Mazda CX-3 Service Bulletins
275 manufacturer communications on file.
- June 1, 2021•Document ID: 10198574Service Bulletin/Repair InstructionsVISIBILITY:POWER WINDOW DEVICES AND CONTROLS
- Mfr Comm. #:
- MT-003-21
- Date Added:
- June 29, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may experience exterior trim heat damage when parked near a glass building. This may be caused by the suns reflection. If a building creates enough of a curve with a series of flat windows, which act like mirrors, the reflections all converge at one point, focusing and concentrating the light onto the street below.
Associated Products (8)Associated Documents - May 24, 2021•Document ID: 10194654Service Bulletin/Repair InstructionsVISIBILITY; UNKNOWN OR OTHER
- Mfr Comm. #:
- 09-014-21-3802
- Date Added:
- June 1, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may exhibit a crack in the lower center area of the windshield. This may be caused by fixtures located at the center of the cowl grille, which result in higher pressures applied to the windshield. When small pebbles/rocks are caught between the cowl grille and the windshield, deep scratches can lead to a crack in the windshield. To prevent this concern in the future, the cowl grille will be modified to reduce the pressure to the windshield.
Associated Products (1)Associated Documents - May 18, 2021•Document ID: 10194887Service Bulletin/Repair InstructionsLANE DEPARTURE; FORWARD COLLISION AVOIDANCE; EXTERIOR LIGHTING; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- SA-036-21
- Date Added:
- June 3, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may have one of the following DTCs stored in memory along with a system status notice on the Multi-information display OR display a system status notice with no DTC: C1001:92 - Forward sensing camera (FSC) poor field of view [Gen 6 vehicles], B14F0:92 - General temporary failure in forward sensing camera (FSC) [Gen 7 vehicles build on or before March 2, 2019], No DTC - Gen 7 vehicles built after March 2, 2019, DTC C1001:92 or B14F0:92 set as a past record for low visibility of the Forward Sensing Camera (FSC). It does not mean there is an actual FSC defect. In some cases the customer may have a concern with the Lane Departure Warning System (LDWS) and/or High Beam Control system (HBC). In other cases this DTC might be found without a related customer concern.
Associated Products (7)Associated Documents - May 13, 2021•Document ID: 10194891Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- SA-034-21
- Date Added:
- June 3, 2021
- Manufacturer:
- MAZDA
SummaryWhen performing vehicle services such as control unit software update, control unit registration/activation, CMU log data retrieval, etc., always use the DCA8000 OR GR8 battery charger SST to maintain battery voltage.
Associated Products (7)Associated Documents - May 11, 2021•Document ID: 10194782Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- SA-033-21
- Date Added:
- June 2, 2021
- Manufacturer:
- MAZDA
SummaryThe rear differential case could develop a crack in the case, as shown below. NOTE: This could affect new vehicles just delivered to the dealer as well as customer vehicles.
Associated Products (5)Associated Documents - May 11, 2021•Document ID: 10194714Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- SA-032-21
- Date Added:
- June 3, 2021
- Manufacturer:
- MAZDA
SummaryThere have been warranty claims submitted for growling or bearing whine noise in differentials, transfer units and transmissions where the source of the noise was a wheel bearing. This misdiagnosis can lead to multiple repair attempts, warranty debits, and additional inconvenience and/or cost to the customer. To reduce the chance of this occurring, please follow the steps outlined in the repair procedure.
Associated Products (8)Associated Documents - May 7, 2021•Document ID: 10194659Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- MT-002-21
- Date Added:
- June 1, 2021
- Manufacturer:
- MAZDA
SummaryWhen programming a key or installing a Genuine Mazda Accessory Remote Engine Start system, you may encounter programming difficulty. This may be caused by a customer installed aftermarket decorative trim and/or cover on the START/STOP ENGINE button. The aftermarket accessory may create electrical interference, which may interfere with programming.
Associated Products (7)Associated Documents - May 4, 2021•Document ID: 10194762Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- SA-030-21
- Date Added:
- June 2, 2021
- Manufacturer:
- MAZDA
SummaryAuxiliary key blank cutting procedure: There are currently 2 methods for cutting a new auxiliary key blank. A. Auxiliary Key Trace Cut Method, B. Auxiliary Key Code Cut Method
Associated Products (7)Associated Documents - April 26, 2021•Document ID: 10191538Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- SA-029-21
- Date Added:
- May 4, 2021
- Manufacturer:
- MAZDA
SummaryAPPLE CARPLAY / ANDRID AURO FREQUENTLY ASKED QUESTIONS (FAQ) The following vehicles are not equipped with Apple CarPlay⢠/ Android Autoâ¢, but it can be activated using MDARS. See Activation instructions on MGSS -> Infotainment -> MAZDA CONNECT Updates -> Apple Carplay / Android Auto MDARS Activation Instructions
Associated Products (7)Associated Documents - April 22, 2021•Document ID: 10190956Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 01-011-21-3800
- Date Added:
- April 26, 2021
- Manufacturer:
- MAZDA
SummarySome customers may experience the CHECK ENGINE light ON with DTC P0126:00 (Thermostat stuck open) and one or more of the following symptoms: The engine takes longer to warm up, The engine temperature gauge fluctuates, The low coolant temperature indicator (blue) light stays on longer or comes on while driving, Poor heater performance, especially at idle. NOTE: Vehicles with SKYACTIV-G 2.5T are not applicable. Due to production variety of the failsafe thermostat integrated in the coolant control valve, engine coolant may enter into a dry hollow in the failsafe thermostat, resulting in unintended opening of the failsafe thermostat at lower temperatures (104-176 ðF (40-80 ðC)). To eliminate this concern, the production process of the coolant control valve has been modified.
Associated Products (4)Associated Documents - April 8, 2021•Document ID: 10190971Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- SA-019-21a
- Date Added:
- April 26, 2021
- Manufacturer:
- MAZDA
SummaryMAZDA CONNECT Symptom Troubleshooting (6th Generation Vehicles). Use the symptom troubleshooting tables below to diagnose MAZDA CONNECT concerns.
Associated Products (3)Associated Documents - March 15, 2021•Document ID: 10189797Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- MT-001-21
- Date Added:
- April 5, 2021
- Manufacturer:
- MAZDA
SummaryIf you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal Workshop Manual diagnosis. Aftermarket devices may be the cause of the electrical concern. Ask the customer if any aftermarket devices have been installed.
Associated Products (7)Associated Documents - March 12, 2021•Document ID: 10189816Service Bulletin/Repair InstructionsSTEERING
- Mfr Comm. #:
- 06-002-21-3782
- Date Added:
- April 5, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may exhibit wear/peel-off of the leather steering wheel surface causing a poor appearance. This concern may be caused by an insufficient wear resistance of the steering wheel surface.
Associated Products (1)Associated Documents - February 8, 2021•Document ID: 10188016Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 01-006-21-3779
- Date Added:
- March 3, 2021
- Manufacturer:
- MAZDA
SummaryThis service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
Associated Products (8)Associated Documents - February 8, 2021•Document ID: 10188015Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 01-005-21-3778
- Date Added:
- March 3, 2021
- Manufacturer:
- MAZDA
SummaryThe Mazda DCA-8000PM is required for all warranty battery testing. If the Mazda DCA-8000PM is not used, incorrect battery testing may result in unnecessary battery replacement. Use the following test procedures in this Service Bulletin to test Mazda vehicle batteries and to generate a Warranty Code.
Associated Products (8)Associated Documents - January 26, 2021•Document ID: 10186701Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 07-001-21-3775
- Date Added:
- February 5, 2021
- Manufacturer:
- MAZDA
SummaryA musty/mildew type odor may come from the vents when the air conditioning (A/C) system is operating. It is most noticeable when the A/C is first turned ON. This odor is the result of mold growth in the A/C evaporator/cooling unit which is caused by condensation, dust, and pollen within the cooling unit. This condition is usually worse during high humidity conditions. âÂÂMazda Air Cooling Coil Coatingâ is available to encapsulate the mold to reduce odors. If the product is properly applied, it can effectively reduce the musty/mildew odor for up to three years.
Associated Products (7)Associated Documents - January 26, 2021•Document ID: 10186699Service Bulletin/Repair InstructionsSTEERING
- Mfr Comm. #:
- 02-003-21-3777
- Date Added:
- February 5, 2021
- Manufacturer:
- MAZDA
SummarySome customers may complain that the steering wheel is off center more than 3ð even when driving straight on a flat road.
Associated Products (7)Associated Documents - January 26, 2021•Document ID: 10186696Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 01-003-21-3776
- Date Added:
- February 5, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the CHECK ENGINE LIGHT ON with DTC P2610 and P2507 stored in memory after engine start and room fuse 15A (A) removed. P2610:00: Instrument cluster internal engine off timer performance problem. P2507:00: PCM battery voltage low input
Associated Products (5)Associated Documents - January 21, 2021•Document ID: 10186705Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 09-004-21-3772
- Date Added:
- February 5, 2021
- Manufacturer:
- MAZDA
SummarySome vehicles may experience stains appearing on the hood, roof and/or trunk of the vehicle. This concern is most likely to be found in a cold weather areas just after the RAPGARD is removed at PDI. This may be caused by moisture which has been trapped and condensed between the paint and the RAPGARD. These types of stains can be removed with a heat gun or an infrared drier.
Associated Products (7)Associated Documents - January 21, 2021•Document ID: 10186704Service Bulletin/Repair InstructionsSTRUCTURE:BODY
- Mfr Comm. #:
- 09-003-21-3771
- Date Added:
- February 5, 2021
- Manufacturer:
- MAZDA
SummaryWhen encountering a vehicle with paint damage, refer to the "Mazda Paint Warranty Guide" to determine cause, prevention, remedy, and warranty coverage (if applicable).
Associated Products (7)Associated Documents