Hyundai Kona N Complaints

11 consumer complaints on file.

#11685374September 5, 2025
FUEL/PROPULSION SYSTEM
There would be a stumble when accelerating up to highway speeds at random times. During acceleration on a highway on August 30, 2025, that stumble became constant and the engine light came on. Exhaust sounds was no longer smooth and constant but rather a constant sputter. Greater vibration was felt in the car anytime the accelerator was depressed. Pulled off the highway and can visually see the motor vibrating significantly. When accelerating from a stop or crawling speed, it struggles to move and I can feel the resistance of the car not wanting to accelerate. Auto parts store scanned the code and it came back as a misfire in cylinder 3. Concerned about engine damage, being stranded, or causing an accident, the car was dropped it off at the Hyundai dealership. At that time (around 2pm) I was far from home and the service center was closed. On 9/5/2025 I was notified that the fuel injectors will need to be replaced and they are currently on order.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11658727May 4, 2025
ELECTRICAL SYSTEM, ENGINE, UNKNOWN OR OTHER
Knock sensor code P1326 has set my car into limp mode twice from getting wet after a car wash once and the other driving on a rainy day. Both times the dealership has replaced the knock sensor. The car suddenly loosing power on the highway going 65pmh and stock at only able 2k rpm is not safe. It's a known issues that yet to receive a recall or at least permanent fix.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11612226September 3, 2024
ENGINE, POWER TRAIN, ELECTRICAL SYSTEM
While driving after a recent car wash, my car entered limp mode, limiting the engine to 2000 RPM. Multiple warning lights for electrical, safety, and engine issues appeared on the dashboard, and the error code P211800 was displayed. Despite being inspected at the dealership, the issue couldn’t be reproduced, and the error code disappeared. This problem has occurred twice, but each time the dealership was unable to identify the cause since the error code was no longer present.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11612224September 3, 2024
ENGINE, POWER TRAIN
While driving on the interstate, the car went into limp mode (does not rev above 2000 rpm). I was unable to maintain speed or merge back into interstate. The dealership has inspected the vehicle, however, they confirm everything is normal. The car did give an engine error code of P132600 for Powertrain. This is the second time this issue has occurred, the dealership replaced the knock sensor the first time.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11604280July 24, 2024
FUEL SYSTEM, GASOLINE
The contact owns a 2022 Hyundai Kona N. The contact received notification of NHTSA Campaign Number: 24V528000 (Fuel System, Gasoline) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time. The contact stated while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was restarted; however, the failure recurred. The dealer was contacted but the vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 22,000. VIN tool confirms part not available.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11576498March 10, 2024
ENGINE
The knock sensor on the engine fails when exposed to any amount of water. The car is designed in a way that lets on too much. It’s something that is VERY common amongst owners of these vehicles. It’s a safety flaw that needs to be fixed because it puts the car in “limp” mode. That makes the car instantly halt acceleration. Please hold Hyundai accountable
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11576357March 9, 2024
ENGINE, POWER TRAIN, ELECTRICAL SYSTEM
After washing my '23 Kona N in a hand car wash, I experienced a sudden, complete loss of power as I was pulling into traffic immediately afterwards, nearly resulting in a rear-end collision. There was a flashing check engine light (CEL or MIL) on the dash, and I had to have the vehicle towed to a dealership. The stored OBD-II code is P132600 (knock sensor). The car has only 16k miles on it. This is a KNOWN ISSUE, and there are complaints about it all over Reddit, Facebook, and other Internet sites, and it also affects the same generation Elantra N. This issue can occur ANY TIME THE VEHICLE GETS WET. It is unacceptable that simply washing my car or driving my vehicle in the rain can cause me to lose all power and create an unsafe driving condition. PLEASE compel Hyundai to address this safety issue with a recall.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11565587January 15, 2024
WHEELS, ELECTRICAL SYSTEM
I bought a used from Route46Nissan. Horn wasn't working when I bought the car and battery was also dead which I had to pay out of pocket to replace. I realized that two tires have side bubbles and which is extremely unsafe which they sold the car like that with security issues. They sold me a warranty and they are not keeping their promises for the stuff that they need to fix
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11557297November 28, 2023
SUSPENSION, STEERING, UNKNOWN OR OTHER
Car tends to jerk and almost jump when first pulling out of almost anywhere. Seems to have happened with other people with the same car. When you turn after pulling out sometimes, the car will jump and the suspension sounds like it’s jumping. The particular issue makes it hard to steer and can easily make the car lose control for anyone not experienced.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11548884October 8, 2023
ELECTRICAL SYSTEM, UNKNOWN OR OTHER
Horn stopped functioning
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11544297September 13, 2023
ENGINE
I took my vehicle through a touch free car wash. After the wash the vehicle sat for about 10 to 20 minutes while I dried off the exterior and cleaned out my interior. After leaving the car wash the car made it less than a mile down the road and illuminated a flashing check engine light with a P132600 code implying a connection rod failure detected by the knock sensor. As of time of reporting the vehicle is still waiting to be serviced by the dealership as it is still under warranty. Safety can be impacted as the vehicle will immediately go into limp mode, throttling performance.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0

← Back to Hyundai Kona N