BMW 328d Service Bulletins
538 manufacturer communications on file.
- November 1, 2015•Document ID: 10147832Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:APPLIANCE:AIR CONDITIONER; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B640613
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryA/C Cooling: Intermittent Reduction of Air Flow. Customer may complain of reduced air flow when the air conditioning system is operated for an extended time, usually longer than 30 minutes. INFORMATION Possibility of reproducing this situation is improved by the following conditions ? High outside ambient temperature ? High humidity Note: It is very difficult to duplicate this issue. The fault may be reproduced under the following conditions: ? Air-conditioning system switched on ? Driving Experience switch NOT set to Eco Pro ? Slower fan speeds ? Temperature setting below 68°F (20°C) ? Trip duration at least 30 minutes ? Outside temperature above 68°F (20°C) NOTE: After parking the vehicle or switching off the air-conditioning system for at least 20 minutes, the symptom disappears (ice melts off evaporator and puddles under the car from the A/C drains.). Evaporator starts to freeze up due to the position of the evaporator temperature sensor.
Associated Products (32)Associated Documents - October 1, 2015•Document ID: 10147784Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL; EQUIPMENT
- Mfr Comm. #:
- B651715
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
Summary"Active Sound Design ASD inoperative after programming. After programming with ISTA/P V3.56.1 Active Sound Design (ASD) no longer provides simulated engine sounds A fault is stored in the ASD module. Fault Code 8053A5 ""ASD; invalid coding data for equalizing"" Invalid ASD coding data"
Associated Products (22)Associated Documents - October 1, 2015•Document ID: 10147771Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- B360115
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryCheck Control Message: Tire Pressure Monitor (RDCi) Failure. A Check Control Message states Tire Pressure Monitor (RDCi) has failed CAUSE Hardware in the remote control unit (FBD3 antenna)
Associated Products (43)Associated Documents - October 1, 2015•Document ID: 10147769Service Bulletin/Repair InstructionsPOWER TRAIN:AXLE ASSEMBLY
- Mfr Comm. #:
- B330215
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
Summary"Grinding or cracking noise when putting vehicle in gear/ ""Drive Disturbed"" displayed. A metallic grinding or cracking noise is heard from the rear of the vehicle when selecting Drive or Reverse. There may also be a Check Control message ""Drive Disturbed"" displayed. CAUSE The inner and/or outer universal joint on the right and/or left rear output shaft has failed."
Associated Products (34)Associated Documents - October 1, 2015•Document ID: 10147760Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B111415
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryThe plastic oil filter housing may fail and lead to an internal and/or external engine oil or coolant leak.
Associated Products (22)Associated Documents - September 1, 2015•Document ID: 10147272Service Bulletin/Repair InstructionsEQUIPMENT; EQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- B840515
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryConnectedDrive Messages Are Not Received In the Vehicle. One or both of the following may occur: SMS based messages are not received in the vehicle. These are: Text messages - Office feature MyInfo Google send to car - addresses and Points of Interests (POI) Concierge The activation code is not accepted by the ConnectedDrive Portal. Software error in the HU-H (Head unit High).
Associated Products (28)Associated Documents - September 1, 2015•Document ID: 10147271Service Bulletin/Repair InstructionsEQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM
- Mfr Comm. #:
- B840315
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"HU-B: Bluetooth Connection Fails Sporadically. The Bluetooth system works intermittently. One or more of the following scenarios may occur: Bluetooth pairing is not possible - display shows ""Please wait"" Unable to select the check box to activate Bluetooth Device does not reconnect to the vehicle after a key cycle Audio interference noise is heard listening to iPod etc. When trying to access the user manual, the display shows ""Please wait"" Incorrect software installed in the HU-B (Headunit Basic)."
Associated Products (33)Associated Documents - September 1, 2015•Document ID: 10147268Service Bulletin/Repair InstructionsLANE DEPARTURE: LANE KEEP: STEERING ASSIST
- Mfr Comm. #:
- B660515
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryParking Maneuvering Assistant and Park Distance Control Failure. After activating the PMA (Parking Maneuvering Assistant) or PDC (Park Distance Control), the system stops functioning and a CCM (Check Control Message) is displayed advising the driver of the failure. The following fault code is stored in the PMA control unit 0x481E4D - PMA control unit internal, internal ASIC fault Software error in the PMA control unit Affected I-Level: F2x from F020-15-03-500 F3x from F020-15-07-500
Associated Products (19)Associated Documents - September 1, 2015•Document ID: 10147264Service Bulletin/Repair InstructionsEQUIPMENT:APPLIANCE:AIR CONDITIONER
- Mfr Comm. #:
- B640715
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryIHKA - Outlet Temperature is Different on Both Sides. The IHKA settings on the left- and right-hand side are identical. The outlet temperature for both sides is different. Software application error in IHKA.
Associated Products (32)Associated Documents - September 1, 2015•Document ID: 10147263Service Bulletin/Repair InstructionsEQUIPMENT:APPLIANCE:AIR CONDITIONER
- Mfr Comm. #:
- B640615
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"IHKA - Blower Runs in Emergency Mode. After the ignition is turned off and the vehicle is locked, the heating and air conditioning blower motor runs continuously. The next time the vehicle is started there may be the CCM (Check control message) displayed for ""Increased battery discharge"". CAUSE The blower output stage receives an invalid LIN bus signal during operation and switches to emergency mode. The blower will continue to run with the specified emergency mode after the ignition is turned off and the vehicle is locked."
Associated Products (34)Associated Documents - September 1, 2015•Document ID: 10147262Service Bulletin/Repair InstructionsEQUIPMENT; EQUIPMENT:APPLIANCE:AIR CONDITIONER
- Mfr Comm. #:
- B640515
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryIHKA - Recirculation Function Changes from Manual to Automatic. While driving, the air recirculation button on IHKA changes by itself from manual to automatic or automatic to manual mode. CAUSE The IHKA operating software is too sensitive.
Associated Products (34)Associated Documents - September 1, 2015•Document ID: 10147259Service Bulletin/Repair InstructionsEXTERIOR LIGHTING:BACK UP LIGHTS
- Mfr Comm. #:
- B630515
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"Reverse Light is Intermittently Inoperative. CCM (Check control message) is displayed indicating a ""reverse light"" is out. CAUSE There is a weak spring in bulb socket or bulb carrier (on the luggage compartment lid) which is causing a bad contact with the bulb."
Associated Products (24)Associated Documents - September 1, 2015•Document ID: 10147251Service Bulletin/Repair InstructionsSTRUCTURE:BODY:DOOR
- Mfr Comm. #:
- B512615
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryDriver or Passenger's Front Doors Handles Inoperable. Sporadically it is not possible to open the driver or passenger's front door from the outside or inside door handle. Multiple attempts will eventually open the door. Comfort access operation of the outside door handle works properly. This situation occurs at temperatures below 37 °F. CAUSE Incorrect routing of the Bowden cable.
Associated Products (24)Associated Documents - September 1, 2015•Document ID: 10147243Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- B360115
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryCheck Control Message: Tire Pressure Monitor (RDCi) Failure. A Check Control Message states Tire Pressure Monitor (RDCi) has failed CAUSE Hardware in the remote control unit (FBD3 antenna)
Associated Products (49)Associated Documents - September 1, 2015•Document ID: 10147241Service Bulletin/Repair InstructionsWHEELS; POWER TRAIN:DRIVELINE
- Mfr Comm. #:
- B270415
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryShudder from the Driveline on Vehicles with xDrive. There is a shudder or vibration from the driveline when taking off from a stop, or when accelerating at highway speeds. CAUSE Possible multiple root causes related to the engine, wheels & tires, suspension components or internal wear on the clutch plates of the xDrive transfer case.
Associated Products (176)Associated Documents - September 1, 2015•Document ID: 10147238Service Bulletin/Repair InstructionsENGINE; EQUIPMENT
- Mfr Comm. #:
- B123115
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"""Low Oil Warning Indicator Light"" Comes on After Extended Driving. After approximately 2-4 hours of driving on the highway at 80 mph, and at an engine speed of around 2200-2500 rpm with an average load, the ""low oil"" warning indicator light illuminates yellow and the following check control (CC) message (ID 27) displays: ""Top up 1 L of engine oil"". Also, fault code: 297200 - oil level (Layer_MOELNIV): Engine oil level too low, may be stored in the DDE CAUSE DDE software error"
Associated Products (2)Associated Documents - September 1, 2015•Document ID: 10147235Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING:EXHAUST SYSTEM; ENGINE
- Mfr Comm. #:
- B111615
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary?N20 and N26 engine: Smoke from Exhaust when Starting a Cold Engine. When starting a cold engine, blue smoke can be seen emitting from the exhaust tailpipe for approximately 10-20 seconds. No turbo charger boost faults are stored and no drivability issues can be detected. Engine oil leakage into the induction system and/or the turbo charger assembly.
Associated Products (73)Associated Documents - August 1, 2015•Document ID: 10151415Service Bulletin/Repair InstructionsEQUIPMENT; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL
- Mfr Comm. #:
- B620515
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
Summary"Instrument Cluster: CBS ""Running-in Check"" is Displayed. After replacing and / or programming the instrument cluster with ISTA/P 3.55.0 or higher (integration Level F020-15-03-501 or higher), the CBS (Condition Based Service) displays ""running-in check"" or ""1200 mile service is due"". The parameters of the CBS scopes for oil service, brake fluid, etc, can also be implausible or invalid. CAUSE Error in the CBS mapping data in the FEM (Front Electronics Module) and corrupt data in the instrument cluster during programming."
Associated Products (34)Associated Documents - August 1, 2015•Document ID: 10151410Service Bulletin/Repair InstructionsSERVICE BRAKES
- Mfr Comm. #:
- B340415
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
SummaryAfter Cold Start, Brake Booster Reservoir Vacuum Reduced. With an outside temperature below 14ºF, brake booster vacuum may be reduced after a cold start. The non-return valve in the vacuum line to the brake booster may stick at temperatures below 14ºF. Sufficient vacuum supply is available again at the brake booster only after the vehicle is driven (approximately 1/4 mile).
Associated Products (6)Associated Documents - August 1, 2015•Document ID: 10151404Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- B270315
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
SummaryVibration or Shudder from Driveline when Accelerating from a Stop. Chassis stabilization warning is displayed. Vehicle may exhibit a shudder or vibration when taking off from a stop. One or more of the following fault codes may be stored: LMV ? 440101 - Transfer box (VTG): End of transmission service life reached ? 440105 - Transfer box (VTG ) Calibration Faulty ? 440115 - Transfer box (VTG): Calibration angle deviation outside tolerance? 44011B - Set torque outside of the torque characteristic curve EGS ? 420611 - DSC interface (wheel speed): non-permitted deviation of wheel speed (actual speed of wheel RL/FL/RR/FR, 0x254) from output speed and turbine speed DSC ? 48097D - Transfer box: Fault, clutch position known, only rear-wheel drive These symptoms or faults would be stored on a vehicle with low mileage (< 12,500 miles). CAUSE A front or rear differential with the incorrect gear ratio was installed in the car. The front and rear differentials need to be geared exactly the same for the xDrive to function properly.
Associated Products (142)Associated Documents