Bombardier Recreational Products (BRP) is recalling certain 2017-2019 Can-Am Spyder F3 and RT motorcycles. The engine output shaft may fatigue and break, resulting in a loss of drive power.
Bombardier Recreational Products, Inc. (BRP) is recalling certain 2015-2019 Can-Am Spyder F3 and RT motorcycles. The front sprocket may be defective and prematurely wear, resulting in a loss of drive power.
BRP has a recall for the output shaft for the 2018 Can Am Spyder F3T. Just after receiving the recall letter the output shaft on my Spyder went out. My bike does have more than the 37,000 miles on it. This is a known defect with this Bike. It is not right that BRP knows this part is defective and has a milage limit on it. This bike is my daily driver for work. I have contacted BRP and have been told as my bike has more miles that i am just up a creek without a paddle as I still owe more than $11,000. on this bike. I have asked for a call back and have not received any. I think this is wrong of them to put a milage cap on this part as it is designed to last the bike its lifetime. I have even told them i would cover parts if they would cover labor on this. I just really need some help with this issue. Thank You [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
No injuries · No fire · No crash
The affected part is the engine output shaft, which is part of the vehicle’s powertrain and propulsion system. BRP issued Recall 24V-728 for this defect, stating that the shaft can break and cause a sudden loss of propulsion, creating a safety hazard. I received the recall notice in April 2025 and have been unable to safely operate the vehicle since then. I contacted every authorized Can-Am dealer within 150 miles, but all confirmed they could not perform the recall repair because replacement parts were unavailable. The first available dealer, Team Mancuso Powersports Southwest, accepted the vehicle on September 23, 2025, and has now had it for over three weeks with no estimated repair date. Several dealers have indicated that this is a nationwide parts shortage, suggesting the manufacturer has not supplied recall parts to service centers. BRP Customer Relations confirmed that parts are back ordered with no ETA and cited border and customs delays as the reason. As a result, my vehicle has been inoperable for over five months, and the defect remains unresolved. The manufacturer has not provided a repair, replacement, or refund as required under federal recall law (49 U.S.C. §30120). This delay affects my safety and that of other riders since the recall defect directly impacts vehicle propulsion. I am requesting NHTSA to investigate BRP’s handling of Recall 24V-728 and ensure the manufacturer provides a timely, lawful remedy to affected owners.
No injuries · No fire · No crash
The contact owns a 2018 Can-Am Spyder RT. The contact stated that while driving at 35 MPH and attempting to upshift into the next gear, the shifter seized and failed to operate as designed. The contact pulled over, and the vehicle was towed to a local dealer, where the vehicle was diagnosed, and the contact was informed that the left shifting switch on the handlebar was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 2,200.
No injuries · No fire · No crash
My wife RODE our 2018 Can Am Spyder 70 miles to have recall 24V728 completed on 4/23/25. Today is 6/24/25 and we still do not have vehicle back. Dealership pulled engine replaced output shaft put it back together and it will now not shift correctly. Dealership has been trying to figure out the problem and in contact with BRP. At first it was something about it not accepting updated programming, then it was something about an oil pressure sensor creating the issue, and now they say it is the HCM which I believe is hydraulic control module in the transmission. On May 7th in an email from BRP Customer Service this statement below was made by the customer service representative. "I have spoken with the dealership, and they have reassured me that the new issues you've mentioned are indeed linked to the recall. They are working diligently to resolve these matters and expect your unit to be repaired by the end of this week." It is now 6/24/25 and BRP is trying to walk back the statement made above by saying it is not related to recall simply because what they think the problem is, is not an inexpensive part. Fact of the matter is it was fully functional when my wife rode it down to dealership the work was done and now the transmission will not shift properly and what they think will fix the issue just happens to be inside the transmission the dealership just had torn apart. Based on other comments from other owners of this type of vehicle I am not the first one to have problems with this recall and I don't believe BRP has a dealer network entirely capable of doing the recall, and the BRP Customer Service rep has been of little help. I do have all the emails between myself and the BRP customer service rep if needed.
No injuries · No fire · No crash
After receiving the safety recall notice from the manufacturer, BRP, in January 2025, I attempted to have the safety recall completed at a dealership in the Pittsburgh PA area. I was initially told by the MOSITES Dealership that they were not able to complete the safety recall because of the time it takes to perform the recall, which ties up their service lifts and mechanic's time. I contacted BRP, who contacted MOSITES WEST in Pittsburgh, PA, and they made a service appointment to complete the safety recall on April 3rd. I dropped the bike off for service on April 3rd. Weeks later, I was told by Gabe in the MOSITES Service Dept. they were waiting for parts and had not started the repair. I contacted BRP who verfied MOSITES West had received the parts and that MOSITES would start the repair soon. That was April 24th. I called and left message for Gabe at the MOSITES West Service Dept. in May for an update but got no return phone call. I contacted BRP and asked for an update and a possible loaner vehicle if it would take much longer, since MOSITES had my bike for more than 30 days. On May 7th, BRP advised MOSITES had not started the safety recall yet, a loaner vehicle was not possible, and MOSITES could not say when they would be able to start the recall repair.
No injuries · No fire · No crash