BMW i8 Service Bulletins
245 manufacturer communications on file.
- May 1, 2020•Document ID: 10176363Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B130420
- Date Added:
- June 15, 2020
- Manufacturer:
- BMW
SummaryTANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
Associated Products (140)Associated Documents - April 1, 2020•Document ID: 10175270Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- B122716
- Date Added:
- May 18, 2020
- Manufacturer:
- BMW
SummaryDIAGNOSING NON FUNCTIONING eDRIVE: Vehicle will not go into "eDrive". No pertinent electric drivetrain fault codes to assist with diagnosis. "eDrive" may be greyed-out in the Central Information Display (CID) and is not selectable. MSA deactivation. 12 Volt battery failure. Intelligent Battery Sensor (IBS) failure.
Associated Products (19)Associated Documents - April 1, 2020•Document ID: 10174320Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM
- Mfr Comm. #:
- B840214
- Date Added:
- April 27, 2020
- Manufacturer:
- BMW
SummaryCONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.
Associated Products (271)Associated Documents - April 1, 2020•Document ID: 10174032Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM)
- Mfr Comm. #:
- B652214
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryAUTOMATED ACTIVATION OF NAVIGATION SYSTEM DURING PDI/QC1: This Service Information Bulletin (Revision 2) replaces SI B65 22 14 dated October 2015. The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department! When the vehicle is connected to the diagnostic system ISTA to perform PDI/QC1 the step to activate the navigation system (part of Delete Transport Mode) will automatically request the INITIAL NAV enabling code (VIN-specific) without pre-ordering the enabling code. This enabling code will be automatically delivered through ISTA and it then activates the navigation system.
Associated Products (293)Associated Documents - April 1, 2020•Document ID: 10174030Service Bulletin/Repair InstructionsEQUIPMENT; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B650720
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryVEHICLE SOUND GENERATOR IS DIFFERENT AND LOUDER AFTER PROGRAMMING: Vehicles sound is different and louder after programming to an Integration level (I-level) between I001-1911-500 and I001-19-11-556. Software in the Vehicle Sound Generator (VSG).
Associated Products (13)Associated Documents - April 1, 2020•Document ID: 10174023Service Bulletin/Repair InstructionsELECTRONIC STABILITY CONTROL:AUTOMATIC (ASC); STEERING; SUSPENSION; ELECTRICAL SYSTEM
- Mfr Comm. #:
- B610920
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryCHECK CONTROL MESSAGES FOR BRAKE SUSPENSION AND AIR BAG SYSTEM MALFUNCTION: Multiple check control messages (CCM) can display for brake suspension and air bag system malfunction. The customer may also complain about any of the following: Engine can no longer be switched off Drive position (D) cannot be engaged on the gear selector switch (GWS) Reduction of steering assist After an engine emergency shut-off (either a prolonged long press; or 3 consecutive short presses of the Start/Stop button) and the vehicle going to sleep (identifiable by the lighting of the "Start/Stop button") everything resumes normal functionality and the CCM messages no longer appear.
Associated Products (30)Associated Documents - April 1, 2020•Document ID: 10174019Service Bulletin/Repair InstructionsENGINE
- Mfr Comm. #:
- B610520
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryCCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
Associated Products (137)Associated Documents - April 1, 2020•Document ID: 10174015Service Bulletin/Repair InstructionsPARKING BRAKE; AIR BAGS
- Mfr Comm. #:
- B513016
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryTAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
Associated Products (259)Associated Documents - April 1, 2020•Document ID: 10174009Service Bulletin/Repair InstructionsBACK OVER PREVENTION; POWER TRAIN; SERVICE BRAKES, HYDRAULIC; WHEELS
- Mfr Comm. #:
- B340517
- Date Added:
- April 20, 2020
- Manufacturer:
- BMW
SummaryTICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
Associated Products (218)Associated Documents - February 1, 2020•Document ID: 10172510Service Bulletin/Repair InstructionsSEAT BELTS
- Mfr Comm. #:
- B720220
- Date Added:
- March 16, 2020
- Manufacturer:
- BMW
SummarySAFETY BELT WARNING GONG SOUNDS AFTER UNBUCKLING WHILE VEHICLE IS STATIONARY. After a vehicle has been programmed to an I-level greater than 19-11-5xx and lower than I-level 20-03-530; the safety belt (aka seat belt) acoustic warning sounds when in Park (engine running) and the safety belt is unbuckled. The chime/gong lasts for up to 1 minute 40 seconds. The customer only expects the acoustic warning when the vehicle is moving and the safety belt is not buckled. The acoustic warning can occur when the seat is occupied and the safety belt buckle is opened on the driver's or passenger's side. Software in the ACSM4 Control Unit.
Associated Products (17)Associated Documents - February 1, 2020•Document ID: 10172497Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B610520
- Date Added:
- March 16, 2020
- Manufacturer:
- BMW
SummaryCCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
Associated Products (138)Associated Documents - November 1, 2019•Document ID: 10169468Service Bulletin/Repair InstructionsEQUIPMENT; VISIBILITY:WINDSHIELD WIPER/WASHER
- Mfr Comm. #:
- B612315
- Date Added:
- December 16, 2019
- Manufacturer:
- BMW
SummaryLow Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full : The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch. A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain a silicone additive are normally colored other than blue.
Associated Products (105)Associated Documents - November 1, 2019•Document ID: 10169461Service Bulletin/Repair InstructionsWHEELS; EQUIPMENT
- Mfr Comm. #:
- B360519
- Date Added:
- December 16, 2019
- Manufacturer:
- BMW
SummarySERVICE ACTION: INSPECT THE RIGHT REAR WHEEL RIM AND REPLACE IF NECESSARY. Vehicles delivered with wheel rim style 470 (shown) have directional wheels specifically for the left and right side of the vehicle. An incorrect heat treatment has been applied to batches of the right rear rim and may have a crack in the spoke of the wheel rim. Visual or audible perceptions may be noted by the customer. Error in the manufacturing process of the right rear wheel rim.
Associated Products (5)Associated Documents - October 1, 2019•Document ID: 10167997Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM
- Mfr Comm. #:
- B513119
- Date Added:
- November 18, 2019
- Manufacturer:
- BMW
SummaryDOOR WILL NOT OPEN OR CLOSE. One or both doors will not open or close (latch/unlatch). Low voltage supply of the vehicle 12 V battery or the key fob battery may cause the door lock actuator to become temporarily electrically faulted.
Associated Products (5)Associated Documents - September 1, 2019•Document ID: 10166392Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; ELECTRICAL SYSTEM:WIRING; SEATS
- Mfr Comm. #:
- B651819
- Date Added:
- October 21, 2019
- Manufacturer:
- BMW
SummaryWHIRRING NOISE IN VEHICLE HEARD BETWEEN THE SUBWOOFERS WHEN LOUD MUSIC PLAYING: The customer states that there are whirring noises heard from behind the front seats when loud music is playing. It is heard coming from between the two subwoofers, behind the rear cupholder.
Associated Products (1)Associated Documents - September 1, 2019•Document ID: 10166390Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:12V/24V/48V BATTERY; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B651419
- Date Added:
- October 21, 2019
- Manufacturer:
- BMW
SummaryHEAD UNIT NBT EVO (HU-H2) PROGRAMMING ABORT: The CID screen may light up blue. When this occurs A battery reset is not successful in restoring head unit operation Software error in the Bootloader file (BTLD) of the head unit.
Associated Products (92)Associated Documents - August 1, 2019•Document ID: 10165283Service Bulletin/Repair InstructionsVISIBILITY
- Mfr Comm. #:
- B511819
- Date Added:
- September 23, 2019
- Manufacturer:
- BMW
SummaryREAR GLASS WINDOW DOES NOT FULLY OPEN. When opening the rear glass window to access the luggage compartment the lid will release but will not open high enough to grasp the window completely by hand. The lock pin is contaminated.
Associated Products (5)Associated Documents - August 1, 2019•Document ID: 10165266Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- B651519
- Date Added:
- September 23, 2019
- Manufacturer:
- BMW
SummarySECURITY IMPROVEMENTS FOR CONNECTEDDRIVE. Security patches for non-safety critical vulnerabilities in BMW head units Entry Nav Entry Media NBT and NBT EVO.
Associated Products (199)Associated Documents - July 1, 2019•Document ID: 10163995Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT:ELECTRICAL; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR
- Mfr Comm. #:
- B122319
- Date Added:
- August 19, 2019
- Manufacturer:
- BMW
SummaryDIAGNOSTIC HINT: CATALYTIC CONVERTER INSPECTION AFTER LOSS OF CRANKSHAFT SIGNAL. In certain situations when the crankshaft position signal is lost while driving the malfunction indicator lamp (MIL) and an engine malfunction check control message (CCM #29) may be displayed. The engine may run roughly or with reduced power.
Associated Products (165)Associated Documents - June 1, 2019•Document ID: 10163056Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B651419
- Date Added:
- July 22, 2019
- Manufacturer:
- BMW
SummaryHEAD UNIT NBT EVO (HU-H2) PROGRAMMING ABORT. During programming several aborts can occur in the head unit NBT EVO (HU-H2).
Associated Products (98)Associated Documents