2021-2025 Jeep Compass Stabilizer Bar Link Service

Important Service Information for Jeep Compass Stabilizer Bar Links

This manufacturer communication, identified as TSB 9004338, provides essential guidance for technicians and owners regarding the servicing and replacement of stabilizer bar links on certain Jeep Compass models. Specifically, it applies to vehicles built before January 4, 2021, covering model years 2021 through 2025. The primary focus is to ensure proper component selection during any repair involving the Jeep Compass stabilizer bar links.

When replacement of the stabilizer bar links is necessary, the bulletin stresses the importance of using only metal-ended components. This directive is critical for maintaining the vehicle's suspension integrity and performance. Owners of affected Jeep Compass vehicles should be aware of these specific requirements when their vehicle undergoes service.

What Owners Should Know

For 2021-2025 Jeep Compass owners, understanding this service bulletin is key, especially if your vehicle was manufactured prior to January 4, 2021. The most critical instruction is to "Do not mix metal and plastic ends on same bar." This means that if any stabilizer bar links are being replaced, both ends of the new link must be made of metal. Furthermore, if an existing metal end is being replaced, only that specific end can be substituted with a new metal end. This prevents incompatible materials from being used together on the same stabilizer bar, which could lead to unforeseen issues with your Jeep Compass stabilizer bar links.

Adhering to these guidelines ensures that the suspension system operates as intended. Incorrectly mixed components could potentially compromise the stability and handling characteristics of your Jeep Compass, leading to reduced ride quality or premature wear of suspension components. It is crucial to discuss these specific instructions with your service technician to confirm proper repair procedures are followed.

Repair Procedure Guidelines

When servicing the stabilizer bar links on affected Jeep Compass vehicles, technicians must follow specific guidelines to ensure correct component installation and vehicle safety. The core instruction is that if stabilizer bar links need to be replaced, technicians must "make sure both ends are metal." This means that any replacement link kit should feature metal ends.

A critical warning from the manufacturer states, "Do not mix metal and plastic ends on same bar." This implies that both the left and right stabilizer bar links on a single axle must be consistent in their material type. If a vehicle currently has mixed components (e.g., one metal-ended link and one plastic-ended link), both should be replaced with all-metal links to comply with this directive. Additionally, the bulletin clarifies, "If replacing existing metal end, only that end can be replaced with new metal end." This indicates that if an all-metal setup is already present and only one side requires replacement, it can be replaced with a new metal-ended link, maintaining the all-metal configuration.

Part Numbers Involved

This service bulletin references specific part numbers for the stabilizer bar link kits. These part numbers are crucial for ensuring that the correct, compliant components are used during any service procedure. The identified part numbers for the "LINK KIT, Stabilizer Bar" are:

• 68498190AS
• 68498191AS
• 68498192AS

Owners should ensure that if replacement parts are needed, these specific part numbers or their approved equivalents are utilized to guarantee compatibility and adherence to the manufacturer's guidelines for Jeep Compass stabilizer bar links.

Source

NHTSA ID: 9004338