Jeep Grand Cherokee Recalls

148 recalls on file.

• Recall97V039000March 17, 1997
  ELECTRICAL SYSTEM:WIRING

  VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH MEMORY SEAT OPTION. THE MEMORY SEAT MODULE WIRING HARNESS CAN COME IN CONTACT WITH THE SEAT SPRING, A LOW RESISTANCE SHORT CIRCUIT CAN DEVELOP RESULTING IN LOCALIZED HEATING.

  Remedy

  DEALERS WILL RELOCATE THE MEMORY SEAT CONTROL MODULE AND WIRING HARNESS AND A PROTECTIVE SHIELD WILL BE INSTALLED ON THE SEAT FRAME.

• Recall96I004000January 1, 1996
  SEAT BELTS:REAR/OTHER

  THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CENTER REAR SEAT BELT BUCKLE MAY NOT BE ACCESSIBLE WHEN THE RIGHT (PASSENGER) SIDE OF THE REAR SEAT BACK IS FOLDED DOWN IN THE CARGO STOWAGE POSITION.

  Remedy

  DEALERS WILL REPLACE THE SEAT BELT BUCKLE ASSEMBLY.

• Recall95V193000October 11, 1995
  ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS

  THE FASTENERS WHICH SECURE THE ALTERNATOR CIRCUIT FUSE TO THE POWER DISTRIBUTION CENTER MAY HAVE AN IMPROPER CLAMP LOAD.

  Remedy

  DEALERS WILL REPLACE THE ALTERNATOR FUSE WITH A FUSE LINK AND ANY DAMAGE TO THE POWER DISTRIBUTION CENTER WILL BE REPAIRED.

• Recall95V172000September 12, 1995
  PARKING BRAKE:CONVENTIONAL:MECHANICAL

  THE PARKING BRAKE HANDLE RELEASE BUTTON CAN SEPARATE FROM THE PARKING BRAKE HANDLE ASSEMBLY, CAUSING THE PARKING BRAKE TO BE INOPERATIVE.

  Remedy

  DEALERS WILL REPLACE THE PARKING BRAKE HANDLE ASSEMBLY.

• Recall93V210000December 13, 1993
  STEERING: STEERING WHEEL/HANDLE BAR

  THE MOLDED PLASTIC PIN WHICH CONNECTS THE UPPER STEERING COLUMN SHAFT AND THE LOWER COLUMN SHAFT MAY HAVE BEEN SHEARED PRIOR TO INSTALLATION OF THE STEERING COLUMN ASSEMBLY INTO THE VEHICLE. IF THIS OCCURRED, THE UPPER STEERING SHAFT WILL SEPARATE FROM THE LOWER STEERING SHAFT.

  Remedy

  A RESTRAINING SLEEVE WILL BE ADDED TO THE INTERMEDIATE SHAFT TO LIMIT THE AMOUNT OF STEERING SHAFT MOVEMENT AVAILABLE.

• Recall93V055000April 8, 1993
  STRUCTURE:BODY:HATCHBACK/LIFTGATE

  GREASE APPLIED TO THE LIFTGATE LATCH RUBBER BUMPERS TO EASE COMPONENT ASSEMBLY CAUSED THE BUMPER TO SWELL, INTERFERING WITH THE MOVEMENT OF THE LIFTGATE LATCH PAWL. THIS PREVENTS THE LIFTGATE LATCHING WHEN CLOSED AND DIFFICULT TO OPEN WHEN LATCHED.

  Remedy

  REPLACE THE LIFTGATE ASSEMBLY ON AFFECTED VEHICLES.

• Recall93V051000April 2, 1993
  SUSPENSION:FRONT

  THE ECCENTRIC CAM ADJUSTER BOLTS IN BOTH FRONT LOWER SUSPENSION ARM-TO-FRONT AXLE BRACKET ATTACHMENTS MAY FAIL DUE TO ASSEMBLY MISALIGNMENT.

  Remedy

  REPLACE THE FRONT SUSPENSION CAM BOLTS, CAM WASHERS, AND NUTS WITH COMPONENTS OF A DIFFERENT DESIGN.

• Recall92V181000December 14, 1992
  SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES

  THE RETAINER CLIP WHICH SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL WAS NOT INSTALLED PROPERLY, AND COULD WORK LOOSE.

  Remedy

  IMPROPERLY INSTALLED RETAINER CLIPS WILL BE REMOVED AND NEW RETAINER CLIPS WILL BE PROPERLY INSTALLED.