 gas engine. The connecting rod and/or crankshaft engine components may have manufacturing defects that can lead to engine damage and engine failure.
General Motors, LLC (GM) is recalling certain 2020-2023 Cadillac CT4 and CT5; 2021-2023 Buick Envision; and 2022-2023 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles. The daytime running lights (DRLs) may not deactivate when the headlights are on. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."
General Motors, LLC (M) is recalling certain 2021-2022 Cadillac Escalade, Escalade ESV, Chevrolet Suburban, Tahoe, GMC Yukon, and Yukon XL vehicles equipped with third-row seats. The rivet that retains the buckle to the mounting bracket in the left or right side third-row seat belt buckle assembly may have been improperly formed.
Transfer case shutters in AWD and 4WD. Almost locks up in 4WD in reverse in a turn. Shutters in both AWD and 4WD. Dealer claims this is normal so just drive in 2WD. The vehicle did not do this before. I test drove new 2026 exact same vehicle. It did not do what my vehicle does. GM will not entertain a buyback. Offered GM voucher points. The engine has already been replaced. It appears to be consuming oil so the dealer is conducting an oil consumption test now.
No injuries · No fire · No crash
Sudden catastrophic engine failure during operation. Was climbing a hill and suddenly started losing power, almost instantly a written warning popped up on my screen saying engine oil over temp, idle engine. We started pulling off the road, engine started rattling, then shut off before we could come to a complete stop. At this point i was checking the gauges and all were at normal operating temperatures, but as I sat there watching the temperature gauge began to rise rapidly with the engine off. The engine was seized and had to be towed.
No injuries · No fire · No crash
On 9/11/26 the Yukon XL flashed a check engine light and message stated to service within 7 business days. 30 seconds later the power shut off and barely coasted to the side of the highway. Engine would turn over but not start. Could not shift into neutral b/c wouldn’t start. Error message: ECM - Engine and Transmission SystemP102AThe Engine and Transmission System is not performing as expected. An issue has been detected in the Fuel Management System used to maintain, control and monitor fuel consumption. If the check engine light is flashing, a misfire condition has been detected. A misfire increases vehicle emissions and could damage the emission control system on the vehicle. Please reduce vehicle speed, avoid hard accelerations, avoid steep uphill grades, and reduce any cargo loads such as a trailer.Service within 7 days Had vehicle towed to dealership. Was repaired and picked up on 9/25/26. Paid for new battery over $400.00 On 9/29/2026 Yukon XL would not shift into reverse. The error message on the car stated. TCM - Engine and Transmission SystemP2718. Odometer: 76117 Miles
No injuries · No fire · No crash
On XXX, I was driving my 2022 GMC Yukon XL Denali equipped with the 6.2L L87 V8 engine, with my [XXX] stepson as a passenger, when the engine malfunctioned and stalled, leaving the vehicle disabled in traffic. The vehicle registered diagnostic trouble code P0016 (Crankshaft Position–Camshaft Position Correlation, Bank 1 Sensor A). Prior to this incident, the vehicle had undergone GM's L87 Engine Loss of Propulsion Safety Recall 25V-274 (GM Campaign N252494000). The vehicle passed the required engine inspection and was cleared to receive the prescribed oil viscosity change from 0W-20 to 0W-40. Under GM's recall service procedure, vehicles displaying P0016 during the inspection were required to be quarantined rather than proceeding with the oil-change remedy. Therefore, the completion of the prescribed remedy indicates that P0016 was not identified during the earlier recall screening. Despite passing GM's engine inspection and receiving the recall remedy, the engine subsequently experienced a failure involving P0016 and a complete loss of propulsion. This raises significant concerns about whether GM's inspection procedures and oil viscosity remedy adequately identify and prevent engine failures in affected vehicles. While our Yukon was disabled in traffic due to the engine stall, another motorist failed to stop and struck the vehicle from behind. The collision caused extensive damage, and the vehicle was subsequently declared a total loss. Although the other driver failed to stop, the engine failure was the initiating event that left our vehicle stranded and exposed to approaching traffic. At the time of the collision, I was [XXX] pregnant and required ambulance transportation, emergency medical evaluation, head imaging, and fetal monitoring. I subsequently experienced post-concussion symptoms and a mandibular-joint injury. My [XXX] stepson was also inside the vehicle. Vehicle can be held for inspection w/letter sent. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The component that failed was the fuel pump control module, which the dealership currently has in its possession. While driving on the interstate at 70 mph with my family of five—including three young children—the vehicle suddenly lost all motor power. This left us stranded on the shoulder for three hours waiting for a tow truck, completely without heat or AC. Once the vehicle was towed to the dealership, they confirmed the fuel pump module failure. There were no warning lamps, error messages, or prior symptoms; the engine simply stopped running. Fortunately, there were no injuries or crashes, but that was solely because I was lucky enough to safely maneuver across four lanes to the shoulder just before an exit. It was an incredibly dangerous situation that could have been much worse. I contacted GM Customer Service, but they stated they could not and would not do anything to assist with the situation. I have retained both the official dealership repair invoice confirming the failure and the tow bill from the incident.
No injuries · No fire · No crash