Mazda CX-3 Service Bulletins
275 manufacturer communications on file.
- November 22, 2022•Document ID: 10226834Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-018-22b
- Date Added:
- December 2, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 74.00.324 or later). The system performance has been improved as follows: Ver. 74.00.324 fixes these software errors (bugs): * If the shift lever is operated quickly while displaying the CarPlayTM screen, the rear view screen may not return to the CarPlayTM screen. * When the gear position is shifted into P from R, the screen may not return to the previous condition before shifting into the R position.
Associated Products (12)Associated Documents - November 21, 2022•Document ID: 10226914Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:INFOTAINMENT:VIDEO (TOUCH)SCREEN/MONITOR/UNIT
- Mfr Comm. #:
- 22-01R
- Date Added:
- December 2, 2022
- Manufacturer:
- MAZDA
SummaryRepair kits are available to replace just the screen. There is no need to replace the entire infotainment display unit as the supply chain has been heavily impacted due to the global shortage of semiconductors. Please use the table below when ordering the screen repair kits. This can also be found in Service Alert SA-041/22.
Associated Products (5)Associated Documents - November 18, 2022•Document ID: 10226814Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- 02-004-22a
- Date Added:
- December 2, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.
Associated Products (18)Associated Documents - November 14, 2022•Document ID: 10226924Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-075-22
- Date Added:
- December 2, 2022
- Manufacturer:
- MAZDA
SummaryIf you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal MGSS diagnosis by asking if any aftermarket devices have been installed. Aftermarket devices may be the cause of the electrical concern. Below are a few examples of unusual electrical concerns caused by aftermarket devices. Examples: 1. Devices connected to the DLC-2 (battery discharge/DTC stored) 2. Cell phone charger/accessory in 12V socket (engine no start or unable to turn off) 3. GPS tracking device (engine no start/battery discharge) 4. Dash cam (DTC stored) 5. Non-certified USB cable (Apple CarplayâÃÂâ/ Android AutoâÃÂâ will not connect) 6. Over-sized wheels/tires (incorrect GPS location)
Associated Products (19)Associated Documents - November 14, 2022•Document ID: 10226923Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM
- Mfr Comm. #:
- SA-074-22
- Date Added:
- December 2, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain the HVAC system not maintaining the correct temperature or the ambient (outside) temperature reading incorrectly. This is caused by a failure in the ambient temperature sensor. To correct this issue, the ambient temperature sensor has been modified.
Associated Products (12)Associated Documents - October 19, 2022•Document ID: 10225776Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 01-013-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome customers may experience the CHECK ENGINE light ON with DTC P0126:00 (Thermostat stuck open) and one or more of the following symptoms: * The engine takes longer to warm up * The engine temperature gauge fluctuates * The low coolant temperature indicator (blue) light stays on longer or comes on while driving * Poor heater performance, especially at idle NOTE: * Vehicles with SKYACTIV-G 2.5T are not applicable. * If DTC P2B61:00 (Coolant control valve circuit range/performance) accompanies, this information is not applicable. Diagnose according to the instructions in MGSS. Due to production variety of the failsafe thermostat integrated in the coolant control valve, engine coolant may enter into a dry hollow in the failsafe thermostat, resulting in unintended opening of the failsafe thermostat at lower temperatures (104-176 ðF (40-80 ðC)). To eliminate this concern, the production process of the coolant control valve has been modified.
Associated Products (5)Associated Documents - October 17, 2022•Document ID: 10225767Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- SA-068-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummaryThe new SKYACTIV-DRIVE FW6A-EL AT uses "Automatic Transmission Fluid (ATF) Type: FZ". Only use "ATF-FZ" to fill or top off the fluid level. ATF-FZ is specially designed for use in the SKYACTIV-DRIVE series AT. It is a low viscosity formula with less friction for better fuel economy. NOTE: ATF-FZ is colored blue for easy identification.
Associated Products (16)Associated Documents - October 17, 2022•Document ID: 10225724Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- SA-008-22a
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience exterior trim heat damage when parked near a glass building or Low-E windows. This may be caused by the sun's reflection.
Associated Products (19)Associated Documents - October 12, 2022•Document ID: 10225763Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-067-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about the following message displayed in the Multi-Information Display: In the following cases, the MRCC with Stop & Go function system is canceled when the vehicle is traveling at 19 mph (30 km/h) or less: * The Forward Sensing Camera (FSC) cannot detect target objects due to one of the following: - The windshield is dirty - The FSC lens is foggy - There is low visibility due to rain, fog or snow - It is at night and there is not enough light - There is direct or reflected sunlight on the FSC - There is problem with the FSC * There is a problem with the AUTOHOLD control function. * There is a problem with the electric parking brake (EPB).
Associated Products (15)Associated Documents - October 12, 2022•Document ID: 10225761Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-066-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may have one of the following DTCs stored in memory along with a system status notice on the Multi-information display OR display a system status notice with no DTC: * C1001:92 - Forward sensing camera (FSC) poor field of view [Gen 6 vehicles] * B14F0:92 - General temporary failure in forward sensing camera (FSC) [Gen 7 vehicles built on or before March 2, 2019] * No DTC - Warning Message only [Gen 7 vehicles built after March 2, 2019] DTC C1001:92 or B14F0:92 set as a past record for low visibility of the Forward Sensing Camera (FSC). It does not mean there is an actual FSC defect. * In some cases the customer may have a concern with the Lane Departure Warning System (LDWS) and/or High Beam Control system (HBC). * In other cases this DTC might be found without a related customer concern. NOTE: In most cases, no dealer visit is necessary.
Associated Products (18)Associated Documents - October 11, 2022•Document ID: 10225783Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-041-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummaryIf the right-side Blind Spot Monitoring (BSM) control module is replaced for any reason, it is also necessary to replace the left-side BSM control module in order to complete the radar aiming procedure. If the right-side BSM control module is replaced alone, "Automatic Configuration" and "BSM Radar Aiming" cannot be completed due to a programming error in the module. Other possible symptoms that may be found if the right-side BSM module is replaced alone: * BSM aiming fails * "BSM OFF" indicator ON * Center Display warning message * BSM failsafe (No operation) * DTC U3000:54 stored in memory * DTC U1A4B:54 stored in memory (CX-3, MX-5 only)
Associated Products (4)Associated Documents - October 10, 2022•Document ID: 10225751Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- SA-065-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles equipped with a coolant control valve may exhibit difficulties when refilling the coolant because the control valve is closed and air in the engine cannot escape during ignition ON. Therefore, turn the ignition OFF when refilling engine coolant using the radiator filler neck.
Associated Products (11)Associated Documents - October 6, 2022•Document ID: 10225774Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 01-012-22
- Date Added:
- November 4, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may exhibit accumulation of dried coolant (1) around the water pipe (2). This is caused by a gap between the housing and pipe due to a press fitting during the manufacturing process. The accumulated coolant is solidified and plugs the gap in high temperature environment and the seepage is stopped and does not progress. This is normal and does not require a part replacement, clean off the dried coolant from around the pipe with a wire brush.
Associated Products (8)Associated Documents - September 26, 2022•Document ID: 10222564Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- 01-010-22
- Date Added:
- October 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may experience a squeaking noise may be heard from the exhaust manifold when the idle speed drops from fast idle to normal idle speed during cold start. This is caused by a variable valve being stuck in the closed position. When returning from fast idle to normal, the stuck valve suddenly opens due to thermal change around it which causes abnormal noise. To eliminate this concern, the internal design of the exhaust manifold has been modified.
Associated Products (3)Associated Documents - September 13, 2022•Document ID: 10222560Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:INFOTAINMENT:VIDEO (TOUCH)SCREEN/MONITOR/UNIT; ELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-041-22c
- Date Added:
- October 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about infotainment center display: - Ghost Touch (Touch screen operates by itself) - Spider Cracks - Surface Peeling - White dots
Associated Products (5)Associated Documents - September 13, 2022•Document ID: 10222452Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:INFOTAINMENT:VIDEO (TOUCH)SCREEN/MONITOR/UNIT; ELECTRICAL SYSTEM
- Mfr Comm. #:
- RF-22-01
- Date Added:
- October 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about infotainment center display ghost touch (touch screen operates by itself), surface peeling or spider cracks. Repair kits are available to replace just the screen. There is no need to replace the entire infotainment display unit as the supply chain has been heavily impacted due to the global shortage of semiconductors.
Associated Products (5)Associated Documents - September 9, 2022•Document ID: 10222575Service Bulletin/Repair InstructionsEQUIPMENT; EQUIPMENT:ELECTRICAL:INFOTAINMENT:VIDEO (TOUCH)SCREEN/MONITOR/UNIT
- Mfr Comm. #:
- 09-036-22
- Date Added:
- October 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about infotainment center display: - Center display touchscreen operates by itself (Ghost Touch). - The film of the center display may be peeled off. - White dots may appear on the center display
Associated Products (4)Associated Documents - August 9, 2022•Document ID: 10218720Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-001-22d
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummaryUse the symptom troubleshooting tables below to diagnose MAZDA CONNECT concerns.
Associated Products (4)Associated Documents - August 1, 2022•Document ID: 10218719Service Bulletin/Repair InstructionsLATCHES/LOCKS/LINKAGES
- Mfr Comm. #:
- SA-050-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain that their liftgate does not open. This can mean a range of things, from the liftgate not unlatching to the power liftgate (PLG) not opening automatically. If you confirm that the customer's concern is that the liftgate does not unlatch correctly, follow the repair information below
Associated Products (9)Associated Documents - July 18, 2022•Document ID: 10217209Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:INSTRUMENT PANEL:SPEEDOMETER/ODOMETER
- Mfr Comm. #:
- 09-024-22
- Date Added:
- August 4, 2022
- Manufacturer:
- MAZDA
SummaryIn accordance with Federal regulations, follow the procedure listed below when replacing a speedometer.
Associated Products (8)Associated Documents